References
- Selden, R., 2000, “Thin Wall Molding of Engineering Plastics. a Literature Survey,” J. Injection Molding Tech., Vol. 4, pp.159-166
- Jim, F., 1995, “Thin Wall Molding Differences in Processing over Standard Injection Molding,” SPEANTEC, Vol. 41, pp. 430-433
- Kim, B. H. and Suh, N. P., 1986, “Low Thermal Inertia Molding,,” Polym. Plast. Technol. Eng., Vol. 25, pp. 73-93 https://doi.org/10.1080/03602558608070076
- Jansen, K. M. B. and Flaman, A. A. M., 1994, “Construction of Fast-Response Heating Elements for Injection Molding Applications,” Polym. Eng. Sci., Vol. 34, pp. 894-897 https://doi.org/10.1002/pen.760341105
- Yao, D. and Kim, B., 2002, “Increasing Flow Length in Thin Wall Injection Molding Using a Rapidly Heated Mold,” Polym. Plast. Technol. Eng., Vol. 415, pp. 819-832 https://doi.org/10.1081/PPT-120014390
- Park, K., Kim, B. and Yao, D., 2006, “Numerical Simulation for Injection Molding with a Rapidly Heated Mold, Part I: Flow Simulation for Thin Wall Parts,” Polym. Plast. Technol. Engng. Vol. 45, pp. 897-902 https://doi.org/10.1080/03602550600718142
- Chen, S. C., Peng, H. S., Chang, W. R. and Jong, W. R., 2004, “Simulations and Verifications of Induction Heating on a Mold Plate,” Int. Comm. Heat Mass Transfer, Vol. 31, pp. 971-980 https://doi.org/10.1016/j.icheatmasstransfer.2004.05.007
- Chang, J. A., Chen, S. C. and Cin, J. C., 2006, “Rapid Mold Temperature Control on Micro-Injection Molded Parts with High Aspect Ratio Micro-Features,” SPEANTEC, Vol. 52, pp. 1275-1279
- Park, K., Hwang, J. J., Kwon, O. K. and Yun, J. H., 2007, “Finite Element Analysis of Induction Heating Process for Development of Rapid Mold Heating System,” Trans. Mat. Proc., Vol. 16, pp. 113-119 https://doi.org/10.5228/KSPP.2007.16.2.113
- Kwon, O. K., Jeong, H. T., Yun, J. H. and Park, K., 2007, “A Study of Rapid Mold Heating System Using High-Frequency Induction Heating,” Trans. J. Kor. Soc. Mech. Engng. (A), Vol. 31, pp. 594-600 https://doi.org/10.3795/KSME-A.2007.31.5.594
Cited by
- Temperature Dependence and Magnetic Properties of Injection Molding Tool Materials Used in Induction Heating vol.51, pp.9, 2015, https://doi.org/10.1109/TMAG.2015.2428215
- Three-dimensional numerical modeling of an induction heated injection molding tool with flow visualization vol.85, pp.1-4, 2016, https://doi.org/10.1007/s00170-015-7955-8