DOI QR코드

DOI QR Code

A New Start-up Method for a Load Commutated Inverter for Large Synchronous Generator of Gas-Turbine

  • An, Hyunsung (Dept. of Electrical and Electronic Engineering, Chungnam National University) ;
  • Cha, Hanju (Dept. of Electrical and Electronic Engineering, Chungnam National University)
  • 투고 : 2017.02.08
  • 심사 : 2017.08.24
  • 발행 : 2018.01.01

초록

This paper proposes a new start-up method for a load commutated inverter (LCI) in a large synchronous gas-turbine generator. The initial rotor position for start-up torque is detected by the proposed initial angle detector, which consists of an integrator and a phase-locked loop. The initial rotor position is accurately detected within 150ms, and the angle difference between the real position and the detected position is less than 1%. The LCI system operates in two modes (forced commutation mode and natural commutation mode) according to operating speed range. The proposed controllers include a forced commutation controller for the low-speed range, a PI speed controller and a PI current controller, where the forced commutation controller is connected to the current controller in parallel. The current controller is modeled by Matlab/Simulink, where a six-pulse delay of the thyristor and a processing delay are considered by using a zero-order hold. The performance of the proposed start-up method is evaluated in Matlab/Psim at standstill and at low speed. To verify the feasibility of the method, a 5kVA LCI system prototype is implemented, and the proposed initial angle detector and the system performance are confirmed by experimental results from standstill to 900rpm.

키워드

E1EEFQ_2018_v13n1_201_f0001.png 이미지

Fig. 1. Configuration of a gas-turbine power station

E1EEFQ_2018_v13n1_201_f0002.png 이미지

Fig. 2. Conventional method for a start-up system

E1EEFQ_2018_v13n1_201_f0003.png 이미지

Fig. 3. Operating characteristic curve of a gas-turbinesystem

E1EEFQ_2018_v13n1_201_f0004.png 이미지

Fig. 4. Configuration of an LCI system

E1EEFQ_2018_v13n1_201_f0005.png 이미지

Fig. 5. Principle of forced commutation mode

E1EEFQ_2018_v13n1_201_f0006.png 이미지

Fig. 6. Principle of natural commutation mode

E1EEFQ_2018_v13n1_201_f0007.png 이미지

Fig. 7. Control structure of an LCI system

E1EEFQ_2018_v13n1_201_f0008.png 이미지

Fig. 8. Simplified representation of a silent-pole synchro-nous machine

E1EEFQ_2018_v13n1_201_f0009.png 이미지

Fig. 9. Block diagram of initial angle detection

E1EEFQ_2018_v13n1_201_f0010.png 이미지

Fig. 10. Block diagram of PLL

E1EEFQ_2018_v13n1_201_f0011.png 이미지

Fig. 11. Block diagram of the current controller

E1EEFQ_2018_v13n1_201_f0012.png 이미지

Fig. 12. Principle of forced commutation

E1EEFQ_2018_v13n1_201_f0013.png 이미지

Fig. 13. Modeling of the load commutated inverter

E1EEFQ_2018_v13n1_201_f0014.png 이미지

Fig. 14. Initial rotor position detection: (a) Initial angle :50¡Æ(b) Initial angle : 220¡Æ

E1EEFQ_2018_v13n1_201_f0015.png 이미지

Fig. 15. Start-up within forced commutation mode

E1EEFQ_2018_v13n1_201_f0016.png 이미지

Fig. 16. Overall start-up of the LCI system

E1EEFQ_2018_v13n1_201_f0017.png 이미지

Fig. 17. Prototype of the 5kVA LCI system and MG-set

E1EEFQ_2018_v13n1_201_f0018.png 이미지

Fig. 18. Initial angle detection (qinit = 115¡Æ): (a) Measuredtheta (2rad/div), (b) Detected theta (2rad/div)

E1EEFQ_2018_v13n1_201_f0019.png 이미지

Fig. 19. Initial angle detection (qinit = 230¡Æ): (a) Measuredtheta (2rad/div), (b) Detected theta (2rad/div)

E1EEFQ_2018_v13n1_201_f0020.png 이미지

Fig. 20. Selection of thyristor pair: (a) Theta (q, 2rad/div),(b) B phase input current, (c) C phase input current

E1EEFQ_2018_v13n1_201_f0021.png 이미지

Fig. 21. Response of current control: (a) Step response ofDC current, (b) DC link current from forcedcommutation

E1EEFQ_2018_v13n1_201_f0022.png 이미지

Fig. 22. Initial start-up in forced commutation mode: (a)DC link voltage (Vdc, 250V/div), (b) DC linkcurrent (Idc, 2A/div), (c) machine voltage (Eac,25V/div), (d) Theta (q, 2rad/div)

E1EEFQ_2018_v13n1_201_f0023.png 이미지

Fig. 23. Three-phase current in forced commutation mode:(a) Machine voltage (Eac, 25V/div), (b) A-phasemachine input current (Ia, 2A/div), (c) B-phasemachine input current (Ib, 2A/div), (d) C-phasemachine input current (Ic, 2A/div)

E1EEFQ_2018_v13n1_201_f0024.png 이미지

Fig. 24. Overall start-up of the LCI system: (a) DC linkvoltage (Vdc, 250V/div), (b) A-phase machineinput current (Ia, 5A/div), (c) machine voltage (Eac,250V/div), (d) rotor speed (wr, 200rpm/div)

Table 1. Relationship between rotor position and polarity of back-emf

E1EEFQ_2018_v13n1_201_t0001.png 이미지

Table 2. Relationship between rotor position and thyristor pair

E1EEFQ_2018_v13n1_201_t0002.png 이미지

Table 3. Parameters of the synchronous machine

E1EEFQ_2018_v13n1_201_t0003.png 이미지

참고문헌

  1. Seon-Hwan Hwang, Jang-Mok Kim, Ho-Seon Ryu and Gi-Gab Yoon, "Control Algorithm of Large Synchronous Machines for Starting Gas Turbosets," Journal of Power Electronics, vol. 9, no. 2, pp.146-155, Mar. 2009.
  2. Ryota Okuyama, Yasuaki Matsumoto, Hiroshi Ogino, Shigeyuki Nakabayashi, Akinobu Ando and Yasuhiko Hosokawa, "Compact Static Starting Device for Gas Turbine," in Proceedings of IEEE ECCE Asia 2013, June 2013
  3. S.D. Sudhoff, E.L. Zivi and T.D. Collins, "Start-up Performance of Load-Commutated Inverter Fed Synchronous Machine Drives," IEEE Trans. Energy Conversion, vol. 10, no. 2, pp. 268-274, Jun. 1995. https://doi.org/10.1109/60.391892
  4. Hisanori Taguchi, Shinzo Tamai, Yasuhiko Hosokawa and Akinobu Ando, "APS Control Method for Gas Turbine Start-up by SFC," in Proceedings of IEEE IPEC 2010 International Conference, Jun. 2010.
  5. Jin Guangzhe, Zhou Changcheng, Gao Qiang and Xu Dianguo, "Research on System of Self-controlled Soft Start with Variable Frequency for Synchronous Motor," in Proceedings of IEEE IPEMC 2012 7th international conference, Jun. 2012.
  6. Wang Keshun, Zhang Lichun, Yang Bo, Li Guanjun, Tao Yibin, Fu Jianzhong, Li Jianfeng and Ji Liantao, "Developing and Simulation Research of the Control Model and Control Strategy of Static Frequency Converter," in Prprounoceedings of IEEE ISDEA 2012 Second International Conference, Jan. 2012.
  7. Jung-Chen Chiang, Chi-Jui Wu and Shih-shong Yen, "Mitigation of Harmonic Disturbance at Pumped Storage Power Station with Static Frequency Convertet," IEEE Trans. Energy Conversion, vol. 12, no. 3, pp. 232-240, Sept. 1997. https://doi.org/10.1109/60.629708
  8. Chihiro Hasegawa and Shoji Nishikata, "A Simple Starting Method for Self-Controlled Synchronous Motors in Electric Propulsion Systems for Ships," in Proceedings of IEEE Power Electronics and Applications, 2007 European Conference, Sept. 2007.
  9. Arun Kumar Datta, M.A. Ansari, N. R. Mondal, B. V. Raghavaiah, Manisha Dubey and Shailendra Jain, "Simulation of Static Frequency Converter for Synchronous Machine Operation and Investigation of Shaft Voltage," International Journal of Electrical, Computer, Energetic, Electronic and Communication Engineering, vol. 8, no. 3, 2014.
  10. Greg Magsaysay, Thomas Schuette and Russ J. Fostiak, "Use of a Static Frequency Converter for Rapid Load Response in Pumped-Storage Plants," IEEE Trans. Energy Conversion, vol. 10, no. 4, pp. 1771-1782, Dec. 1995.
  11. kamalesh Hatua and V.T. Ranganathan, "A Novel VSI- and CSI-Fed Active-Reactive Induction Motor Drive with Sinusoidal Voltage and Currents," IEEE Trans. Power Electronics, vol. 26, no. 12, pp. 3936- 3947, Dec. 2011. https://doi.org/10.1109/TPEL.2011.2143728
  12. Eduardo P. Wiechmann and Rolando Burgos, "On the Efficiency of Voltage Source and Current Source Inverters for High-Power Drives," IEEE Trans. Industrial Electronics, vol. 55, no. 4, pp. 1771-1782, Dec. 2011. https://doi.org/10.1109/TIE.2008.918625
  13. Amit Kumar Jain and V.T. Ranganathan, "Improved Control of Load Commutated Inverter Fed Salient Pole Wound Field Synchronous Motor Using Field Oriented Technique," in Proceedings of IEEE ECCE 2012 Conference, Sept. 2012.
  14. Bhim Singh, Sanjeev Singh and S.P. Hemanth Chender, "Harmonics Mitigation in LCI-Fed Synchronous Motor Drives," IEEE Trans. Energy Conversion, vol. 25, no. 2, pp. 369-380, June 2010. https://doi.org/10.1109/TEC.2009.2038369
  15. David Finney, "Variable frequency AC motor drive systems," Peter Peregrinus Ltd, 1988, pp. 202-274.
  16. Alberto Tessarolo and Roberto Menis, "On the Modeling of Commutation Transients in Split-Phase Synchronous Motors Supplied by Multiple Load- Commutated Inverters," IEEE Trans. Industrial Electronics, vol. 57, no. 1, pp. 35-43, Jan. 2010. https://doi.org/10.1109/TIE.2009.2031182
  17. Chihiro Hasegawa and Shoji Nishikata, "A Sensorless Rotor Position Detecting Method," in Proceedings of IEEE ICEMS 2008 International Conference, Oct, 2008.
  18. Jung-Ik Ha, Kozo Ide, Toshihiro Sawa and Seung-Ki Sul, "Sensorless Rotor Position Estimation of an Interior Permanent-Magnet Motor from Initial states," IEEE Trans. Industrial Applications, vol. 39, no. 3, pp. 761-767, May/June. 2003. https://doi.org/10.1109/TIA.2003.811781
  19. Ali Sarikhani and Osama A. Mohammed, "Sensorless Control of PM Synchronous Machines by Physics- Based EMF observer," IEEE Trans. Energy Conversion, vol. 27, no. 4, pp. 1009-1017, Dec. 2012. https://doi.org/10.1109/TEC.2012.2208646
  20. Start-up System for a Synchronous Motor Drive, Alberto Abbondanti, Plum Boro, Pa. (1988, May 24). 4,746,850 [U.S. Patent documents]