DOI QR코드

DOI QR Code

Investigation of 1D sand compression response using enhanced compressibility model

  • Chong, Song-Hun (Department of Civil Engineering, Sunchon National University)
  • Received : 2021.01.19
  • Accepted : 2021.05.13
  • Published : 2021.05.25

Abstract

1D sand compression response to ko-loading experiences volume contraction from low to high effective stress regimes. Previous study suggested compressibility model with physically correct asymptotic void ratios at low and high stress levels and examined only for both remolded clays and natural clays. This study extends the validity of Enhanced Terzaghi model for different sand types complied from 1D compression data. The model involved with four parameters can adequately fit 1D sand compression data for a wide stress range. The low stress obtained from fitting parameters helps to identify the initial fabric conditions. In addition, strong correlation between compressibility and the void ratio at low stress facilitates determination of self-consistent fitting parameters. The computed tangent constrained modulus can capture monotonic stiffening effect induced by an increase in effective stress. The magnitude of tangent stiffness during large strain test should not be associated with small strain stiffness values. The use of a single continuous function to capture 1D stress-strain sand response to ko-loading can improve numerical efficiency and systematically quantify the yield stress instead of ad hoc methods.

Keywords

Acknowledgement

This research was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT) (No. 2021R1C1C1006003).

References

  1. Atkinson, J.H., Richardson, D. and Woods, R.I. (1986), "Technical note on the determination of tangent stiffness parameters from soil test data", Comput. Geotech., 2(3), 131-140. https://doi.org/10.1016/0266-352X(86)90023-6.
  2. Becker, D.E., Crooks, J.H.A., Been, K. and Jefferies, M.G. (1987), "Work as a criterion for determining in situ and yield stresses in clays", Can. Geotech. J., 24(4), 549-564. https://doi.org/10.1139/t87-070.
  3. Boone, S.J. (2010), "A critical reappraisal of "preconsolidation pressure" interpretations using the oedometer test", Can. Geotech. J., 47(3), 281-296. https://doi.org/10.1139/T09-093.
  4. Bransby, M.F. and Randolph, M.F. (1998), "Combined loading of skirted foundations", Geotechnique, 48(5), 637-655. https://doi.org/10.1680/geot.1998.48.5.637.
  5. Casagrande, A. (1936), "The determination of the preconsolidation load and its practical significance", Proceedings of the 1st International Soil Mechanics and Foundation Engineering Conference, Cambridge, Massachusetts, U.S.A., June.
  6. Cho, G.C., Dodds, J. and Santamarina, J.C. (2006), "Particle shape effects on packing density, stiffness, and strength: Natural and crushed sands", J. Geotech. Geoenviron. Eng., 132(5), 591-602. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:11(1474).
  7. Chong, S.H. (2014), "The effect of subsurface mass loss on the response of shallow foundations", Ph.D Disseration, Georgia Institute of Technology, Atlanta, Georgia, U.S.A.
  8. Chong, S.H. and Santamarina, J.C. (2016), "Soil compressibility models for a wide stress range", J. Geotech. Geoenviron. Eng., 142(6), 06016003. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001482.
  9. Clementino, R.V. (2005), "Discussion: An oedometer test study on the preconsolidation stress of glaciomarine clays", Can. Geotech. J., 42(3), 972-974. https://doi.org/10.1139/t05-010.
  10. DeJong, J. and Christoph, G. (2009), "Influence of particle properties and initial specimen state on one-dimensional compression and hydraulic conductivity", J. Geotech. Geoenviron. Eng., 135(3), 449-454. https://doi.org/10.1061/(ASCE)1090-0241(2009)135:3(449).
  11. Hagerty, M., Hite, D., Ullrich, C. and Hagerty, D. (1993), "One-dimensional high-pressure compression of granular media", J. Geotech. Eng., 119(1), 1-18. https://doi.org/10.1061/(ASCE)0733-9410(1993)119:1(1).
  12. Houlsby, G.T., Kelly, R.B., Huxtable, J. and Byrne, B.W. (2005), "Field trials of suction caissons in clay for offshore wind turbine foundations", Geotechnique, 55(4), 287-296. https://doi.org/10.1680/geot.2005.55.4.287.
  13. Hyodo, M., Wu, Y., Kajiyama, S., Nakata, Y. and Yoshimoto, N. (2017), "Effect of fines on the compression behaviour of poorly graded silica sand", Geomech. Eng., 12(1), 127-138. https://doi.org/10.12989/gae.2017.12.1.127.
  14. Janbu, N. (1969), "The resistance concept applied to deformation of soils", Proceedings of the 7th International Conference on Soil Mechanics and Foundation Engineering, Mexico City, Mexico,
  15. Krost, K., Gourvenec, S.M. and White, D.J. (2011), "Consolidation around partially embedded seabed pipelines", Geotechnique, 61(2), 167-173. https://doi.org/10.1680/geot.8.T.015.
  16. Nakata, Y., Hyodo, M., Hyde, A., Kato, Y. and Murata, H. (2001), "Microscopic particle crushing of sand subjected to high pressure one-dimensional compression", Japanese Geotechnical Society, Tokyo, Japan.
  17. Pestana, J.M. and Whittle, A.J. (1995), "Compression model for cohesionless soils", Geotechnique, 45(4), 611-631. https://doi.org/10.1680/geot.1995.45.4.611.
  18. Randolph, M.F., Gaudin, C., Gourvenec, S.M., White, D.J., Boylan, N. and Cassidy, M.J. (2011), "Recent advances in offshore geotechnics for deep water oil and gas developments", Ocean Eng., 38(7), 818-834. https://doi.org/10.1016/j.oceaneng.2010.10.021.
  19. Sridharan, A., Abraham, B.M. and Jose, B.T. (1991), "Improved technique for estimation of preconsolidation pressure", Geotechnique, 41(2), 263-268. https://doi.org/10.1680/geot.1991.41.2.263.
  20. Tsuha, C.H.C., Foray, P.Y., Jardine, R.J., Yang, Z.X., Silva, M. and Rimoy, S. (2012), "Behaviour of displacement piles in sand under cyclic axial loading", Soils Found., 52(3), 393-410. https://doi.org/10.1016/j.sandf.2012.05.002.
  21. Wang, Z., Lu, Y., Hao, H. and Chong, K. (2005), "A full coupled numerical analysis approach for buried structures subjected to subsurface blast", Comput. Struct., 83(4-5), 339-356. https://doi.org/10.1016/j.compstruc.2004.08.014.
  22. Wang, Z.C. and Wong, R.C.K. (2010), "Effect of grain crushing on 1D compression and 1D creep behavior of sand at high stresses", Geomech. Eng., 2(4), 303-319. http://doi.org/10.12989/gae.2010.2.4.303.
  23. Yang, Z.X., Jardine, R.J., Zhu, B.T., Foray, P. and Tsuha, C.H.C. (2010), "Sand grain crushing and interface shearing during displacement pile installation in sand", Geotechnique, 60(6), 469-482. https://doi.org/10.1680/geot.2010.60.6.469.
  24. Yun, T. and Santamarina, J. (2005), "Decementation, softening, and collapse: Changes in small-strain shear stiffness in loading", J. Geotech. Geoenviron. Eng., 131(3), 350-358. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:3(350).