DOI QR코드

DOI QR Code

Valorization of marble's waste as a substitute in sand concrete

  • Ouassila, Boughamsa (Department of Civil Engineering, LMGHU Laboratory, University of Skikda) ;
  • Houria, Hebhoube (Department of Civil Engineering, LMGHU Laboratory, University of Skikda) ;
  • Leila, Kherref (Department of Civil Engineering, LMGHU Laboratory, University of Skikda) ;
  • Mouloud, Belachia (Department of Civil Engineering, LMGHU Laboratory, University of Skikda) ;
  • Assia, Abdelouahed (Department of Civil Engineering, LMGHU Laboratory, University of Skikda) ;
  • Chaher, Rihia (Department of Civil Engineering, LMGHU Laboratory, University of Skikda)
  • 투고 : 2019.02.18
  • 심사 : 2020.01.04
  • 발행 : 2020.02.25

초록

The recovery of waste proves a solution with two impacts: the environmental impact by the reduction of pollution and the gain of the occupied space by this waste, and the economic impact by the use of these lasts in the building and in the area of public works. The present research consists in recovering a waste marble (thrown powder exposed to the different meteorological phenomena) generated by the quarry marble of Fil-fila, located at the east side of Skikda in the north-east of Algeria, and add it, as sand in the composition of sand concrete. To carry out this research, we analyzed the evolution brought by the substitution of ordinary sand by marble waste sand, with 25%, 50%, 75% and 100% on the properties in the fresh state (density, workability and air content) and in the cured state (compressive strength, tensile strength, surface hardness and sound velocity). For durability we tested water absorption by immersion and chloride penetration. The results obtained are compared with control samples of 0% of substitution rate. In order to have a good filling of the voids in the granular skeleton; we added a quantity of limestone recycled fines from the quarries and for a good workability a super-plasticizing additive. The results showed that the partial substitution modified both the fresh and the hardened characteristics of the tested concretes, the durability parameters also improved.

키워드

참고문헌

  1. Aliabdo, A.A., Elmoaty, A.E.M.A. and Auda, E.M. (2014), "Re-use of waste narble dust in the production of cement and concrete", Constr. Build. Mater., 50, 28-41. https://doi.org/10.1016/j.conbuildmat.2013.09.005.
  2. Belaidi, A.S.E., Azzouz, L., Kadri, E. and Kenai, S. (2012), "Effect of natural pozzolana and marble powder on the properties of self-compacting concrete", Constr. Build. Mater., 31, 251-257. https://doi.org/10.1016/j.conbuildmat.2011.12.109.
  3. Beton de Sable (1995), NF P 18-500.
  4. Binici, H., Kaplan, H. and Yilmaz, S. (2007), "Influence of marble and limestone dusts as additives on some mechanical properties of concrete", Sci. Res Essay, 2(9), 372-379.
  5. Ceylan, H. and Manca, S. (2013), "Evaluation of concrete aggregate marble pieces", J. Tech. Sci., 3, 21-25
  6. Corinaldesi, V., Giacomo, M. and Naik, T. (2010), "Characterization of marble powder for its use in mortar and concrete", Constr. Build. Mater., 24, 113-117. https://doi.org/10.1016/j.conbuildmat.2009.08.013.
  7. Demirel, B. (2010), "The effect of the using waste marble dust, as fine sand on the mechanical properties of the concrete", Int. J. Phys. Sci., 5, 1372-1380.
  8. Djebien, R., Belachia, M. and Hebhoub, H. (2015), "Effect of marble waste fines on rheological and hardened properties of sand concrete", Struct. Eng. Mech., 53(6), 1241-1251. https://doi.org/10.12989/sem.2015.53.6.1241.
  9. Djebien, R., Hebhoub, H., Belachia, M., Berdoudi, S. and Kherraf, L. (2018), "Incorporation of marble waste as sand in formulation of self-compacting concrete", Struct. Eng. Mech., 67(1), 87-91. https://doi.org/10.12989/sem.2018.67.1.087.
  10. Dreux, G. and Feasta, J. (1996), Nouveau Guide du Beton et de Ses Constituants, Edition Eyrolles, Paris, France.
  11. Gulden, C.U. and Recep, A. (2015), "Properties of hardened concrete produced by waste marble powder", Proc. Soc. Behav. Sci., 19, 52181-2190. https://doi.org/10.1016/j.sbspro.2015.06.294.
  12. Gulden, C.U., Turhan, B. and Recep, A. (2016), "Durability properties of concrete produced by marble waste as aggregate or mineral additives", Proc. Eng., 161, 543-548. https://doi.org/10.1016/j.proeng.2016.08.689.
  13. Hebhoub, H. and Belachia, M. (2011), "Use of the marble wastes in the hydraulic concrete", 6th International Advanced Technologies Symposium (IATS'11), 16-18.
  14. Hebhoub, H., Aoun, H., Belachia, M., Houari, H. and Ghorbel, E. (2011), "Use of waste marble aggregates in concrete", Constr. Build. Mater., 25, 1167-1171. https://doi.org/10.1016/j.conbuildmat.2010.09.037.
  15. Hebhoub, H., Belachia, M. and Djebien, R. (2014), "Introduction of sand marble wastes in the composition of mortar", Struct. Eng. Mech., 49(4), 491-498. https://doi.org/10.12989/sem.2014.49.4.491.
  16. Manpreet, S., Anshuman, S. and Dipendu, B. (2017), "An investigation on effect of partial replacement of cement by waste marble slurry", Constr. Build. Mater., 134, 471-488. https://doi.org/10.1016/j.conbuildmat.2016.12.155.
  17. Omar, O.M., Abd Elhameed, G.D., Sherif, M.A. and Mohamadien, H.A. (2012), "Influence of limestone waste as partial replacement material for sand and marble powder in concrete properties", HBRC J., 8(3), 193-203. https://doi.org/10.1016/j.hbrcj.2012.10.005.
  18. Rana, A., Kalla, P. and Csetenyi, L.J. (2015), "Sustainable use of marble slurry in concrete", J. Clean. Prod., 94, 304-311. https://doi.org/10.1016/j.jclepro.2015.01.053.
  19. Rodrigues, R., De Brito, J. and Sardinha, M. (2015), "Mechanical properties of structural concrete containing very fine aggregates from marble cutting sludge", Constr. Build. Mater., 77, 349-356. https://doi.org/10.1016/j.conbuildmat.2014.12.104.
  20. SABLOCRETE (1994), Sand Concrete: Characteristics and Practices of Use, Press of the National School of the Bridges and Roads, France.