DOI QR코드

DOI QR Code

Mechanical Performance of Slurry Infiltrated High Performance Fiber Reinforced Cementitious Composite

슬러리 충전 고성능 섬유 보강 시멘트 복합체의 역학적 성능

  • Kim, Hyun Wook (Structural Engineering Research Group, Engineering Center, P OSCO E& C) ;
  • Lee, Chang Joon (Department of Architectural Engineering, Chungbuk National University)
  • Received : 2017.02.10
  • Accepted : 2017.02.24
  • Published : 2017.04.20

Abstract

This research investigated the mechanical performance of slurry infiltrated high performance fiber reinforced cementitious composite (SI-HPFRCC) with high volume blast furnace slag powder. Hooked-end steel fibers (volume fraction of 6.4%) were used for the fabrication of SI-HPFRCC. A series of mechanical performance test was conducted including strength and toughness of SI-HPFRCC in compressive and flexural mode at four different ages. Compressive and flexural strength tests of the slurry matrix at the same ages were also conducted in order to evaluate fiber reinforcing effect on the mechanical performance. The flexural response of SI-HPFRCC shows an increasing brittleness with age. The compressive response also shows an increasing brittleness with age but the degree of brittleness is much lower than the flexural case. In terms of strength, SI-HPFRCC shows about 140~190% of compressive strength improvement and 440~500% flexural strength improvement comparing to the slurry matrix.

고비율의 고로슬래그를 사용한 슬러리 충전 고성능 섬유보강 시멘트 복합체(SI-HPFRCC)의 역학적 성능을 평가하였다. SI-HPFRCC 실험체 제작을 위해 hooked-end 형의 강섬유를 6.4% 사용하였다. 재령에 따른 압축강도 및 압축인성과 휨강도 및 휨인성 실험을 통해 SI-HPFRCC의 역학적 성능을 평가하였다. 또한 섬유보강 효과를 평가하기 위해 SI-HPFRCC 실험체 제작에 사용된 슬러리 매트릭스의 압축강도 및 휨강도를 측정하였다. 실험결과 SI-HPFRCC의 휨거동이 재령에 따라 취성이 증가함을 확인하였다. 압축거동의 경우에도 재령에 따른 취성 증가를 볼 수 있었으나 그 정도는 미미하였다. 강도측면에서 볼 때 SI-HPFRCC는 슬러리 매트릭스에 비해 약 140~190%의 압축강도 증가와 440~500%의 휨강도 증가를 보였다.

Keywords

References

  1. Park YJ, Kim DG, Mun GS, Han SH, Kim GY, Han CG. Impact resistance characteristics of HPFRCC depending on various fiber replacing ratio. Proceeding of Korea Institute of Building Construction; 2015 May 28-29; Yeosu, Korea. Seoul (Korea): Korea Institute of Building Construction; 2015. p. 209-10.
  2. Kim SW, Lee JY, Bang JW, Kim KY, Park CW. Tensile strength characteristics of slurry infiltrated HPFRCC according to the fiber volume fraction. Proceeding of the Korea Concrete Institute; 2015 Oct 21-23; Gyeongju, Korea. Seoul (Korea): The Korea Concrete Institute; 2015. p. 83-4.
  3. Cheong SH, Kim HW, Lee CJ. Flexural strength properties of slurry infiltrated HPFRCC according to steel fiber change. Proceeding of the Korea Concrete Institute; 2015 May 13-15; Gwangju, Korea. Seoul (Korea): The Korea Concrete Institute; 2015. p. 327-28.
  4. Nam JS, Kim HS, Lee IC. Miyauchi H, Kim GY. Evaluation on the impact resistant performance of fiber reinforced concrete by high-velocity projectile and contacted explosion. Journal of the Korea Concrete Institute. 2013 Feb;25(1):107-14. https://doi.org/10.4334/JKCI.2013.25.1.107
  5. Lankard DR. Properties, application: slurry infiltrated fiber concrete (SIFCON). Concrete International. 1984 Dec;6(12): 44-7.
  6. Naaman AE, Homrich JR. Tensile stress-strain properties of sifcon. ACI Material Journal. 1989 May;86(3):244-51.
  7. Naaman AE, Otter D, Najm H. Elastic modulus of SIFCON in tension and compression. ACI Material Journal. 1992 Nov;88(6):603-31.
  8. Rao HS, Ramana NV. Behaviour of slurry infiltrated fibrous concrete (SIFCON) simply supported two-way slab in flexure. Indian Journal of Engineering & Material Sciences. 2005 Oct;12(5):427-33.
  9. ASTM C1609/C1609M-12. Standard Test Method for Flexural Performance of Fiber-Reinforced Concrete. ASTM International. West Conshohocken, PA. 2012.
  10. JSCE-SF5. Method of Test for Compressive Strength and Compressive Toughness of Steel Fibre-Reinforced Concrete. Japan Society of Civil Engineers. Tokyo. 1984.