DOI QR코드

DOI QR Code

Study of wind tunnel test results of high-rise buildings compared to different design codes

  • Badri, Abdulmonem A. (Department of structural engineering, faculty of engineering, Cairo university) ;
  • Hussein, Manar M. (Department of structural engineering, faculty of engineering, Cairo university) ;
  • Attia, Walid A. (Department of structural engineering, faculty of engineering, Cairo university)
  • 투고 : 2014.09.07
  • 심사 : 2015.03.10
  • 발행 : 2015.05.25

초록

Several international codes have been developed for evaluating wind loads on structures; however, the wind structure interaction could not be accurately captured by these codes due to the gusty nature of wind and the dynamic behavior of structures. Therefore, the alternative wind tunnel testing was introduced. In this study, an introduction to the available approaches for wind load calculations for tall buildings was presented. Then, a comparative study between different codes: the Egyptian code, ECP 201-08, ASCE 7-05, BS 6399-2, and wind tunnel test results was conducted. An investigation has been carried out on two case studies tall buildings located within the Arabian Gulf region. Numerical models using (ETABS) software were produced to obtain the relation between codes analytical values and wind tunnel experimental test results for wind loads in the along and across wind directions. Results for the main structural responses including stories forces, shears, overturning moments, lateral displacements, and drifts were presented graphically in order to give clear comparison between the studied methods. The conclusions and recommendations for future works obtained from this research are finally presented to help improving Egyptian code provisions and show limitations for different cases.

키워드

참고문헌

  1. ACI Committee 318 (2005), ACI 318R-05, Building Code Requirements for Structural Concrete (ACI 318-05) and Commentary (ACI 318R-05), American Concrete Institute, - Building - 430 pages.
  2. Aly, A.M., Zasso, A. and Resta, F. (2011), "Dynamics and control of high-rise buildings under multidirectional wind loads", Smart Mater. Res., 2011(ID 549621), 15pages.
  3. ASCE 7-05 (2006), Minimum Design Loads for Buildings and Other Structures, Standard, American Society of Civil Engineers, Reston, VA.
  4. ASCE Task Committee on Drift Control of Steel Building Structures of the Committee on Design of Steel Building Structures (1988), "Wind drift design of steel-framed buildings: State-of-the-art report", J. Struct. Eng.- ASCE, 114(9), 2085-2108. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:9(2085)
  5. Au, S. and To, P. (2012), "Full-scale validation of dynamic wind load on a super-tall building under strong wind", J. Struct. Eng. - ASCE, 138(9), 1161-1172. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000539
  6. Badri, A.A. (2012), Study of wind tunnel test results of high-rise buildings compared to international and Egyptian design codes, M.Sc. thesis, Faculty of Engineering, Cairo University.
  7. Bashor, R. and Kareem, A. (2009), "Comparative study of major international standards", Proceedings of the 7th Asia-Pacific Conference on Wind Engineering, November 8-12, 2009, Taipei, Taiwan.
  8. Belloli, M., Rosa, L. and Zasso, A. (2014), "Wind loads on a high slender tower: Numerical and experimental comparison", Eng. Struct., 68(6), 24-32. https://doi.org/10.1016/j.engstruct.2014.02.030
  9. Bhami Mohammed, Cini, C. and Suresh Kumar, K. (2009), "Wind Loads: Where does our code of practice stand", Proceedings of the 5th National Conference on Wind Engineering, Surat, India, November.
  10. BSI (1997), Loading for Buildings, Part 2: Code of Practice for Wind Loads. BS 6399-2, British Standards Institute, London.
  11. Computers and Structures, Inc (2011), Extended three dimensional analysis of building systems (ETABS), Computer software package, version 9.7.4, CSI, Berkeley.
  12. Davenport, A.G. (2007), Wind Tunnel Testing: a General Outline, The Boundary Layer Wind Tunnel Laboratory, The University of Western Ontario, Faculty of Engineering Science London, Ontario, Canada N6A 5B9.
  13. ECP: ECP-201-08 (2008), Egyptian code for calculating loads and forces in structural work and masonry Housing and Building National Research Center, Ministry of Housing, Utilities and Urban Planning, Cairo.
  14. http://www.comp-engineering.com/ETABManE.htm
  15. Gerges, R.R. and Benuska, K (2013), "Across-wind response of high-rise buildings", Articles, Structural Performance, STRUCTURE magazine, July, 2013.
  16. Heiza, K.M. and Tayel, M.A. (2012) "Comparative study of the effects of wind and earthquake loads on high-rise buildings", Concrete Res. Lett., 3(1), 386-405.
  17. Holmes, J.D. (2014), "Along and cross-wind response of a genetic tall building: Comparison of wind tunnel data with codes ad standards", J. Wind Eng. Ind. Aerod., 132, 136-141. https://doi.org/10.1016/j.jweia.2014.06.022
  18. Kikitsu, H., Okada, H. and Okuda, Y. (2003), "Comparison of peak pressure coefficients for wind load among international codes and standards", Proceedings of the CIB-CTBUH International Conference on Tall Buildings.
  19. Kim, Y.C., Kanda, J. and Tamura, Y. (2011) "Wind-induced coupled motion of tall buildings with varying square plan with height", J. Wind Eng. Ind. Aerod., 99(5), 638-650. https://doi.org/10.1016/j.jweia.2011.03.004
  20. Liang, S., Zou, L., Wang, D. and Huang, G. (2014), "Analysis of three dimensional equivalent static wind loads of symmetric high-rise buildings based on wind tunnel tests", Wind Struct., 19(5), 565-583. https://doi.org/10.12989/was.2014.19.5.565
  21. McNamara, R.J. (2001), "Practical solution to reduce the wind induced response of tall buildings", Proceedings of the 6th World Congress of the Council on Tall Buildings and Urban Habitat, Council on tall buildings and urban habitat, Melbourne Organizing Committee.
  22. Ming, G. (2010), "Wind-resistant studies on tall buildings and structures", Sci. China Technol. Sc., 53(10), 2630-2646. https://doi.org/10.1007/s11431-010-4016-2
  23. Merrick, R. and Bitsuamlak, G. (2009), "Shape effects on the wind-induced response of high-rise buildings", J. Wind Eng., 6(2), 1-18.
  24. Sepe, V. and Marcello Vasta, M. (2014), "Wind-tunnel tests on high-rise buildings: wind modes and structural response", Wind Struct., 18(1), 037-056. https://doi.org/10.12989/was.2014.18.1.037
  25. Simiu, E. (2009), Toward A Standard on the Wind Tunnel Method, NIST technical note 1655.
  26. Smith, B.S. and Coull, A. (1991), Tall Building Structures: Analysis and Design, New York, John Wiley & Sons, Inc.
  27. Taranath, B.S. (2009), Reinforced Concrete Design of Tall Buildings, New York, CRC Press, Taylor &Francis Group.
  28. Zhou, Y., Kijewski, T. and Kareem, A. (2002), "Along-wind load effects on tall buildings: Comparative study of major international codes and standards", J. Struct. Eng. - ASCE, 128(6), 788-796. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:6(788)

피인용 문헌

  1. Experimental research on design wind loads of a large air-cooling structure vol.28, pp.4, 2015, https://doi.org/10.12989/was.2019.28.4.215
  2. A Comparative Study of Wind Tunnel Tests and Design Codes in Evaluation of Along-Wind Effects on Towers vol.2021, pp.None, 2015, https://doi.org/10.1155/2021/8818057
  3. The Modern Trend of Super Slender Residential Buildings vol.20, pp.1, 2015, https://doi.org/10.35784/bud-arch.2068