Journal of the Korea institute for structural maintenance and inspection (한국구조물진단유지관리공학회 논문집)

Korea Institute for Structural Maintenance Inspection (한국구조물진단유지관리공학회)
권호 표지
DOI QR코드

DOI QR Code

Bond Performance of Magnesium Potassium Phosphate Cement Mortar according to Moisture Condition of Substrate

바탕면 함수조건에 따른 마그네시아 인산칼륨 시멘트 모르타르의 부착성능

  • Received : 2016.08.18
  • Accepted : 2016.09.23
  • Published : 2017.01.01
Download PDF
⟨ Previous Next ⟩

Abstract

This study focuses on the investigation of bond strength of magnesium potassium phosphate cement mortar(MKPC) according to moisture condition of substrate. Tensile bond test, shear bond test and interfacial bond test are adopted for evaluating the adhesion characteristics of MKPC to conventional cement mortar substrate. The main experimental variables are test methods and moisture levels of substrate. Because the moisture condition of the substrate may be critical to achieving bond, optimum moisture condition for a conventional concrete substrate has evaluated in this study. The results are as follows ; The effects of moisture condition at substrate into the bonding of MKPC are less different than polymer cement mortar and epoxy mortar. But the saturated and surface dry condition is the most appropriate moisture level among the considered, followed by saturated condition and wet condition. Thus, an adequate moisture level of substrate for MKPC is essential for good bond strength.

본 논문은 바탕면의 함수조건에 따른 보수재료로서 MKPC의 인발 부착강도, 전단 부착강도, 계면 부착강도를 폴리머 시멘트 모르타르, 에폭시 모르타르와 비교 분석하였다. 그 결과 MKPC는 PC 및 MKPC와 비교하여 바탕면 함수조건에 따른 부착성능의 변화가 상대적으로 작은 것으로 나타났다. 또한 MKPC의 경우 절건 바탕면에서의 부착성능은 무기계 보수재료인 폴리머 시멘트 모르타르와 비교하여 우수한 특성을 지니고 있으며, 습윤 바탕면에서의 부착성능은 폴리머 시멘트 모르타르와 유사한 수준을 보이고 있으나 에폭시 모르타르와 비교하여 우수한 특성을 지니는 것으로 나타났다.

Keywords

References

  1. Roy, D. M. (1987), New Strong Cement Materials: Chemically Bonded Ceramics, Science 235, 651-658. https://doi.org/10.1126/science.235.4789.651
  2. Abdelrazig, B. E. (1988), The Chemical Composition Of Mortars Made From Magnesia-Phosphate Cement, Cem. Concr. Res. 18, 415-425. https://doi.org/10.1016/0008-8846(88)90075-0
  3. Ahn, M. Y. (2008), The Properties of Ultra Rapid Hardening Mortar for Repair using Magnesia-Phosphate Cement, Ph.D. Dissertation, Dankook University, 25-28.
  4. Cho, H. W. (2012), Fundamental Properties of Magnesia-Prosphate Composite Considering Mix Conditions and Curing Temperature, Journal of The Korea Institute for Structural Maintenance and Inspection, 16, 163-170. https://doi.org/10.11112/jksmi.2012.16.6.163
  5. Seehra, S. S. (1993), Rapid Setting Magnesium Phosphate Cement for Quick Repair of Concrete Pavements - Characteristics and Durability Aspects, Cement and Concrete Research, 23, 254-266. https://doi.org/10.1016/0008-8846(93)90090-V
  6. Yang, Q. (1999), Factors Influencing Properties of Phosphate Cement-Based Binder for Rapid Repair of Concrete, Cement and Concrete Research, 29, 389-396. https://doi.org/10.1016/S0008-8846(98)00230-0
  7. Ma, H., Xu, B., and Li, Z. (2014), Effects of Water Content, Magnesia-to-Phosphate Molar Ratio and Age on Pore Structure, Strength and Permeability of Magnesium Potassium Phosphate Cement Paste, Materials and Design, 64, 497-502. https://doi.org/10.1016/j.matdes.2014.07.073
  8. Ma, H., Xu, B., and Li, Z. (2014), Magnesium Potassium Phosphate Cement Paste: Degree of Reaction, Porosity and Pore Structure, Cement and Concrete Research, 65, 96-104. https://doi.org/10.1016/j.cemconres.2014.07.012
  9. Kang, S. P., and Kim, J. H. (2015), Influence of Mixing Factors on the Early-Age Properties of Magnesium Potassium Phosphate Cement Mortar, Journal of the Architectural Institute of Korea, 31(5), 61-68.
  10. Yun, K. K., Lee, J. H., Choi, S. L., and Kim, K. H. (2001), Bond Strength Properties of Latex Modified Concrete, Journal of the Korea Institute for Structural Maintenance and Inspection, 13(5), 39-47.
  11. Oh S. K., and Choi S. M. (2001), A Study on Performance Evaluation by Application Conditions of Water Based Epoxy Resin Mortar as Surface Treatment Material for Concrete Reservoir, Journal of the Architectural Institute of Korea, 17(8), 85-94.
  12. Fernando, P. T, Castro, J. P., and Jalali, S. (2008), Adhesion Characterization of Tungsten Mine Waste Geopolymeric Binder. Influence of OPC Concrete Substrate Surface Treatment, Construction and Building Materials, 22, 154-161. https://doi.org/10.1016/j.conbuildmat.2006.10.005
  13. Huang, H., Liu, B., Xi, K., and Wu, T. (2016), Interfacial Tensile Bond Behavior of Permeable Polymer Mortar to Concrete, Construction and Building Materials, 121, 210-221. https://doi.org/10.1016/j.conbuildmat.2016.05.149