DOI QR코드

DOI QR Code

Axial compressive behavior of concrete-encased CFST stub columns with open composite stirrups

  • Ke, Xiaojun (College of Civil Engineering and Architecture, Guangxi University) ;
  • Ding, Wen (College of Civil Engineering and Architecture, Guangxi University) ;
  • Liao, Dingguo (College of Civil Engineering and Architecture, Guangxi University)
  • 투고 : 2021.01.25
  • 심사 : 2021.11.02
  • 발행 : 2021.11.25

초록

The existing method to improve the coordination performance of the inner and outer parts of concrete-encased concrete-filled steel tube (CFST) composite columns by increasing the volume-stirrup ratio causes difficulties in construction due to over-dense stirrups. Thus, this paper proposes an open polygonal composite stirrup with high strength and high ductility CRB600H reinforced rebar, and seventeen specimens were constructed, and their axial compressive performance was tested. The main parameters considered were the volume-stirrup ratio, the steel tube size, the stirrup type and the stirrup strength. The test results indicated: For the specimens restrained by open octagonal composite stirrups, compared with the specimen of 0.5% volume-stirrup ratio, the compressive bearing capacity increased by 14.6%, 15.7% and 21.5% for volume-stirrup ratio of 0.73%, 1.07% and 1.61%, respectively. For the specimens restrained by open composite rectangle stirrups, compared with the specimen of 0.79% volume-stirrup ratio, the compressive bearing capacity increased by 7.5%, 6.1%, and -1.4% for volume-stirrup ratio of 1.12%, 1.58% and 2.24%, respectively. The restraint ability and the bearing capacity of the octagonal composite stirrup are better than other stirrup types. The specimens equipped with open polygonal composite stirrup not only had a higher ductility than those with the traditional closed-loop stirrup, but they also had a higher axial bearing capacity than those with an HPB300 strength grades stirrup. Therefore, the open composite stirrup can be used in practical engineering. A new calculation method was proposed based on the stress-strain models for confined concrete under different restrain conditions, and the predicted value was close to the experimental value.

키워드

과제정보

This work is supported by the National Natural Science Foundation of China (Project No. 51668007 and 51508112), and the Natural Science Foundation of Guangxi (Project No. 2018GXNSFAA050007), Foundation of Training Plan for Thousands of Young Teachers in Guangxi Colleges and Universities (2019). The financial support is gratefully acknowledged.

참고문헌

  1. ACI318-11 (2011), Building Code Requirements for Structural Concrete and Commentary, American Concrete Institute, Detroit, USA.
  2. AISC360-10 (2010), Specification for Structural Steel Buildings, American Institute of Steel Construction (AISC), Chicago, USA.
  3. Cai, J., Pan, J. and Li, X. (2018), "Behavior of ECC-encased CFST columns under axial compression", Eng. Struct., 171, 1-9. https://doi.org/10.1016/j.engstruct.2018.05.090.
  4. Cai, J., Pan, J., Su, H. and Lu, C., (2018), "Experimental study on the hysteretic behavior of ECC-encased CFST columns", Eng. Struct., 173, 107-121. https://doi.org/10.1016/j.engstruct.2018.06.095.
  5. Cai, M., Ke, X. and Su, Y. (2020), "Axial compressive performance of RAC-encased RACFST composite columns", Eng. Struct., 210, 110393. https://doi.org/10.1016/j.engstruct.2020.110393
  6. Candappa, D.P., Setunge, S. and Sanjayan, J.G. (1999), "Stress versus strain relationship of high strength concrete under high lateral confinement", Cement Concrete Res., 29(12), 1977-1982. https://doi.org/10.1016/S0008-8846(99)00219-7.
  7. CECS458 (2016), Technical Specification for CRB600H High Ductility and High Strength Steel Bars, China Planning Press, Beijing, China.
  8. Chen, Q.J., Cai, J. and Bradford, M.A. (2014), "Seismic behaviour of a through-beam connection between concrete-filled steel tubular columns and reinforced concrete beams", Eng. Struct., 80, 24-39. https://doi.org/10.1016/j.engstruct.2014.08.036.
  9. Chen, Y., Feng, J. and Yin, S. (2012), "Compressive behavior of reinforced concrete columns confined by multi-spiral hoops", Comput. Concrete, 9, 341-355. https://doi.org/10.12989/cac.2012.9.5.341
  10. Cusson, D. and Paultre, P. (1998), "High-strength concrete columns confined by rectangular ties", J. Struct. Eng., 120, 783-804. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:3(783).
  11. Eurocode (2004), Design of Composite Steel and Concrete Structures Part1-1, General Rules-Structural Rules for Buildings, European Committee for Standardization, Brussels, Belgium.
  12. GB/T 228.1 (2010), Metallic Materials-tensile Testing-Part 1, Method of Test at Room Temperature (ISO 6892-1:2009, MOD).
  13. GB/T 50080 (2017), Standard for Test Method of Performance on Ordinary Fresh Concrete, China Architecture Building Press, Beijing, China.
  14. Han, L.H. and An, Y.F. (2014), "Performance of concrete-encased CFST box stub columns under axial compression", J. Constr. Steel Res., 93, 62-76. https://doi.org/10.1016/j.jcsr.2013.10.019.
  15. Han, L.H., Wang, Z.B., Xu, W. and Tao, Z. (2016), "Behavior of concrete-encased CFST members under axial tension", J. Struct. Eng., 142, 04015149. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001422.
  16. Hong, H.P., Huang, Y. Deng, L. and Bai, Y. (2019), "Axial capacity of steel tube-reinforced concrete stub columns", Eng. Struct., 183, 523-532. https://doi.org/10.1016/j.engstruct.2019.01.044.
  17. Hwang, S.K. and Yun, H.D. (2004), "Effects of transverse reinforcement on flexural behaviour of high-strength concrete columns", Eng. Struct., 26(1), 1-12. https://doi.org/10.1016/j.engstruct.2003.08.004.
  18. JGJ95 (2011), Technical Specification for Concrete Structures with Cold-rolled Ribbed Steel Wires and Bars, China Architecture Building Press, Beijing, China.
  19. Ji, X., Kang, H., Chen, X. and Qian, J. (2014), "Seismic behavior and strength capacity of steel tube-reinforced concrete composite columns", Earthq. Eng. Struct. Dyn., 43(4), 487-505. https://doi.org/10.1002/eqe.2354.
  20. Li, Y., Li, G., Hou, C. and Zhang, W.J. (2019), "Long-term experimental behavior of concrete-encased CFST with preload on the inner CFST", J. Constr. Steel. Res., 155, 355-369. https://doi.org/10.1016/j.jcsr.2019.01.001.
  21. Li, Y.J., Han, L.H., Xu, W. and Tao, Z. (2015), "Circular concrete-encased concrete-filled steel tube (CFST) stub columns subjected to axial compression", Mag. Concrete. Res., 68(19), 1-16. https://doi.org/10.1680/jmacr.15.00359.
  22. Liang, C.Y., Chen, C.C., Weng, C.C., Yin, Y.L. and Wang, J.C. (2014), "Axial compressive behavior of rectangle composite columns confined by multiple spirals", J. Constr. Steel Res., 103, 230-240. https://doi.org/10.1016/j.jcsr.2014.09.006
  23. Ma H., Li M. and Wang Q. (2019), "Experimental study on seismic performance of full-scale concrete-filled steel tube columns with openings in the steel tube wall", World Earthq. Eng., 35, 53-61. https://doi.org/CNKI:SUN:SJDC.0.2019-01-007.
  24. Mander, J.B. and Priestley, M.J.N. (1988), "Observed stress-strain behavior of confined concrete", J. Struct. Eng., 114(8), 1827-1849. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1827).
  25. Mander, J.A.B. and Priestley, M.J.N. (1988), "Theoretical stress-strain model for confined concrete", J. Struct. Eng., 114(8), 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804).
  26. Pooya, A., Yoshiharu, S. and Bing, L. (2018), "Drift capacity of high-strength concrete columns with mixed-grade longitudinal reinforcements", Adv. Struct. Eng., 22, 519-534. https://doi.org/10.1177/1369433218794270.
  27. Qian, J., Cheng, L. and Zhou, D. (2002), "Behavior of axially loaded concrete columns confined with ordinary coops", J. Tsinghua Univ., 42(10), 1369-1373. https://doi.org/10.16511/j.cnki.qhdxxb.2002.10.024.
  28. Shi, Q., Wang, N., Tian, Y., Wang, P. and Li, K. (2013), "Study on stress-strain relationship of high-strength concrete confined with high-strength stirrups under axial compression", J. Build. Struct., 34(4), 144-151. https://doi.org/10.14006/j.jzjgxb.2013.04.014.
  29. Sun, L.Z., Wu, D.Y., Zhao, J.L., Yang, F. and Li, W. (2017), "Behavior of circular RC columns with two layers of spirals", KSCE J. Civil Eng., 21, 955-963. https://doi.org/10.1007/s12205-016-0928-0.
  30. T/CECS188 (2019), Technical Specification for Steel Tube-reinforced Concrete Column Structure, China Architecture Building Press, Beijing, China.
  31. Wang. L.S. and Qian, J.R. (2004), "Experimental research on complete axial compressive stress-strain curve of high-strength concrete filled steel tubular columns", Build. Struct., 34(1), 11-19. https://doi.org/10.19701/j.jzjg.2004.01.003.
  32. Xu, L. and Liu, Y.B. (2013), "Concrete filled steel tube reinforced concrete (CFSTRC) columns subjected to iso-834 standard fire: experiment", Adv. Struct. Eng., 16(7), 1263-1282. https://doi.org/10.1260/1369-4332.16.7.1263.
  33. Xue, J., Zhang, X., Ke, X. and Ma, L. (2019), "Seismic resistance capacity of steel reinforced high-strength concrete columns with rectangular spiral stirrups", Constr. Build Mater., 229, 116880. https://doi.org/10.1016/j.conbuildmat.2019.116880.
  34. Yang, F., Sun, L., Zhao, J., Wu, D. and Li, W. (2015), "Behavior of a novel circular HSC column with double high strength spirals", Adv. Struct. Eng., 18, 1371-1382. https://doi.org/10.1260/1369-4332.18.9.1371.
  35. Zhang, J., Cai, R., Li, C. and Liu, X. (2020), "Seismic behavior of high-strength concrete columns reinforced with high-strength steel bars", Eng. Struct., 218, 110861. https://doi.org/10.1016/j.engstruct.2020.110861.
  36. Zhou, X.H., Zheng, Z. and Dan, G. (2020), "Analysis and design of axially loaded square CFST columns with diagonal ribs", J. Constr. Steel Res., 167, 105848. https://doi.org/10.1016/j.jcsr.2019.105848.