The Journal of the Acoustical Society of Korea (한국음향학회지)

The Acoustical Society of Korea (한국음향학회)
권호 표지
DOI QR코드

DOI QR Code

Effects of sound absorbent gypsum board in the ceiling on low-frequency heavyweight floor impact sound

흡음 석고보드 천장재에 의한 저주파 중량 바닥충격음의 저감 효과

  • Received : 2018.07.19
  • Accepted : 2018.09.20
  • Published : 2018.09.30
Download PDF
⟨ Previous Next ⟩

Abstract

This study investigated effects of absorbent gypsum board in the ceiling on low-frequency heavyweight floor impact sound through sound absorption coefficient and floor impact sound measurement. The sound absorption coefficients were measured with sound absorbent gypsum board, glass wool on gypsum board, and a double panel absorbent gypsum board (absorbent gypsum board + glass wool + absorbent gypsum board). Result showed that the absorbent gypsum board had sound absorption coefficient of 0.1 ~ 0.7 from 200 and 630 Hz octave band. The sound absorption coefficient was increased in all frequency range by adding glass wool. Additional absorbent gypsum board increased sound absorption coefficient up to 250 Hz octave band, but decreased over 250 Hz. Heavyweight floor impact sounds were measured in test building for three materials above, gypsum board, and bare slab. Result showed that glass wool on gypsum board and a double panel absorbent gypsum board reduced by 3 dB ~ 4 dB (single number quantity) heavyweight floor impact sound. Comparing with bare slab condition, floor impact sound reduction was mainly found from 125 Hz to 500 Hz octave band, and the maximum reduction was shown in the 250 Hz octave band.

본 연구에서는 흡음 석고보드 천장재에 의한 바닥충격음 저감 효과를 조사하기 위해 잔향실에서의 흡음률 측정과 바닥충격음 성능평가 시험동에서의 바닥충격음 성능평가를 실시하였다. 먼저, 흡음률 측정은 흡음 석고보드, 흡음석고보드+글라스울, 흡음 석고보드 이중 천장재(흡음 석고보드+글라스울+흡음 석고보드)를 대상으로 실시하였다. 측정결과, 흡음 석고보드의 경우 200 Hz과 630 Hz 대역에서 약 0.1~0.5의 흡음률을 나타냈으며, 글라스울을 추가하였을 때 전체 측정 주파수대역(50 Hz ~ 630 Hz)에서 흡음률이 상승하였다. 흡음 석고보드를 추가 설치하였을 때 250 Hz 대역까지 흡음률이 크게 상승하였으나, 315 Hz 이상 대역에서는 흡음률이 감소하였다. 상기 3개의 흡음석고보드 및 일반 석고보드 천장재와 맨슬래브(천장 무) 대상으로 바닥충격음 차단 실험동에서 바닥충격음 차단성능 측정을 실시하였다. 측정결과, 흡음석고보드+글래스울과 흡음석고 보드 이중 천장재의 일반 석고보드 대비 중량충격음의 저감량은 단일평가지수 기준으로 3 dB ~ 4 dB인 것으로 나타났다. 맨슬래브 대비 중량충격음의 저감은 주로 125 Hz ~ 500 Hz 대역에서 발생하였으며 250 Hz 대역에서 최대의 저감량을 나타냈다.

Keywords

References

  1. K. W. Kim, J. S. Kang, S. E. Lee, and K. S. Yang, "Floor impact sound isolation performance by composition of ceiling and wall," Trans. KSNVE. 15, 465-473 (2005). https://doi.org/10.5050/KSNVN.2005.15.4.465
  2. S. H. Lee, G. C. Jeong, and J. Y. Chung, "Vibration isolation effect of floor impact sound by ceiling structure," Trans. KSNVE. 257-260 (2004).
  3. H. G. Park and D. H. Mun, "Characteristics of floor impact noise insulation for no hanger ceiling structure in apartment building," Trans. KSNVE. 208-213 (2014).
  4. K. H. Kim, J. K. Ryu, and J. Y. Jeon, "Development of perforated ceiling structures to reduce floor impact sound," J. Korean Institute of Architectural Sustainable Environment and Building Systems, 9, 34-39 (2015).
  5. N. G. Gi, M. J. Song, G. S. Jang, and S. W. Kim, "A study on the reduction characteristics of floor impact sound due to the ceiling frame structures in apartments," Architectural Institute of Korea, 21, 505-508 (2001).
  6. C. G. Cho, Y. K. Baik, and I. S. Shin, "An experimental study of improvement of ceiling structure for reducing floor impact sound in existing apartment buildings," The Korean Society of Living Environmental System 9, 38-44 (2002).
  7. J. K. Ryu, H. S. Song, and Y. H. Kim, "Effect of the suspended ceiling with low-frequency resonant panel absorber on heavyweight floor impact sound in the building," Building and Environment 139, 1-7 (2018). https://doi.org/10.1016/j.buildenv.2018.05.004
  8. J. H. Jeong, B. K. Lee, J. O. Yeon, and J. Y. Jeon, "Floor impact sound pressure level characteristics by the change of reverberation time in mock-up test rooms," Trans. KSNVE. 24, 339-347 (2014). https://doi.org/10.5050/KSNVE.2014.24.4.339
  9. KS F 2805, Measurement of Sound Absorption in a Reverberation Room, 2014.
  10. KS F 2810-2, Field Measurements of Floor Impact Sound Insulation of Buildings - Part 2: Method Using Standard Heavy Impact Sources, 2012.