전기전자학회논문지 (Journal of IKEEE)

  • 제24권3호
  • /
  • Pages.853-858
  • /
  • 2020
  • /
  • 1226-7244(pISSN)
  • /
  • 2288-243X(eISSN)
한국전기전자학회 (Institute of Korean Electrical and Electronics Engineers)
권호 표지
DOI QR코드

DOI QR Code

RF 노이즈 내성을 가진 OLED 디스플레이용 2-채널 DC-DC 변환기

2-Channel DC-DC Converter for OLED Display with RF Noise Immunity

  • Kim, Tae-Un (School of Electrical and Computer Engineering, Chungbuk National University) ;
  • Kim, Hak-Yun (Zinitix Co.) ;
  • Choi, Ho-Yong (School of Electrical and Computer Engineering, Chungbuk National University)
  • 투고 : 2020.08.31
  • 심사 : 2020.09.28
  • 발행 : 2020.09.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

본 논문은 통신기기에서 유입 되는 RF 노이즈에 대해 내성을 가진 OLED용 2-채널 DC-DC 변환기를 제안한다. RF 신호 내성을 위해, 입력전압 변동만큼 감쇠시키는 입력전압 변동감쇠 회로가 내장된다. 양의 전압 VPOS를 출력하는 부스트 변환기는 SPWM-PWM 듀얼모드로 동작하고, 데드 타임을 제어함으로써 전력 효율을 제고한다. VNEG를 출력하는 인버팅 차지펌프는 2-상 출력 구조로 VCO를 이용한 PFM으로 동작해 작은 리플을 갖도록 설계된다. 0.18 ㎛ BCDMOS 공정으로 시뮬레이션 한 결과, 부스트 변환기 출력전압의 오버슈트와 언더슈트는 10 mV에서 각각 2 mV, 5 mV로 감소하였다. 또한, 2-채널 DC-DC 변환기의 전력효율은 39%~93%을 가졌고, 데드 타임 제어기를 적용한 부스트 변환기의 효율은 종전보다 최대 3% 증가하였다.

This paper proposes a 2-ch DC-DC converter for OLED display with immunity against RF noise inserted from communication device. For RF signal immunity, an input voltage variation reduction circuit that attenuates as much as the input voltage variation is embedded. The boost converter for positive voltage VPOS operates in SPWM-PWM dual mode and has a dead time controller to increase power efficiency. The inverting charge pump for negative voltage VNEG is a 2-phase scheme and operates in PFM using VCO to reduce output ripple voltage. Simulation results using 0.18 ㎛ BCDMOS process show that the overshoot and undershoot of the output voltage decrease from 10 mV to 2 mV and 5 mV, respectively. The 2-ch DC-DC converter has power efficiency of 39%~93%, and the power efficiency of the boost converter is up to 3% higher than the conventional method without dead time controller.

키워드

참고문헌

  1. G. Dickson, "What's in store for portable displays?," Inf. Disp., vol.36, no.1, pp.29-33, 2020. https://doi.org/10.1002/msid.1090
  2. G. M. Phelan, "OLED lighting hits the market," Inf. Disp., vol.34, no.1, pp.10-15, 2018. https://doi.org/10.1002/j.2637-496X.2018.tb01054.x
  3. Y.-Y. Lee, S. Park, J. Park, W. Choe, and J. Kwag, "Late-News Poster: Single Package DC/DC Converter for Tablet OLED," SID Symp. Dig. Tech. Pap., vol.48, no.1, pp.1449-1451, 2017. DOI: 10.1002/sdtp.11921
  4. S. Jeon, H. Lee, and H. Choi, "Design of Highly Integrated 3-Channel DC-DC Converter Using PTWS for Wearable AMOLED," J. IKEEE, vol.23, no.3, pp.1061-1067, 2019. DOI: 10.7471/ikeee.2019.23.3.1061
  5. C. S. Chae, H. P. Le, K. C. Lee, G. H. Cho, and G. H. Cho, "A single-inductor step-up DC-DC switching converter with bipolar outputs for active matrix OLED mobile display panels," IEEE J. Solid-State Circuits, vol.44, no.2, pp.509-524, 2009. DOI: 10.1109/JSSC.2008.2010986
  6. ITU-T, "Immunity requirements for telecommunication equipment in close proximity use of wireless devices," ITU-T K.127, 2017.
  7. Y. B. Lee, "GSM mobile terminal and noise suppression method for the same," US8121551B2, 2012.
  8. Christophe Basso, Switch-Mode Power Supplies Spice Simulations and Practical Designs. USA, NY, New York: McGraw-Hill, 2008.
  9. H. Y. Kim, M. H. Lee, Y. H. Shin, J. W. Kim, N. S. Kim, and H. Y. Choi, "Dual-mode inverting buck-boost converter using set-time variable PWM method," J. Semicond. Technol. Sci., vol.18, no.4, pp.423-432, 2018. DOI: 10.5573/JSTS.2018.18.4.423
  10. F. Pan, T. Samaddar, Charge pump circuit design. USA, NY, New York: McGraw-Hill, 2006.