초록
본 연구에서는 정격출력 500 MW로 연속운전 하는 표준석탄화력 발전설비의 출력을 300 ~ 500 MW로 변동운전하게 될 때 황산화물의 생성량과 탈황설비 흡수탑에서의 황산화물 배출농도 변화를 비교하고, 출력에 반비례하는 과다한 액기비 개선을 제안하였다. 저출력에서 연소효율 보정을 위해 과잉공기비를 높임에 따라 발생하는 연소가스량에 비해 상대적으로 황산화물의 비율이 낮아지기 때문에 고유황 연료일수록 고출력에서 유황성분의 생성농도가 상승하였다. 출력변동과 함께 탈황흡수탑 입구 황산화물 생성농도를 300 ~ 500 ppm으로 변화시켰을 때, 석회석 슬러리와 연소가스의 액기비는 10.99 ~ 16.27로 변화되었다. 따라서 저부하시 액기비 상승에 따른 잉여에너지저감을 위한 슬러리의 필요최소 유량은 300 MW 출력에서 황산화물 배출농도를 x라고 했을 때 다음 상관관계식을 추천한다. $y1[m^3/sec]=0.11x+3.74$
In this research, when the output of the standard coal-fired thermal power plant operating continuously at the rated output of 500 MW is changed to operate at 300 to 500 MW, the amount of sulfur oxide produced and the amount of sulfur oxide in the absorption tower of desulfurization equipment and proposed an extra liquid to gas ratio improvement inversely proportional to the output. In order to calibrate the combustion efficiency at low power, the ratio of sulfur oxides relative to the amount of combustion gas is increased as the excess air ratio is increased. When the concentration of sulfur oxide at the inlet of the desulfurization absorber was changed from 300 to 500 ppm along with the output fluctuation. The liquid to gas ratio of limestone slurry and combustion gas was changed from 10.99 to 16.27. Therefore, if the concentration of sulfur oxides with output of 300 MW is x, The following correlation equation is recommended for the minimum required flow rate of slurry for the reduction of surplus energy due to the increase of the liquid weight at low load. $y1[m^3/sec]=0.11x+3.74$