The Transactions of The Korean Institute of Electrical Engineers (전기학회논문지)

The Korean Institute of Electrical Engineers (대한전기학회)
권호 표지
DOI QR코드

DOI QR Code

Fan Effect for Temperature Rising Suppression of the Rare Earth IPMSM

IPMSM의 희토류 영구자석의 온도상승 억제를 위한 팬효과

  • Jo, Eul-Gyu (Dept. of Electrical Engineering, Changwon Nat'l University) ;
  • Cho, Kwang-Jin (Dept. of Electrical Engineering, Changwon Nat'l University) ;
  • Kim, Gyu-Tak (Dept. of Electrical Engineering, Changwon Nat'l University)
  • Received : 2015.08.31
  • Accepted : 2015.10.06
  • Published : 2015.11.01
Download PDF
⟨ Previous Next ⟩

Abstract

In this paper, temperature characteristic analysis was performed by using a thermal equivalent circuit. To suppress the temperature rising, the cooling fan was installed in rotor. The temperature of permanent magnet was reduced from 66[$^{\circ}C$] to 55[$^{\circ}C$] by installing the fan. The temperature of the permanent magnets is difficult to measure. Therefore the temperature of end winding was measured directly by the thermo couple. The validity of this study was demonstrated as compared the calculated results with experimental ones.

Keywords

References

  1. Gyu-Hong Kang, Young-Dae Song, Gyu-Tak Kim and Jin-Hur, "The Novel Cogging Torque Reduction Method for Interior Type Permanent Magnet Motor", IEEE Trans. on AE, Vol. 45, No. 1, pp 161-167, 2009.
  2. Jae-Won Lim, Jang-Ho Seo, Sang-Yub Lee, Hyun-Kyo Jung, "Thermal network analysis of interior permanent magnet machine" 2009 Spring Conference of The Korean Society for Railway, pp. 527-532, 2009.
  3. 이양수, 한송엽, "전동기의 열해석 기술", Proceedings of KIEE, Vol. 48, No. 9, pp. 12-17, 1999.
  4. S.K. Chowdhury, P.K Baski, "A simple lumped parameter thermal model for electrical machine of TEFC design", Power Electronics, Drives and Energy Systems(PEDES) & 2010 Power India, 2010 Joint International Conference on, pp 1-7, 2010.
  5. Y. Chen, P. Pillay, "An Improved formula for lamination core loss calculations in machines operating with high frequency and high flux density excitation", Industry Application conference. Vol. 2, pp. 13-18, 2002.
  6. J.P. Holman, "Heat Transfer", McGraw-Hill, 10th Edition, 2010.
  7. Ayman M. EL-Rafaie, Nathan C. Harris, Thomas M. Jahns, Khwaja M. Rahman, "Thermal Analysis of Multibarrier Interior PM Synchronous Machine Using Lumped Parameter Model", IEEE Trans. on Energy Conversion, Vol. 19, No. 2, 2004.