DOI QR코드

DOI QR Code

Performance Analysis of Strength Development of FRC Base Depending on Maturity

적산온도에 의한 FRC 기층의 강도발현 성능 분석

  • 최성용 ((주)이노블록 기술연구소) ;
  • 박영환 (한국건설기술연구원 구조융합연구소) ;
  • 정우태 (한국건설기술연구원 구조융합연구소)
  • Received : 2014.10.20
  • Accepted : 2016.01.26
  • Published : 2016.02.15

Abstract

PURPOSES : In this study, we analyzed the compressive strength characteristics of lean base concrete in relation to changes in the outdoor temperature after analyzing the cold and hot weather temperature standards and calculated the minimum and maximum temperatures when pouring concrete. We examined the rate of strength development of lean base concrete in relation to the temperature change and derived an appropriate analysis formula for FRC base structures by assigning the accumulated strength data and existing maturity formula. METHODS : We measured the strength changes at three curing temperatures (5, 20, and $35^{\circ}C$) by curing the concrete in a temperature range that covered the lowest temperature of the cold period, $5^{\circ}C$, to the highest temperature of the hot period, $35^{\circ}C$. We assigned the general lean concrete and FRC as test variables. A strength test was planned to measure the strength after 3, 5, 7, 14, and 28 days. RESULTS : According to the results of compressive strength tests of plain concrete and FRC in relation to curing temperature, the plain concrete had a compressive strength greater than 5 MPa at all curing temperatures on day 5 and satisfied the lean concrete standard. In the case of FRC, because the initial strength was substantially reduced as a result of a 30% substitution of fly ash, it did not satisfy the strength standard of 5 MPa when it was cured at $5^{\circ}C$ on day 7. In addition, because the fly ash in the FRC caused a Pozzolanic reaction with the progress into late age, the amount of strength development increased. In the case of a curing temperature of $20^{\circ}C$, the FRC strength was about 66% on day 3 compared with the plain concrete, but it is increased to about 77% on day 28. In the case of a curing temperature of $35^{\circ}C$, the FRC strength development rate was about 63% on day 3 compared with the plain concrete, but it increased to about 88% on day 28. CONCLUSIONS : We derived a strength analysis formula using the maturity temperatures with all the strength data and presented the point in time when it reached the base concrete standard, which was 5 MPa for each air temperature. We believe that our findings could be utilized as a reference in the construction of base concrete for a site during a cold or hot weather period.

Keywords

References

  1. Alexander, K. M. and Taplin, J. H., 1962. Concrete Strength, Paste Strength, Cement Hydration and Maturity Rule, Australian Journal of Applied Science, Australia, Vol.13, pp.277-284.
  2. Architectural Institute of Korea, Standard Specification for Construction, 2013.
  3. Carino, N. J., 1984. Maturity Method; Theory and Application, Journal of Cement and Concrete, ASTM, USA.
  4. Guo, C., 1989. Maturity of Concrete Method for Predicting Early-Stage Strength, ACI Material Journal, USA, Vol.86, No.4, pp.341-353.
  5. Hansen, P. F. and Pedersen, E. J., 1997. Maturity Computer for Controlled Curion and Hardening of Concrete, Nordisk Betong, Sweden, Stockholm, Vol.1, pp.19-34.
  6. Korea Concrete Institute, Standard specification for Concrete, 2009.
  7. Korea Institute of Construction Technology, Development of Fiber Reinforced Concrete Base for Composite Pavement System, Research Paper, 2012.
  8. Ministry of Land, Infrastructure and Transport, Paving Guidelines, 2005.
  9. Plowman, J. M., 1956. Maturity and Strength of Concrete, Magazine of Concrete Research, Vol.8, No.2, pp.13-22. https://doi.org/10.1680/macr.1956.8.22.13
  10. Saul, A. G. A., 1951. Principle Underlying the Steam Curing of Concrete at Atmospheric Pressure, Magazine of Concrete Research, Vol.2, No.6, pp.127-140. https://doi.org/10.1680/macr.1951.2.6.127
  11. 鎌田英治, 洪悅郞, 鎌田英治, 雅幸田畑, 幸雄浜, 1986. Propose concrete strength estimation using a logistic curve(幸雄ロジスティック曲線を用したコンクリ-ト强度推定式の提案) : Architectural Institute of Japan(日本建築學會構造系論文報告集), Japan, No.367, pp.1-7.