The Transactions of The Korean Institute of Electrical Engineers (전기학회논문지)

The Korean Institute of Electrical Engineers (대한전기학회)
권호 표지
DOI QR코드

DOI QR Code

The Electronic Ballast Design of Acoustic Resonance Free and Transient Over Current Limit for High Power MHL

음향 공명 제거 및 과도 상태 전류를 제한시킨 고출력 메탈 헬라이드 램프용 전자식 안정기 설계

  • 김기남 (강원대학 전기.전자공학과) ;
  • 박종연 (강원대학 전기.전자공학과) ;
  • 최영민 (강원대학 전기.전자공학과)
  • Received : 2010.02.16
  • Accepted : 2010.04.15
  • Published : 2010.05.01
Download PDF
⟨ Previous Next ⟩

Abstract

This paper presents the design of acoustic resonance free and over current limit during transient state consideration electronic ballast for 1.5kW Metal-Halide Lamp(MHL) that employs frequency modulation (FM) technique. The proposed ballast consists of a Full-Bridge(FB) rectifier, a passive power factor correction (PFC) circuit, a full-bridge inverter, an ignitor using LC resonance and a control circuit for frequency modulation. The frequency modulation technique is the most effective solution to eliminate acoustic resonance among other technique. It spreads power spectrum of lamp to reduce the supplied power spectrum under the energy level of eigen-value frequency. Moreover, the proposed ballast is simple and cost effective above conventional ballast. A new PFC circuit is proposed which combines with LCD type and PCSR filter. A new PFC circuit has higher PF and lower THD than conventional LCD type and secure high reliability. Finally, to protected switching components in transient state, the surge current into ballast is limited by increase the switching frequency. Performance of the proposed ballast was validated through computer simulation using Pspice, experimentation and by applying it to an electronic ballast for a prototype 1.5kW MHL.

Keywords

References

  1. Rong Guo, Zhaoming Qian, "A Novel Low-Cost High-reliability Ignitor for Metal Halide Lamps", in Proc. IEEE APE'06, 2006, pp19-23.
  2. Chenyang Liu, Changsheng Hu, Zhongchao Zhang, "Analysis and Design of Ignitor for HID ballast", in Proc. IEEE IAS'05, 2005, bol.3 pp.1949-1953.
  3. C. Y. Park, G. H. Jo, D, Y, Jung,"The kind and Characteristic of Ballast", Journal of the KIPE, Vol.4, No.3, pp. 24-29, 1999, 6.
  4. K.N.Sakthivel, Sisir K.Das, K.R.Kini, "Importance of Quality AC Power Distribution and Understanding of EMC Standards IEC 61000-3-2, IEC 61000-3-3 & IEC 61000-3-11", Proceeding of INCEMIC, 2003
  5. R. Carbone, A.Scappatura, "A High Efficiency Passive Power Factor Corrector for Single-Phase Bridge Diode Rectifiers", IEEE. Ann. conf., pp, 1627-1630, 2004
  6. R. Carbone, P.Corsonello, "A New Passive Power Factor Correction for Single-Phase Bridge Diode Rectifiers", IEEE, 2003
  7. W.M.Lin, J.Sebastian, A.Fernandez, M.M.Hernando, P.J.Villegas, "Design of the Basic Rectifier with LC Filter to Comply with the New Edition of the IEC1000-3-2 Current Harmonics-Limit Specifications(Edition 2.0)", IEEE, 2002
  8. 박종연, 김기남, 이봉진, "음향 공명을 제거한 MHL용 고출력 전자식 안정기 설계", 대한 전기학회 논문지, 제 57권 7호, July, 2008
  9. Mangesh Borage, Sunil Tiwari and S.Kotaiah, "Passive Techniques for Compliance of Single-phase Rectifiers with IEC 1000-3-2 Norms", Processing of INCEMIC, 2003
  10. John Parry, "Variable Frequency Drive Using IR215x Self-Oscillating IC's", International Rectifier, Design Tip 98-1
  11. Shen, M., Qian, Z., Peng, F.Z., "A novel two-stage acoustic resonance free electronic ballast for HID lamps", Conf. Rec. IEEE-IAS Annual Meeting, pp.1869-1874, Oct, 2002
  12. Jianqiang Wang, Dianguo Xu, Hua Yang, "Design consideration of electronic ballast for MH lamps with frequency modulation", Power Elec. and Drive sys.PEDS 2003, vol.2, pp. 1543-1546, Nov, 2003
  13. Melis,J., Vila-Masot,O., "Low frequency square wave electronic ballast for gas discharge lamps", US Patent 5428268, 27 June, 1995
  14. Jianqiang Wang, Dianguo Xu, Hua Yang, "Low-frequency sine wave modulation of 250W high-frequency metal halide lamp ballasts" Applied Power Elec. Conf., APEC'04, Nineteenth Annual IEEE, Vol.2, pp.1003-1007, 2004
  15. Dalla Costa, M.A., Alonso, J.M., Garcia,J., Cardesin, J., Rico-Secades,M. "Acoustic Resonance Characterization of Low-Frequency Square-Waveform Operation", Power Elec., IEEE., Trans., Vol.22, Part Special Section on Lighting Application, pp.735-743, May, 2007
  16. Cheng, C.A, Liang, T.J., Lin, R.L., Chen, J.F., "Design and implementation of frequency-modulated electronic ballast for metal-halide lamps", Electric Power Appl., IEE Proc., Vol153, pp. 702-710, Sep, 2006 https://doi.org/10.1049/ip-epa:20060011
  17. Gulko, M., Ben-Yaakov, S., "A MHz Electronic ballast for automotive-type HID lamps", Proc. IEEE Conf., PESC, pp.39-45, June, 1997
  18. Ponce, M., Lopez, A., Correa, J., Arau, J., and Alonso,J.M., "Electronic ballast for HID lamps with high frequency square waveform to avoid acoustic resonance", Proc. IEEE Conf. APEC, pp.658-663, March, 2001
  19. Cheng, C.A, Liang, T.J., Lin, R.L., Chen, J.F.,"A high power factor electronic ballast of projector lamps with variable frequency control". Proc. IEEE Conf., PESC, pp.213-217, June, 2002
  20. 박종연, 김기남, 이봉진, "음향 공명 제거 및 조광 제어가 가능한 1kW 메탈 핼라이드 램프용 전자식 안정기 설계", 대한 전기학회 논문지, 제 57권 10호, Oct, 2008