Experimental Analysis for the Effect of Part's Dimensional Tolerance on the Pressing Pressure Uniformity of Laminator Equipment

라미네이터장비의 부품 치수공차가 가압력 균일도에 미치는 영향에 대한 실험적 분석

  • Ryu, Sun-Joong (Dept. of Mechanical Engineering, Dongyang Mirae University)
  • 유선중 (동양미래대학교 기계공학과)
  • Received : 2017.11.28
  • Accepted : 2017.12.21
  • Published : 2017.12.31

Abstract

In this study, we tried to analyze and measure the correlation between the part dimensional tolerance empirically applied by the designer and the final performance of the equipment, which is expressed as the pressing pressure uniformity. For this purpose, the dimensional tolerances and pressing pressure uniformity of eight laminator equipments were measured actually. As a result of the correlation analysis, it was confirmed that the tolerance grade for each dimension determined by the designer was valid. In the case of laminator equipment, the driving parts and the flatness have the largest influence on the uniformity of the pressing pressure.

Keywords

References

  1. Jang Yong Lee, "Tolerance Analysis of Automobile Steering System", Journal of the Korean Society for Precision Engineering, Vol. 28, No. 12, pp. 1397-1402, (2011).
  2. Jinsu Kim, Jae-Sung Kim, and Hyunjune Yim, "Tolerance Analysis and Design of Refrigerator Door System for Functional and Aesthetic Quality of Gap and Flush", J. Korean Soc. Precis. Eng., Vol. 31, No. 1, pp. 59-66, (2014). https://doi.org/10.7736/KSPE.2014.31.1.59
  3. Cheulgon Kim, Jihoon Hwang, Hyeongjoon Seo, Jinyong Mo, Duhan Jung and Seokmoo Hong, "Study of the Assembly of Indoor Air-conditioner Unit Using Tolerance Analysis", Trans. Korean Soc. Mech. Eng. A, Vol. 39, No. 4, pp. 423-428, (2015). https://doi.org/10.3795/KSME-A.2015.39.4.423
  4. Sun-Joong Ryu, Doeg Jung Kim, "Contact Pressure Distribution Measurement of PVA Brush for Post CMP Cleaning", J. the Semiconductor & Display Equipment Technology, Vol.3, No.4, pp.73-78, (2016).