DOI QR코드

DOI QR Code

자동차 연료펌프용 BLDC 전동기구동의 센서리스 제어기법

Control Techniques of Sensorless BLDC Motor Drive for a Vehicle Fuel Pump Application

  • 투고 : 2011.08.08
  • 심사 : 2011.09.07
  • 발행 : 2011.10.01

초록

This paper suggests a control technique of the sensorless brushless DC (BLDC) motor drive for a vehicle fuel pump application. The sensorless technique based on a comparator and a potential start-up method with high starting torque are proposed. The comparator is used to generate the commutation signals in phase with the three-phase back-EMFs. The rotor position is aligned at standstill for maximum starting torque without an additional sensor and any information of motor parameters. Also, the stator current can be easily adjusted by modulating the pulse width of the switching devices during alignment. Some experiments are implemented on a single chip 16-bit DSP controller to demonstrate the feasibility of the sensorless techniques.

키워드

참고문헌

  1. J. Shao, "An Improved Microcontroller-Based Sensorless Brushless DC (BLDC) Motor Drive for Automotive Applications", IEEE Trans. on Ind. Appl., vol.42, no.5, pp.1216-1221. 2006. https://doi.org/10.1109/TIA.2006.880888
  2. S. Ogasawara and H. Akagi, "An Approach to Position Sensorless Drive for Brushless DC Motors", IEEE Trans. on Ind. Appl., vol.27, no.5, pp.928-933. Sept./Oct. 1991. https://doi.org/10.1109/28.90349
  3. N. Matsui, "Sensorless PM Brushless DC Motor Drives", IEEE Trans. on Industrial Electronics, vol.43, no.2, pp. 300-308, Apr. 1996. https://doi.org/10.1109/41.491354
  4. K. Y. Cheng and Y. Y. Tzou, "Design of a Sensorless Commutation IC for BLDC Motors", IEEE Trans. on Power Electronics, vol.18, no.6, pp.1365- 1375, Nov. 2003. https://doi.org/10.1109/TPEL.2003.818867
  5. R .C. Becerra, T. M. Jahns, and M.Ehsani, "Four- Quadrant Sensorless Brushless ECM Drive", in Proc. IEEE APEC'91 Conf., 1991, pp.202-209.
  6. T. M. Jahn, R. C. Becerra, and M. Ehsani, "Integrated Current Regulation for a Brushless ECM Drive", IEEE Trans. on Power Electronics, vol.6, no.1, pp.118-126, Jan. 1991. https://doi.org/10.1109/63.65010
  7. J. X. Shen, Z. Q. Zhu, and D. Howe, "Sensorless Flux-Weakening Control of Permanent-Magnet Brushless Machines Using Third-Harmonic Back- EMF", in Proc. IEEE IEMDC, May 2003, pp.1229-1235.
  8. M. Fraq and D. Ishak, "A New Scheme Sensorless Control of BLDC Motor Using Software PLL and Third Harmonic Back-EMF", IEEE ISIEA 2009, pp.861-865.
  9. N. Matsui, "Sensorless PM Brushless DC Motor Drives", IEEE Trans. on Industrial Electronics, vol.43, no.2, pp. 300-308, Apr. 1996. https://doi.org/10.1109/41.491354
  10. W. J .Lee and S. K. Sul, "A new starting method of BLDC motors without position sensor", IEEE Trans. on Ind. Appl., vol.42, no.6, pp.1532-1538, Nov./Dec. 2006. https://doi.org/10.1109/TIA.2006.882668
  11. G. H. Jang, J. H. Park, and J. H. Chang, "Position Detection and Start-up Algorithm of a Rotor in a Sensorless BLDC Motor Utiliting Inductance Variation", Electric Power Appl., IEEE Proc., vol.149, pp.137-142, Mar. 2002. https://doi.org/10.1049/ip-epa:20020022
  12. S. Nakashima, Y. Inagaki, and I. Miki, "Initial Rotor Position Estimation for Surface Permanent Synchronous Motor", IEEE Trans. on Ind. Appl., vol.36, pp.1598-1603, Nov./Dec. 2000. https://doi.org/10.1109/28.887211

피인용 문헌

  1. A Design of Programmable Low Pass Filter to Reduce the ZCP Estimation Error at High Speed BLDC Sensorless Drive vol.63, pp.1, 2014, https://doi.org/10.5370/KIEE.2014.63.1.035