Journal of Biomedical Engineering Research (대한의용생체공학회:의공학회지)

The Korean Society of Medical and Biological Engineering (대한의용생체공학회)
권호 표지
DOI QR코드

DOI QR Code

A Feasibility Study for Application of Single-Chip Solution for Diagnostic Resting ECG

ECG 원칩 솔루션의 진단용 심전계 적용을 위한 타당성 연구

  • Received : 2015.06.10
  • Accepted : 2015.08.01
  • Published : 2015.08.30
Download PDF
⟨ Previous Next ⟩

Abstract

In order for medical devices to be used outside hospital, they have to be not only of small size but also power consumption has to be kept at low level. This study investigates the feasibility of application of ADS1298 ECG single-chip solution developed by Texas Instruments Inc. for use in development of a new platform for diagnostic resting ECG. To prove the feasibility of commercial products based on the ADS1298 chip, the performance of the ADS1298 chip was measured in terms of input impedance, common mode rejection, frequency response, and input dynamic range using the testing method under the suitability criteria of the IEC 60601-2-25 standard. Result of the this study shows that commercialization of the ECG products based on the ADS1298 ECG single-chip solution that satisfies the international standards would be possible, if the manufactures take the filter characteristics into account in building a new platform for diagnostic resting ECG.

Keywords

References

  1. Y. S. Lee et al., "Introduction to Medical Engineering", Shinkwang Press, pp. 155-162, 1999 (in Korean).
  2. Jan A. Kors, Gerald van Herpen, Jan H. Bemmel, "Variability in ECG Computer Interpretation", Journal of Electrocardiology, vol. 25, no. 4, pp. 263-271, 1992. https://doi.org/10.1016/0022-0736(92)90031-T
  3. Barbara Drew, Paul Kliegfield, Standardizing electrocardiographic leads", Journal of Electrocardiology, Vol. 41, Supplement, pp. 187-189, 2008. https://doi.org/10.1016/j.jelectrocard.2008.01.003
  4. "Electrocardiogram Measurement Circuit Design Lab" Course Note, Design of Medical Devices, Dept. of ECEE, Univ. of Colorado, Fall Term, 2013.
  5. B. Drew, P. Kligfield, "Standardizing electrodcardio-graphic leads", Journal of Electrocardiology, vol. 41, pp. 187-189, 2008. https://doi.org/10.1016/j.jelectrocard.2008.01.003
  6. ANSI/AAMI EC11, Diagnostic electrocardiographic devices, American National Standard, 2001.
  7. IEC 60601-2-25, Part 2-25: Particular requirements for the basic safety and essential performance of electrocardiographs, International Electrotechnical Commission, 2011.
  8. IEC 60601-2-51, Part 2-51: Particular requirements for safety, including essential performance, of recording and analysing single channel and multichannel electrocardiographs, International Electrotechnical Commission, 2013.
  9. Per Forstberg, Gustav Josefsson, "Evaluation of Commercial Analog Front Ends for Pattern Recognition Based Control of Robotic Prostheses", Chalmers University of Technology, pp. 22-23, 2011.