Abstract
In the manufacturing process of flat panel displays, a high-precision planar motion stage is used to position a specimen. Stages of this type typically use frictionless linear motors and air bearings, and laser interferometers. Real-time dynamic correction of the yaw motion error is very important because the inevitable yaw motion error of the stage means a change in the specimen orientation. Gantry control is generally used to compensate for yaw motion errors. Flexure units that allow rotational motion are applied to the stage to apply this method to a stage using an air-bearing guide. This paper proposes a method to improve the constant speed motion performance of a H-type XY stage equipped with air bearing and flexure units. When applying the gantry control to the stage, including the flexure units, the cause of the mutual ripple generated from the linear motors is analyzed, and adaptive learning control is proposed to compensate for the mutual ripple. A simulation was performed to verify the proposed method. The speed ripple was reduced to approximately the 22 % level. The ripple reduction was verified by simulating the stage state where yaw motion error occurs.
평판 디스플레이 제조 공정에서 대상물의 위치 결정을 위해 고정밀 평면 모션 스테이지를 사용한다. 이 유형의 스테이지는 일반적으로 마찰이 없는 선형 모터와 에어 베어링을 사용하며, 고정밀 위치 센서로 레이저 간섭계를 사용한다. 스테이지의 불가피한 기생 운동에 의해 야기되는 요 모션 오차는 위치 결정 대상체의 향 변화를 의미하므로, 스테이지의 성능과 공정 정밀도 향상을 위해 요 모션 오차의 실시간 동적 보정은 매우 중요하다. 요 모션 오차 보상에는 갠트리 제어가 일반적이며, 이 방법을 공기베어링 가이드를 사용하는 스테이지에 적용하기 위해서 회전 모션을 허용하는 유연기구가 스테이지에 적용된다. 본 논문은 공기베어링과 유연기구를 갖춘 H형 XY 스테이지의 정속 구동 성능을 개선하는 방법을 제안한다. 유연기구를 포함한 스테이지의 갠트리 제어 시 선형 모터로부터 발생하는 상호 리플의 발생 원인을 분석하고, 이러한 상호 리플을 보상하는 방안으로 적응 학습 제어를 제시한다. 제시 방안의 검증을 위해 시뮬레이션을 수행하여, 보상 제어를 통해 속도 리플이 약 22 % 수준으로 감소함을 확인하였다. 그리고 요 모션 오차가 발생하는 스테이지 상태를 가정하여 리플 저감 효과를 검증하였다.