Effects of Machining Conditions for Improvement of Surface Roughness on Micro End-Milling

마이크로 엔드밀 가공시 가공인자가 표면거칠기 향상에 미치는 영향

  • 조병무 (충남대학교 대학원 기계공학과) ;
  • 김상진 (충남대학교 BK21 메카트로닉스사업단) ;
  • 박희상 (한양대학교 대학원 기계설계학과) ;
  • 배명일 (충남대학교 기계.기계설계.메카트로닉스공학부)
  • Published : 2008.04.15

Abstract

Micro end-milling is one of effective technology that is able to do ultra-precision machining while increasing the productivity and has wide application field. But selection of machining condition is very difficult because of complicated machining mechanism. Therefore this study was carried out to select working factors to get the optimum surface roughness. Machining condition are depth of cut, feed rate and spindle revolution. The result of this study showed that Surface roughness was affected, in the other of depth of cut, spindle revolution, feed rate. And this study provided an regression equation relating surface roughness to working factors through Regression Analysis and determination coefficient of regression equation had a satisfactory reliability of 79%.

Keywords

References

  1. Min, S. K., Lee, S. W., Lee, D. J., Lee, E. S., Je, T. J., and Choi, D. S., 2001, "A Study in the Machining Characteristics for Micro Barrier Ribs By using Micro Endmilling," Proceedings of the KSMTE Autumn Conference, pp. 26-31
  2. Nakamura, S., 1996, "High-speed Spindles for Machine Tools," Int. J. Japan Soc. Prec. Eng., Vol. 30, No. 4, pp. 291-294
  3. Elbestawi, M. A., Ismail, F. K., and Yuen, M., 1994, "Surface Topography Characterization in Finish Milling," Int. J. of Machine Tools & Manufacture, Vol. 34, No, 2, pp. 245-255 https://doi.org/10.1016/0890-6955(94)90104-X
  4. Lim, P., Jang, D. K., Lee, H. K., and Yang, G. E., 2004, "High Speed Machining of Cavity Pattern in Prehardened Mold Using the Small Size Tools," Journal of KSPE, Vol. 21, No. 1, pp. 133-139
  5. Park, S., 1998, "Experimental Design and Applications," Youngji Press, Republic of Korea, pp. 93-225
  6. Lee, S. H. and Lee, S. H., 2001, "Optimization of Experimental Parameters for Burr Minimization," Journal of KSPE, Vol. 18, No. 12, pp. 130-136
  7. Chung, W. J., Cho, Y. D., Lee, C. M., Jung, D. W., and Song, T. J., 2006, "A Study on the Reduction of Unclamping Time by Design of Experiments," Transactions of KSMTE, Vol. 15, No. 3, pp. 1-7
  8. Shim, S. C., Jang, S. M., Maeng, M. J., and Chung, J. K., 2004, "The Cutting Characteristics of Rotary Tools Using Regression Analysis," Proceedings of the KSMTE Spring Conference, pp. 105-110