DOI QR코드

DOI QR Code

Modeling of EMB (Electro Mechanical Brake) to Emulate Gearbox Fault and Control

기어의 고장을 구현하기 위한 EMB(Electro Mechanical Brake) 모델링 및 제어

  • Choe, Byung-Do (Department of Automotive Engineering, Graduate School, Hanyang University) ;
  • Hwang, Woo-Hyun (Department of Automotive Engineering, Graduate School, Hanyang University) ;
  • Huh, Kun-Soo (Department of Automotive Engineering, Hanyang University)
  • 최병도 (한양대학교 대학원 자동차공학과) ;
  • 황우현 (한양대학교 대학원 자동차공학과) ;
  • 허건수 (한양대학교 미래자동차공학과)
  • Received : 2011.08.08
  • Accepted : 2012.05.25
  • Published : 2012.11.01

Abstract

EMB is considered as the next generation braking mechanism because it has simple structure and is environment friendly. However, as other brake mechanisms, EMB should be operated reliably for any operating conditions. EMB should be designed with fail-safe and fault-tolerant control concepts which require robust fault detection algorithms for various possible faults. In the design of fault detection algorithms, it is very difficult to construct faulty conditions in real EMB and thus, simulations are often used to emulate the faulty conditions. In this paper, a simulation tool is developed using the commercial software to emulate gear faults in the EMB mechanism. A backlash compensation algorithm is introduced based on contact point detection because screw backlash causes a delay in clamping force response time.

Keywords

References

  1. N. A. Kelling and P. Leteinturier, "X-by-Wire: Opportunituies. Challenges and Trends," SAE 2003-01-0113, 2003.
  2. Strategic Analysis of European Markets for X-by-wire Systems, Frost & Sullivan, USA, 2007.
  3. P. Pillay and R. Krishnan, "Modeling, Simulation, and Analysis of Permanent-magnet Motor Drives, PartI: The Permanent-Magnet Synchronous Motor Drive," IEEE, Transactions on Industry Applications, Vol.25, No.25, pp.265-273, 1989. https://doi.org/10.1109/28.25541
  4. J. P. Hong, Core Machine Component Design, Bookshill, Seoul, pp.62-64, 2002.
  5. R. Schwarz, R. Isermann, J. Böhm, J. Nell and P. Rieth, "Modeling and Control of an Electromechanical Disk Brake," SAE 980600, 1998.
  6. C. Line, C. Manzie and M. C. Good, "Electromechanical Brake Modeling and Control: From PI to MPC," IEEE, Vol.16, No.3, pp.446-457, 2008.
  7. C. Jo, S. Hwang and H. Kim, "Clamping-force Control for Electromechanical Brake," IEEE, Vol.59, No.7, pp.3205-3212, 2010.
  8. R. Schwarz, R. Isermann, J. Böhm, J. Nell and P. Rieth, "Clamping Force Estimation for a Brake-by-Wire Actuator," SAE 1999-01-0482, 1999.