A Strength Analysis of Rack and Pinion of Steering Gear Assay using a Commercial Finite Element Program

상용 유한 요소 프로그램을 이용한 차량 조향 장치의 랙과 피니언의 강도 해석

  • Published : 2008.11.01

Abstract

In general, the strength of gears is calculated using the formula of AGMA or JGMA. But these formula can not be applied directly to the strength calculation of the rack and pinion of steering gear assay, because of complex tooth and contact shapes. So Lewis bending stress and Hertzian contact stress formula are generally used for the design of rack and pinion of steering gear assay. But these formula do not also give the exact stress of rack and pinion. In this paper, comparing the finite element analysis results and the experimentally measured values, it is shown that the finite element modeling technique of the rack and pinion of steering assay is reasonable.

Keywords

References

  1. D. W. Dudley, Handbook of Practical Gear Design, CRC Press, Chapter 2.7, 1994
  2. E. S. Lee, W. S. Yoon, J. M. Lee and D. J. Jung "A Study on Development of The Torque Sensor for a Electric Power Steering (EPS)," Spring Conference Proceedings, KSAE, p.559, 2004
  3. E. Zahavi, The Finite Element Method Machine Design, Prentice Hall, New Jersey, pp.229-235, 1992
  4. D. Looman, "Ansys Advantage," Vol.1, No.2, pp.34-36, 2007
  5. R. L. Norton, Machine Design, Prentice Hall, 2nd Edn, New Jersey, p.629, 2000
  6. C. S. Sim, Steering System, Mando Corporation, pp.61-64, 2003