DOI QR코드

DOI QR Code

Estimating floor spectra in multiple degree of freedom systems

  • Calvi, Paolo M. (Department of Civil Engineering, University of Toronto) ;
  • Sullivan, Timothy J. (Department of Civil Engineering and Architecture, Universita' degli Studi di Pavia)
  • 투고 : 2013.11.11
  • 심사 : 2014.03.03
  • 발행 : 2014.07.31

초록

As the desire for high performance buildings increases, it is increasingly evident that engineers require reliable methods for the estimation of seismic demands on both structural and non-structural components. To this extent, improved tools for the prediction of floor spectra would assist in the assessment of acceleration sensitive non-structural and secondary components. Recently, a new procedure was successfully developed and tested for the simplified construction of floor spectra, at various levels of elastic damping, atop single-degree-of-freedom structures. This paper extends the methodology to multi-degree-of-freedom (MDOF) supporting systems responding in the elastic range, proposing a simplified modal combination approach for floor spectra over upper storeys and accounting for the limited filtering of the ground motion input that occurs over lower storeys. The procedure is tested numerically by comparing predictions with floor spectra obtained from time-history analyses of RC wall structures of 2- to 20-storeys in height. Results demonstrate that the method performs well for MDOF systems responding in the elastic range. Future research should further develop the approach to permit the prediction of floor spectra in MDOF systems that respond in the inelastic range.

키워드

참고문헌

  1. Biggs, J.M. (1971), "Seismic response spectra for equipment design in nuclear power plants", Proceeding of the 1st International Conference Struct. Mech. Rreact. Techn., Berlin, Paper K4/7.
  2. Carr, A.J. (2009), Ruaumoko3D - A program for Inelastic Time-History Analysis, Department of Civil Engineering, University of Canterbury, New Zealand.
  3. CEN EC8 (2004), Eurocode 8 - Design Provisions for Earthquake Resistant Structures, EN-1998-1:2004: E, Comite Europeen de Normalization, Brussels, Belgium.
  4. Chopra, A.K. (2000), "Dynamics of structures", Pearson Education, USA.
  5. Garcia, R., Sullivan T.J. and Della Corte, G. (2010), "Development of a displacement-based design method for steel frame-RC wall buildings", J. Earthq. Eng., 14(2), 252-277. https://doi.org/10.1080/13632460902995138
  6. Igusa, T. and Der Kiureghian, A. (1985), "Generation of floor response spectra including oscillator-structure interaction", Earthq. Eng. Struct. Dyn., 13(5), 661-676. https://doi.org/10.1002/eqe.4290130508
  7. Kumari, R. and Gupta V.K. (2007), "A modal combination rule for peak floor accelerations in multistoried buildings", ISET J. Earthq. Tech., 44(1), 213-231.
  8. Maley, T.J., Sullivan, T.J. and Della Corte, G. (2010), "Development of a displacement-based design method for steel dual systems with buckling-restrained braces and moment resisting frames", J. Earthq. Eng., 14(1), 106-140. https://doi.org/10.1080/13632461003651687
  9. Menon, A. and Magenes, G. (2008), Out-of-plane Seismic Response of Unreinforced Masonry Definition of Seismic Input, Research Report ROSE - 2008/04, IUSS Press, Pavia, Italy, 269 pages.
  10. Mondal, G. and Jain, S.K. (2005), "Design of non-structural elements for buildings: A review of codal provisions", Indian Concrete J., 79(8), 22-28.
  11. Oropeza, M., Favez, P. and Lestuzzi, P. (2010), "Seismic response of nonstructural components in case of nonlinear structures based on floor response spectra method", Bull. Earthq. Eng., 8(2), 387-400. https://doi.org/10.1007/s10518-009-9139-0
  12. Pennucci, D., Sullivan, T.J. and Calvi, G.M. (2011), Performance-Based Seismic Design of Tall RC Wall Buildings, Research Report ROSE2011/02, IUSS Press, Pavia, Italy, 319pages.
  13. Priestley, M.J.N., Calvi, G.M. and Kowalsky, M.J. (2007), "Direct displacement-based seismic design", IUSS Press, Pavia, Italy, 720 pages.
  14. Rodriguez, M.E., Restrepo, J.I. and Carr, A.J. (2002), "Earthquake-induced floor horizontal accelerations in buildings", Earthq. Eng. Struct. Dyn., 31, 693-718. https://doi.org/10.1002/eqe.149
  15. Singh, M.P. (1980), "Seismic design input for secondary systems", J. Struct. Div. ASCE, 106, 505-517.
  16. Sullivan, T.J. (2011), "An energy factor method for the displacement-based seismic design of RC wall structures", J. Earthq. Eng., 7(15), 1083-1116.
  17. Sullivan, T.J. (2013), "Highlighting differences between force-based and displacement-based design solutions for RC frame structures", Struct. Eng. Int., 23(2), 122-131. https://doi.org/10.2749/101686613X13439149156958
  18. Sullivan, T.J., Calvi, P.M. and Nascimbene, R. (2013), "Towards improved floor spectra estimates for seismic design", Earthq. Struct., 4(1), 109-132.. https://doi.org/10.12989/eas.2013.4.1.109
  19. Taghavi, S. and Miranda, E. (2006), "Seismic demand assessment on acceleration-sensitive building nonstructural components", Proceedings of the 8th National Conference on Earthquake Engineering, San Francisco, California, USA, April.
  20. Vanmarcke, E.H. (1977), "A simplified procedure for predicting amplified response spectra and equipment response", Proceeding of the 6th World Conference Earthquake Engineering III New Delhi, India, 3323-3327.
  21. Villaverde, R. (2004), "Seismic analysis and design of non-structural elements in Earthquake engineering from engineering seismology to performance-based design", (Eds) Y. Bozorgnia, V.V. Bertero, CRC Press, 19-48.
  22. Welch, D.P., Sullivan, T.J. and Calvi, G.M. (2014), "Developing direct displacement-based procedures for simplified loss assessment in performance-based earthquake engineering", J. Earthq. Eng., 18(2), 290-322 https://doi.org/10.1080/13632469.2013.851046
  23. Welch D.P., Sullivan T.J. and Filiatrault, A. (2014a), "Equivalent structural damping of drift-sensitive nonstructural building components", Proceedings of the 10th National Conference in Earthquake Engineering, Earthquake Engineering Research Institute, Anchorage, Alaska, USA, July.

피인용 문헌

  1. Simplified seismic performance assessment and implications for seismic design vol.13, pp.S1, 2014, https://doi.org/10.1007/s11803-014-0242-0
  2. Spectrum-to-spectrum methods for the generation of elastic floor acceleration spectra vol.199, 2017, https://doi.org/10.1016/j.proeng.2017.09.514
  3. Code-oriented floor acceleration spectra for building structures vol.15, pp.7, 2017, https://doi.org/10.1007/s10518-016-0076-4
  4. A method for the direct estimation of floor acceleration spectra for elastic and inelastic MDOF structures vol.45, pp.15, 2016, https://doi.org/10.1002/eqe.2779
  5. Seismic isolation of buildings using devices based on sliding between surfaces with variable friction coefficient vol.2, pp.1, 2017, https://doi.org/10.1007/s41062-017-0081-8
  6. Historical development of friction-based seismic isolation systems vol.106, 2018, https://doi.org/10.1016/j.soildyn.2017.12.003
  7. Seismic Isolation Devices Based on Sliding Between Surfaces with Variable Friction Coefficient vol.32, pp.4, 2016, https://doi.org/10.1193/091515EQS139M
  8. Using ambient vibration measurements to generate experimental floor response spectra and inter-story drift curves of Reinforced Concrete (RC) buildings vol.199, 2017, https://doi.org/10.1016/j.proeng.2017.09.163
  9. Floor Spectra of Inelastic RC Frame Buildings Considering Ground Motion Characteristics 2016, https://doi.org/10.1080/13632469.2016.1244134
  10. Performance-based seismic design of nonstructural building components: The next frontier of earthquake engineering vol.13, pp.S1, 2014, https://doi.org/10.1007/s11803-014-0238-9
  11. Performance-Based Seismic Design of Nonstructural Building Elements pp.1559-808X, 2021, https://doi.org/10.1080/13632469.2018.1512910
  12. Seismic performance of non-structural elements during the 2016 Central Italy earthquake pp.1573-1456, 2019, https://doi.org/10.1007/s10518-018-0361-5
  13. Seismic assessment of an industrial frame-tank system: development of fragility functions pp.1573-1456, 2019, https://doi.org/10.1007/s10518-018-00548-2
  14. Vulnerability assessment and seismic mitigation intervention for artistic assets: from theory to practice vol.167, pp.None, 2014, https://doi.org/10.1016/j.engstruct.2018.03.093
  15. Derivation of floor acceleration spectra for an industrial liquid tank supporting structure with braced frame systems vol.171, pp.None, 2018, https://doi.org/10.1016/j.engstruct.2018.05.053
  16. Conceptual seismic design in performance‐based earthquake engineering vol.48, pp.4, 2014, https://doi.org/10.1002/eqe.3141
  17. Evaluation of seismic design provisions for acceleration-sensitive non-structural components vol.16, pp.5, 2014, https://doi.org/10.12989/eas.2019.16.5.611
  18. Seismic demand and capacity assessment of suspended ceiling systems vol.193, pp.None, 2014, https://doi.org/10.1016/j.engstruct.2019.05.034
  19. Damping modification factor for elastic floor spectra vol.17, pp.11, 2014, https://doi.org/10.1007/s10518-019-00684-3
  20. Real-time seismic structural response prediction system based on support vector machine vol.18, pp.2, 2014, https://doi.org/10.12989/eas.2020.18.2.163
  21. Quantifying seismic risk in structures via simplified demand-intensity models vol.18, pp.5, 2014, https://doi.org/10.1007/s10518-019-00776-0
  22. Displacement-Based Simplified Seismic Loss Assessment of Masonry Buildings vol.24, pp.suppl1, 2014, https://doi.org/10.1080/13632469.2020.1755747
  23. Seismic Demand on Acceleration-Sensitive Nonstructural Components in Viscously Damped Braced Frames vol.146, pp.9, 2014, https://doi.org/10.1061/(asce)st.1943-541x.0002770
  24. A practice-oriented method for estimating elastic floor response spectra vol.53, pp.3, 2020, https://doi.org/10.5459/bnzsee.53.3.116-136
  25. Strength‐reduction factors for the design of light nonstructural elements in buildings vol.49, pp.13, 2014, https://doi.org/10.1002/eqe.3292
  26. Direct generation of floor design spectra (FDS) from uniform hazard spectra (UHS) - Part II: extension and application of the method vol.47, pp.12, 2014, https://doi.org/10.1139/cjce-2018-0151
  27. Seismic Acceleration and Displacement Demand Profiles of Non-Structural Elements in Hospital Buildings vol.10, pp.12, 2014, https://doi.org/10.3390/buildings10120243
  28. Towards Seismic Design of Nonstructural Elements: Italian Code-Compliant Acceleration Floor Response Spectra vol.2021, pp.None, 2014, https://doi.org/10.1155/2021/4762110
  29. Evaluation of the Floor Acceleration Amplification Demand of Instrumented Buildings vol.2021, pp.None, 2014, https://doi.org/10.1155/2021/7612101
  30. Analytical fragility curves for masonry school building portfolios in Nepal vol.19, pp.2, 2021, https://doi.org/10.1007/s10518-020-00989-8
  31. Earthquake-Induced Floor Accelerations in Base-Rocking Wall Buildings vol.25, pp.5, 2014, https://doi.org/10.1080/13632469.2018.1548393
  32. Integration of Modelling Approaches for the Seismic Assessment of Complex URM Buildings: The Podestà Palace in Mantua, Italy vol.11, pp.7, 2021, https://doi.org/10.3390/buildings11070269
  33. Seismic design of acceleration-sensitive non-structural elements in New Zealand: State-of-practice and recommended changes vol.54, pp.4, 2014, https://doi.org/10.5459/bnzsee.54.4.243-262
  34. Floor acceleration response spectra of elastic reinforced concrete frames vol.45, pp.None, 2022, https://doi.org/10.1016/j.jobe.2021.103558
  35. Seismic acceleration demand and fragility assessment of storage tanks installed in industrial steel moment-resisting frame structures vol.152, pp.None, 2014, https://doi.org/10.1016/j.soildyn.2021.107016
  36. Analysis of the Acceleration Response Spectra of Single-Layer Spherical Reticulated Shell Structures vol.12, pp.4, 2014, https://doi.org/10.3390/app12042116