초록
조립재료는 철도, 도로, 댐 등의 대형 지반구조물의 중요한 성토재료로 활용되고 있다. 따라서 이러한 조립재료에 대한 정확한 물성산정은 합리적인 설계와 시공을 위해 필수적이다. 하지만 대입경의 조립재료를 실험하기 위한 장비가 부족하여 이에 대한 연구가 매우 제한적이었다. 이에 본 연구에서는 직경 500mm, 300mm, 150mm 등의 공시체에 대한 실험이 기능한 대형삼축압축시험장비를 구축하였다. 본 장비에서는 로드셀을 삼축셀 안에 설치하고, 미소변형률 수준에서의 제어와 변위측정의 정확도를 높이기 위해 시편 중간 영역의 변형을 측정하였다. 본 장비의 동적물성실험 검증을 위해 같은 강성으로 직경 300mm와 50mm의 우레탄 5쌍을 제작하였다. 대형삼축압축시험장비를 이용해서는 직경 300mm의 대형 우레탄 시편에 대한 실험을 수행하였으며, 소형(직경 50mm) 우레탄 시편에 대한 RC/TS, 충격반향기법시험 등을 수행하였다. 시험 결과에서 본 장비의 합리적 시험 결과를 확인할 수 있었다.
Coarse granular material is used as important fill material in most of large embankments such as railway, road, dam and so on. Therefore, the accurate design parameters of the coarse granular material are necessarily required in design and construction. The behavior of the coarse granular material was not well understood because of the lack of large testing equipment capable of coarse granular material. A large triaxial testing system was developed in this research, capable of large specimens of 500 mm, 300 mm and 150 mm in diameter. In the new large triaxial testing system, the load cell is installed inside the triaxial cell and axial displacement is measured locally on a specimen in order to improve control and measurement in small strain level. Urethane specimens of 300 mm and 50 mm in diameter were prepared. The large triaxial tests were performed on the 300 mm diameter urethane specimens while RC/TS and impact echo tests on the 50 mm diameter urethane specimens to verify this testing system. In this verification test results, we could ascertain the reasonable test results of the KRRI large triaxial testing system.