DOI QR코드

DOI QR Code

Force transfer mechanism in positive moment continuity details for prestressed concrete girder bridges

  • Hossain, Tanvir (SBM Offshore) ;
  • Okeil, Ayman M. (Department of Civil and Environmental Engineering, Louisiana State University)
  • Received : 2012.12.21
  • Accepted : 2014.05.26
  • Published : 2014.08.25

Abstract

The force transfer mechanism in positive moment continuity details for prestressed concrete girder bridges is investigated in this paper using a three-dimensional detailed finite element model. Positive moment reinforcement in the form of hairpin bars as recommended by the National Cooperative Highway Research Program Report No 519 is incorporated in the model. The cold construction joint that develops at the interface between girder ends and continuity diaphragms is also simulated via contact elements. The model is then subjected to the positive moment and corresponding shear forces that would develop over the service life of the bridge. The stress distribution in the continuity diaphragm and the axial force distribution in the hairpin bars are presented. It was found that due to the asymmetric configuration of the hairpin bars, asymmetric stress distribution develops at the continuity diaphragm, which can be exacerbated by other asymmetric factors such as skewed bridge configurations. It was also observed that when the joint is subjected to a positive moment, the tensile force is transferred from the girder end to the continuity diaphragm only through the hairpin bars due to the lack of contact between the both members at the construction joint. As a result, the stress distribution at girder ends was found to be concentrated around the hairpin bars influence area, rather than be resisted by the entire girder composite section. Finally, the results are used to develop an approach for estimating the cracking moment capacity at girder ends based on a proposed effective moment of inertia.

Keywords

References

  1. AASHTO (2010), LRFD Bridge Design Specifications, American Association of State Highway and Transportation Officials, Washington, D.C.
  2. ANSYS (2008), Theory Reference, ANSYS, Inc., Canonsburg, PA.
  3. Caner, A., Dogan, E. and Zia, P. (Mar. 2002), "Seismic performance of multisimple-span bridges retrofitted with link slabs", J. Bridge Eng., ASCE, 7(2), 85-93. https://doi.org/10.1061/(ASCE)1084-0702(2002)7:2(85)
  4. Caner, A. and Zia, P. (1998), "Behavior and design of link slabs for jointless bridge decks", PCI J., Precast/Prestressed Concrete Institute, 43(3), 68-80. https://doi.org/10.15554/pcij.05011998.68.80
  5. El-Safty, A. and Okeil, A.M. (2008), "Extending the service life of bridges using continuous decks", PCI J., Precast/Prestressed Concrete Institute, 53(6), 96-111. https://doi.org/10.15554/pcij.11012008.96.111
  6. Hastak, M., Mirmiran, A., Miller, R.A., Shah, R. and Castrodale, R. (2003), "State of practice for positive moment connections in prestressed concrete girders made continuous", J. Bridge Eng., 8(5), 267-272. https://doi.org/10.1061/(ASCE)1084-0702(2003)8:5(267)
  7. Hossain, T., Okeil, A.M. and Cai, C.S. (2013a), "Calibrated finite element modeling of creep behavior of prestressed concrete bridge girders", (Accepted for publication in ACI Struct. J.).
  8. Hossain, T., Okeil, A.M. and Cai, C.S. (2013b), "Field test and finite element modeling of a three span continuous girder bridge", J. Perform. Constr.Facil., ASCE, 28(1), 136-148.
  9. Hossain, T., Segura, S. and Okeil, A.M. (2012), "Analytical and field measured temperature profile and its structural effects on a continuous girder bridge", (submitted for publication in the ASCE J. of Bridge Engineering).
  10. Kim, T.H., Cheon, J.H. and Shin, H.M. (2012), "Evaluation of behavior and strength of Prestressed Concrete Deep Beams Using Nonlinear Analysis", Comput. Concrete, 9(1), 63-79. https://doi.org/10.12989/cac.2012.9.1.063
  11. Lee, D.H., Hwang, J.H., Ju, H. and Kim, K.S. (2014), "Application of direct tension force transfer model with modified fixed-angle softened-truss model to finite element analysis of steel fiber-reinforced concrete members subjected to shear", Comput. Concrete, 13(1), 49-70. https://doi.org/10.12989/cac.2014.13.1.049
  12. Miller, R.A., Castrodale, R., Mirmiran, A. and Hastak, M. (2004), Connection of Simple-Span Precast Concrete Girders for Continuity, NCHRP Report 519, Transportation Research Board, Washington, D.C.,
  13. Mirmiran, A., Kulkarni, S., Castrodale, R., Miller, R. and Hastak, M. (2001), "Nonlinear continuity analysis of precast, prestressed concrete girders with cast-in-place decks and diaphragms", PCI J., Precast/Prestressed Concrete Institute, 46(5), 60-80.
  14. Nawy, E.G. (2000), Prestressed Concrete A Fundamental Approach.
  15. Newhouse, C.D., Roberts-Wollmann, C.L., Cousins, T.E. and Davis, R.T. (2008), "Modeling early-age bridge restraint moments: creep, shrinkage, and temperature effects", J. Bridge Eng., 13(5), 431-438. https://doi.org/10.1061/(ASCE)1084-0702(2008)13:5(431)
  16. Oesterle, R.G., Glikin, J.D. and Larson, S.C. (Jan. 1989), Design of Precast Prestressed Bridge Girders Made Continuous, NCHRP Report No. 322, Transportation Research Board, Washington, D.C.,
  17. Okeil, A.M. and El-Safty, A.K. (Nov. 2005), "Partial continuity in bridge girders with jointless decks", Pract. Period. Struct. Des. Constr., ASCE, 10(4), 229-238. https://doi.org/10.1061/(ASCE)1084-0680(2005)10:4(229)
  18. Okeil, A.M., Cai, C.S., Chebole, V. and Hossain, T. (2011), "Evaluation of continuity detail for precast prestressed girders", 477, Louisiana Transportation Research Center, Baton Rouge, LA, p. 198.
  19. Okeil, A.M., Hossain, T. and Cai, C.S. (2013), "Field monitoring of positive moment continuity detail in a skewed prestressed concrete bulb-T girder bridge", PCI Journal, Precast/Prestressed Concrete Institute, SPR 2013, 2-12.
  20. Peterman, R.J. and Ramirez, J.A. (1998), "Restraint moments in bridges with full-span prestressed concrete form panels", PCI Journal, Precast/Prestressed Concrete Institute, 43(1), 54-73. https://doi.org/10.15554/pcij.01011998.54.73
  21. Salmons, J.R. and May, G.W. (1974), Strand Reinforcing for End Connection of Pretensioned I-Beam Bridges, Interim Report 73-5B, Missouri Cooperative Highway Research Program, Missouri State Highway Department.
  22. Schlaich, J., Schafer, K. and Jennewein, M. (1987), "Toward a cnsistent dsign of sructural cncrete", PCI J., Precast/Prestressed Concrete Institute, 32(3), 74-150. https://doi.org/10.15554/pcij.05011987.74.150
  23. Shang, F., An, X.H., Kawai, S. and Mishima, T. (2010), "Open-slip coupled model for simulating three-dimensional bond behavior of reinforcing bars in concrete", Comput. Concrete, 7(5), 403-419. https://doi.org/10.12989/cac.2010.7.5.403
  24. Shayanfar, M.A. and Safiey, A. (2008), "A new approach for nonlinear finite element analysis of Reinforced cncrete structures with corroded reinforcements", Comput. Concrete, 5(2), 155-174. https://doi.org/10.12989/cac.2008.5.2.155
  25. Sousa, C., Sousa, H., Neves, A.S. and Figueiras, J. (2012), "Numerical evaluation of the long-term behavior of precast continuous bridge decks", J. Bridge Eng., 17(1), 89-96. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000233
  26. Timoshenko, S.P. and Gere, J.M. (2009), Theory of Elastic Stability, Dover Publications, USA.
  27. Wang, W.W., Dai, J.G., Huang, C.K. and Bao, Q.H. (2011), "Strengthening multiple span simply-supported girder bridges using post-tensioned negative moment connection technique", Eng. Struct., 33(2), 663-673. https://doi.org/10.1016/j.engstruct.2010.11.025

Cited by

  1. Bond behavior of lightweight concretes containing coated pumice aggregate: hinged beam approach vol.16, pp.6, 2015, https://doi.org/10.12989/cac.2015.16.6.909
  2. Structural Behavior of Debonded Link-Slabs in Continuous Bridge Decks vol.24, pp.5, 2019, https://doi.org/10.1061/(ASCE)BE.1943-5592.0001388
  3. Camber calculation of prestressed concrete I-Girder considering geometric nonlinearity vol.19, pp.1, 2017, https://doi.org/10.12989/cac.2017.19.1.001
  4. A numerical-experimental evaluation of beams composed of a steel frame with welded and conventional stirrups vol.22, pp.1, 2014, https://doi.org/10.12989/cac.2018.22.1.027
  5. Structural effects of temperature gradient on a continuous prestressed concrete girder bridge: analysis and field measurements vol.16, pp.11, 2014, https://doi.org/10.1080/15732479.2020.1713167