DOI QR코드

DOI QR Code

Study on Performance Variation According to the Arrangements of Adjacent Vertical-Axis Turbines for Tidal Current Energy Conversion

인접한 조류발전용 수직축 터빈의 배치방식에 따른 성능 변화

  • Lee, Jeong-Ki (Div. of Naval Architecture & Ocean Systems Engineering, Korea Maritime & Ocean University) ;
  • Hyun, Beom-Soo (Div. of Naval Architecture & Ocean Systems Engineering, Korea Maritime & Ocean University)
  • 이정기 (한국해양대학교 조선해양시스템공학부) ;
  • 현범수 (한국해양대학교 조선해양시스템공학부)
  • Received : 2016.03.15
  • Accepted : 2016.04.28
  • Published : 2016.05.25

Abstract

Tidal farm is a multi-arrayed turbine system for utilizing tidal stream energy. For horizontal-axis turbine(HAT) system, it is recommended that each unit has to be deployed far apart in order to avoid hydrodynamic interference among turbines, as proposed by the European Marine Energy Centre(EMEC). But there is no rule for the arrangement of vertical-axis turbine(VAT) yet. Moreover it has been reported that a proper arrangement of adjacent turbines can enhance the overall efficiency even greater than an arrangement without mutual interference effect. This paper suggests the layout of VATs showing the better performances, which turned out to be quite different from HATs' arrangement. Numerical calculations were performed to investigate the performance variation in terms of the rotational direction as well as the distance between turbines. It has been shown that the best combination of rotational direction and distance between turbines can increase its performance higher about 9.2% than that of two independently operated turbines. It is likely that such improvement is due to the increased velocity between adjacent turbines. For diagonally arranged turbines, the maximum normalized mean power coefficient was obtained to be higher about 5.6% than that of two independent turbines. It is expected that the present results can be utilized for conceptual design of tidal farm to harness the tidal stream energy.

조류발전단지는 유망한 해역에 터빈을 복수로 다배열하여 발전하는 시스템을 말한다. 이러한 단지는 각 터빈이 최대 효율로 작동하고, 최대 발전량을 얻을 수 있도록 설계되어야 하는데, 이를 위해서는 터빈 사이의 간섭으로 인한 성능 저하가 발생하지 않도록 터빈은 일정 거리를 두고 배치되어야 한다. 수평축 터빈의 경우 EMEC(European Marine Energy Centre)에서 배치거리를 제안하고 있으나, 수직축 터빈은 그러한 규정이 제안된 바 없다. 여러 연구 결과들에 따르면 수직축 터빈이 인접할 경우 성능의 향상까지 도모될 수 있으므로, 그 배치는 수평축 터빈보다 더욱 중요하게 검토될 필요가 있다. 본 논문에서는 수직축 터빈에 대하여 수평축 터빈과 같이 일정 거리를 두고 배치하는 것과 터빈을 인접하도록 배치하는 것과의 차이를 조사하였다. 이를 위해 두 터빈간의 거리와 회전방향을 파라메터로 하여 그에 따른 성능 차이를 수치해석적으로 연구하였고, 그 이유를 파악하고자 하였다. 본 연구를 통하여 가장 적절한 수치해석 영역과 조건을 설정할 수 있었으며, 인접한 두 터빈이 각각 반시계-시계방향으로 회전하는 것이 단독 터빈 2기 대비 약 9.2%의 성능향상이 예측되었다. 터빈이 대각으로 배치된 경우는 최대 약 5.6%정도 성능이 향상됨을 확인하였다. 본 연구는 수직축 터빈을 이용한 조류발전단지를 설계시 유용한 정보가 될 것으로 기대된다.

Keywords

References

  1. Dabiri, O.J., 2011, "Potential order-of-magnitude enhancement of wind farm power density via counter-rotating vertical-axis wind turbine arrays", J. Renew. Sustain. Energ., Vol. 3, 043104. https://doi.org/10.1063/1.3608170
  2. EMEC, 2009, "Assessment of Tidal Energy Resource - Marine renewable energy guides", the European Marine Energy Centre (EMEC).
  3. Hyun, B. S. et al., 2012, "Tidal Stream Energy Research", Final report, Tidal Stream Energy Research Center.
  4. Hyun, B. S. and Lee, J. K., 2013, "Hydrodynamic aspects on three-dimensional effects of vertical-axis tidal stream turbine", J. Korean Soc. Mar. Environ. Energy, Vol. 16, No. 2, 61-70. https://doi.org/10.7846/JKOSMEE.2013.16.2.61
  5. IEC, 2005, "Wind turbines - Part 1: Design requirements (IEC-61400-1)", Committee Draft, International Electrotechnical Commission (IEC).
  6. Kinzel, M. et al., 2012, "Energy exchanging in an array of vertical-axis wind turbines", J. Turbulence, Vol. 13, No. 38, 1-13. https://doi.org/10.1080/14685248.2011.633522
  7. Li, Y. and Calisal, M.S., 2010, "Modeling of twin-turbine systems with vertical axis tidal current turbines: Part I-Power output", J. Ocean Eng., Vol. 37, 627-637. https://doi.org/10.1016/j.oceaneng.2010.01.006
  8. Marsh, P. et al., 2015, "Three-dimensional numerical simulation of straight-bladed vertical axis tidal turbines investigating power output, torque ripple and mounting force", J. Renew. Energ., Vol. 83, 67-77. https://doi.org/10.1016/j.renene.2015.04.014
  9. Rawlings, W.G., 2005, "Parametric characterization of an experimental vertical-axis hydro turbine", Thesis for master degree, University of British Columbia.