A Study on Overvoltage Reduction Method of Single Point Bonded Section on Combined Transmission Lines

혼합송전선로 편단접지 구간 과전압 저감 방안에 관한 연구

  • Published : 2009.10.01

Abstract

This paper discusses the effects of ECC (Earth Continuity Conductor) for reducing the level of induced sheath overvoltages at the single point bonded section of combined transmission lines which are mixed underground power cable with overhead line in one T/L. In previous papers, the characteristics of ECC on only underground power cable systems were sufficiently analyzed. However, the result of only underground power cable systems are totally different from that of combined transmission lines because ECC is commonly grounded with overhead grounding wire at mesh of cable head. Therefore, in this paper, the installation effects of ECC have been variously analyzed considering the three kinds of fault positions, cable formation of duct and trefoil, spacing between phase conductor and ECC, and the change of overhead transmission line section length on 154kV combined transmission line. Finally, simulation results show that ECC can effectively reduce the induced sheath voltage.

Keywords

References

  1. 한국전력공사 송변전건설처, '지중송전 케이블 시스템', 2002. 12
  2. J. W. Kang, C. K. Jung, K. K. Choi, T. I. Jang, H. H. Yoon, 'A Study on Transient Analysis by Installation of Earth Continuity Conductor on Underground Power Cable Systems', 2008 ICEE Conference, July 2008
  3. C. K. Jung, J. W. Kang, 'Characteristics of Parallel Ground Continuity Conductor for Single Point Bonded Power Cable System', Submitting to IJEEPS (International Journal of Emerging Electric Power Systems)
  4. 정채균, 강지원, '지중송전선로 병행지선 최적 설치 방안에 관한 연구', 대한전기학회 논문지, Vol. 58, No.9, 2009. 9
  5. 강지원, 정채균, 윤형희, 윤종건, 김두진, 김재승, '지중송전계통 병행 지선 설치 방안 검토', 대한전기학회 하계학술대회 논문집, 2008. 7
  6. 강지원, 정채균, 박흥석, 장태인, 윤형희, '혼합송전계통에서 고장구간에 따른 병행지선 설치효과 검토', 대한전기학회 전력기술부문회 추계학술대회 논문집, 2008. 11
  7. IEEE, 'IEEE Guide for the Application of Sheath Bonding Methods for Single-conductor Cables and Calculation of induced Voltage and Current in Cable Sheaths', ANSI/IEEE Std. 575-1998
  8. CIGRE WG B1.18, 'Special Bonding of High Voltage Power Cables', Oct. 2005
  9. IEC 60364-5-54, 'Electrical installations of buildings - Part 5-54 : Selection and erection of electrical equipment Earthing arrangements, protective conductors and protective bonding conductors', June 2002
  10. 한국전력공사, '지중송전 설계기준(DS-6240) 케이블 접속', 1987. 8