Journal of the Korea Concrete Institute (콘크리트학회논문집)

Korea Concrete Institute (한국콘크리트학회)
권호 표지
DOI QR코드

DOI QR Code

Generalized Analysis of RC and PT Flat Plates Using Limit State Model

한계상태모델을 이용한 철근콘크리트와 포스트텐션 무량판의 통합해석

  • 강현구 (오클라호마대학교 건설환경공학부) ;
  • 나창순 (국민대학교 건축학부)
  • Published : 2009.10.31
Download PDF
⟨ Previous Next ⟩

Abstract

This paper discusses generalized modeling schemes for both reinforced concrete (RC) and post-tensioned (PT) flat plate buildings. In this modeling approach, nonlinear behavior due to slab flexure, moment and shear transfer at slab-column connections, and punching shear was included along with linear secant stiffness of each member or connection that accounts for concrete cracking. This generalized model was capable of simulating all different scenarios of slab-column connection failures such as brittle punching, flexure-shear interactive failure, and flexural failure followed by drift-induced punching. Furthermore, automatic detection of drift-induced punching shear and subsequent backbone curve modifications were realistically modelled by incorporating the limit state model, in which gravity shear versus drift capacity relations were adopted. The validation of the model was conducted using one-third scale two-story by two-bay RC and PT flat plate frames. The comparisons revealed that the model was robust and effective.

2층 규모의 철근콘트리트조 및 포스트텐션조 무량판구조를 1/3 스케일로 축소하여 제작한 실험체의 진동대 실험 결과를 바탕으로 무량판구조의 모델링 기법을 향상하고자 하는 연구를 수행하였다. 이 연구에서 적용한 모델링 방법은 슬래브의 휨모멘트에 의한 휨파괴, 불균형모멘트의 전달에 의한 휨파괴 및 펀칭전단파괴에 의한 슬래브-기둥 접합부의 모멘트 전달능력 상실등의 영향을 반영하는 매우 포괄적인 구조해석 방식이다. 펀칭전단파괴에 대해서는 중력비와 층간변위각에 기초한 한계상태 모델이 적용되었다. 이 논문에서 제안된 비선형 모델은 무량판구조의 진동대 실험 결과와 잘 부합하는 것으로 나타났다.

Keywords

References

  1. Yuyama, S., Okamoto, T., and Nagataki, S., "Acoustic Emission Evaluation of Structural Integrity in Repaired Reinforced Concrete Beams," Materials valuation, Vol. 52, No. 1, 1994, pp. 86-90
  2. ACI Committee 318, "Building Code Requirements for Reinforced Concrete (ACI 318-08)," American Concrete Institute, Farmington Hills, Mich., 2008, 465 pp
  3. Aschheim, M. and Moehle, J. P.,"Four-Story Flat-Slab Building in Sherman Oaks," Preliminary Building Report to ATC-33 Case Study, Berkeley, Calif., 1995
  4. Dovich, L. and Wight, J. K., "Lateral Response of Non seismically Detailed Reinforced Concrete Flat Slab Structures," Report No. 400/U423/94-30, University of Michigan, Ann Arbor, Mich., 1994, 183 pp
  5. Hueste, M. B. D. and Wight, J. K., 'Nonlinear Punching Shear Failure Model for Interior Slab-Column Connections," Journal of Structural Engineering, ASCE, Vol. 125, No. 9, Sept. 1999, pp. 997-1008 https://doi.org/10.1061/(ASCE)0733-9445(1999)125:9(997)
  6. FEMA 356, "Pre-standard and Commentary for the Seismic Rehabilitation of Buildings (FEMA 356)," Federal Emergency Management Agency, 2000, Washington, DC, 518 pp
  7. Elwood, K. J., "Shake Table Tests and Analytical Studies on the Gravity Load Collapse of Reinforced Concrete Frames," Ph.D Dissertation, University of California, Berkely, Calif., 2002, 419 pp
  8. Kang, T. H.-K. and Wallace, J. W., "Punching of Reinforced and Post-Tensioned Concrete Slab-Column Connections," ACI Structural Journal, Vol. 103, No. 4, 2006, pp. 531-540
  9. Kang, T. H.-K. and Wallace, J., W., "Dynamic Responses of Flat Plate Systems with Shear Reinforcement," ACI Structural Journal, Vol. 102, No. 5, 2005, pp. 763-773
  10. Kang, T. H.-K. and Wallace, J. W., "Stresses in Unbonded Tendons of Post-Tensioned Flat Plate Systems under Dynamic Excitation," Journal of the Post-Tensioning Institute, Vol. 6, No. 1, 2008, pp. 45-59
  11. Spacone, E., Filippou, F. C., and Taucer, F. F., "Fiber Beam-Column Model for Nonlinear Analysis of R/C Frames: Part I. Formulation," Earthquake Engineering and Structural Dynamics, Vol. 25, No. 7, 1996, pp. 711-725 https://doi.org/10.1002/(SICI)1096-9845(199607)25:7<711::AID-EQE576>3.0.CO;2-9
  12. Pecknold, D. A., "Slab Effective Width for Equivalent Frame Analysis," ACI Journal, Vol. 72, No. 4, 1975, pp. 135-137
  13. McKenna, F. and Fenves, G., "The OpenSees Command Language Manual: version 1.2," Pacific Earthquake Engineering Research Center, , University of California, Berkeley, Calif., 2001
  14. FEMA 274, "Commentary on the Guidelines for the Seismic Rehabilitation of Buildings (FEMA 274)," Federal Emergency Management Agency, Washington, DC, 1997, 488 pp
  15. Kang, T. H.-K., LaFave, J. M., Robertson, I. N., and Hawkins, N. M., "Recommendations for Design of Post-Tensioned Slab-Column Connections Subjected to Lateral Loading," Journal of the Post-Tensioning Institute, Vol. 6, No. 1, 2008, pp. 45-59
  16. Robertson, I. N. and Johnson, G., "Cyclic Lateral Testing of Nonductile Slab-Column Connections," ACI Structural Journal, Vol. 103, No. 3, 2006, pp. 356-364

Cited by

  1. Nonlinear Dynamic Analysis of RC Frames Based on Constitutive Models of Constituent Materials vol.17, pp.4, 2013, https://doi.org/10.11112/jksmi.2013.17.4.001