DOI QR코드

DOI QR Code

Effect of Repeated Wet/Dry Cycles of Salt Solution on Flexural Performance of Steel Fiber Reinforced Concrete

반복적 염수침지가 강섬유 혼입 콘크리트의 휨성능에 미치는 영향

  • Kim, Ji-Hyun (Multidisciplinary Infra-technoplogy Research Laboratory, Pukyong National University) ;
  • Choi, Yu-Jin (Architectural and Fire Protection Engineering, Pukyong National University) ;
  • Chung, Chul-Woo (Architectural and Fire Protection Engineering, Pukyong National University)
  • Received : 2022.10.20
  • Accepted : 2022.11.14
  • Published : 2022.12.20

Abstract

Concrete is a representative composite material that shows excellent performance in the construction field. However, it is a brittle and nonhomogeneous material and exhibits weak behavior against bending and tensile forces. To compensate for such weakens, fiber reinforcement has been utilized, and steel fiber has been recognized as one of the best material for such purpose. However, steel fiber can seriously affect the durability of concrete exposed to the marine environment due to the corrosion caused by chlorine ions. This study intended to evaluate the mechanical performance of steel fiber reinforce concrete during and after repeated wet/dry cycles in salt solution. According to the experimental results, there was no reduction in the relative dynamic modulus of concrete during the repeated wet/dry cycles in salt solution for 37 weeks. Flexural strength was not decreased after completion of repeated wet/dry cycles in salt solution. There was no sign of corrosion in steel fibers after visual observation of fractured surface. However, the flexural toughness was decreased, and this is because about half of the concrete specimen showed failure before reaching the maximum displacement of 3 mm. Although repeated wet/dry cycles in salt solution did not cause cracks in concrete through corrosion of steel fibers, specific attention is required because it can reduce flexural toughness of steel fiber reinforced concrete.

콘크리트는 건설분야의 대표적인 복합재료로써 아주 우수한 재료이나, 불균질성을 가진 취성적 재료로 휨이나 인장력에 대해 취약한 거동을 보인다. 이러한 단점을 보완하기 위해 다양한 종류의 섬유를 보강한 콘크리트를 활용하고 있다. 특히, 강섬유는 다른 고분자 섬유에 비해 시장성이 좋으며 우수한 역학적 성능을 가지고 있어 콘크리트 보강재로 널리 사용되고 있다. 그러나 해양 환경에 노출된 부위에 시공할 때 염소이온 침투에 따른 부식의 영향으로 콘크리트의 내구성을 저하시킨다는 문제점을 가진다. 따라서 본 연구에서는 반복적 연수침지가 강섬유 혼입 콘크리트에 미치는 다양한 영향들에 관해 평가해 보고자 하였다. 실험 결과에 따르면, 37주간의 반복적 염수 침지 기간 동안 콘크리트의 상대동탄성 계수의 감소는 관찰되지 않았고, 염수 침지 종료 후의 휨강도의 감소도 발생하지 않았다. 반복시험 종료 후 시편의 파단면 육안 관찰 시 강섬유 부식의 증거는 확인할 수 없었다. 그러나 휨인성은 감소하였는데, 이는 콘크리트 시편의 절반 정도가 휨 시험의 최대 측정변위인 3mm지점에 도달하지 못하고 파괴가 발생하였기 때문이다. 비록 반복적 염수침지가 강섬유의 부식을 통한 콘크리트 균열을 발생시키지 못하더라도, 휨인성에는 영향을 미칠 수 있으므로 해양환경에 강섬유 보강 콘크리트를 사용 시 이를 유의해야 할 것으로 판단된다.

Keywords

Acknowledgement

This work was supported by the Energy R&D Program of the Korea Institute of Energy Technology Evaluation and Planning(KETEP) granted financial resource from the Ministry of Trade, Industry & Energy, Republic of Korea(No. 20201510300110).

References

  1. Xia DT, Xiang K, Zhou BR. Flexural toughness of hybrid fiber reinforced high-performance concrete under three-point bending. Applied Mechanics and Materials. 2013 Aug;357-360:1110-4. https://doi.org/10.4028/www.scientific.net/AMM.357-360.1110
  2. Banthia N, Majdzadeh F, Wua J, Bindiganavile V. Fiber synergy in hybrid fiber reinforced concrete (HyFRC) in flexure and direct shear. Cement and Concrete Composites. 2014 Apr;48:91-7. https://doi.org/10.1016/j.cemconcomp.2013.10.018
  3. Zollo RF. Fiber-reinforced concrete: an overview after 30 years of development. Cement and Concrete Composites. 1997; 19(2):107-22. https://doi.org/10.1016/S0958-9465(96)00046-7
  4. Nataraja MC, Dhang N, Gupta AP. Stress-strain curves for steel-fiber reinforced concrete under compression. Cement and concrete composites. 1999 Dec;21(5-6):383-90. https://doi.org/10.1016/S0958-9465(99)00021-9
  5. Kim HW, Lee CJ, Shon CS, Moon H, Chung CW. Mechanical performance and chloride ion penetration of polyolefin fiber reinforced concrete designed for shotcreting at marine environment. Journal of Structural Integrity and Maintenance. 2020 Feb;5(1):8-17. https://doi.org/10.1080/24705314.2019.1692164
  6. Lee CJ, Salas Montoya A, Moon H, Kim HW, Chung CW. The influence of the hybridization of steel and polyolefin fiber on the mechanical properties of base concrete designed for marine shotcreting purposes. Applied Sciences. 2021 Oct;11(20):9456. https://doi.org/10.3390/app11209456
  7. ASTM C 876, Standards Test Method for Half Cell Potentials of Reinforcing Steel in Concrete. PA: American Society for Testing and Materials; 1991.
  8. ASTM G 59, Standards Test Method for Conducting Potentiodynamic Polarization Resistance Measurements. PA: American Society for Testing and Materials; 2020.
  9. Faritov AT, Rozhdestvenskii YG, Yamshchikova SA, Minnikhanova ER, Tyusenkov AS. Improvement of the linear polarization resistance method for testing steel corrosion inhibitors. Russian Metallurgy(Metally). 2017 Feb;2016(11):1035-41. https://doi.org /10.1134/S0036029516110070
  10. Ijsseling FP. Application of electrochemical methods of corrosion rate determination to systems involving corrosion product layers: part 1: linear polarization resistance measurement as an example of a simple method that can be performed with commercially available instruments. British Corrosion Journal. 1986;21(2):95-101. https://doi.org/10.1179/000705986798272316
  11. ASTM G109, Standard Test Method for Determining the Effects of Chemical Admixtures on the Corrosion of Embeded Steel Reinforcement in Concrete Exposed to Chloride Environments. PA: American Society for Testing and Materials; 1995.
  12. ASTM C215, Standard Test Method for Fundamental Transverse, Longitudinal, and Torsional Resonant Frequencies of Concrete Specimens. PA: American Society for Testing and Materials; 2000.
  13. KS F 2566, Standard test method for flexural performance of fiber reinforced concrete. Seoul (Korea): Korea Agency for Technology and Standards; 2000.
  14. Nordtest method NT-BUILD 492, Concrete, mortar and cement-based repair materials: chloride migration coefficient from non-steady-state migration experiments. Denmark: Nordic Council of Ministers; 1999.
  15. KS L 5201, Portland cement. Seoul (Korea): Korea Agency for Technology and Standards; 2021.
  16. KS F 2567, Silica fume for use in concrete. Seoul (Korea): Korea Agency for Technology and Standards; 2003.
  17. KS F 2563, Ground granulated blast - furnace slag for use in concrete. Seoul (Korea): Korea Agency for Technology and Standards; 2020.
  18. ASTM C 39, Standard test method for compressive strength of cylindrical concrete specimens. PA: American Society for Testing and Materials; 2010.
  19. ASTM C 1202, Standard Test Method for Electrical Indication of Concrete's Ability to Resist Chloride Ion Penetration. PA: American Society for Testing and Materials; 2000.