DOI QR코드

DOI QR Code

Improvements to the analysis of floorbeams with additional web cutouts for orthotropic plated decks with closed continuous ribs

  • 투고 : 2005.12.01
  • 심사 : 2006.07.14
  • 발행 : 2007.02.25

초록

Additional cutouts in the floorbeam webs of orthotropic plated bridge decks relieve the highly stressed lower flange of the ribs passing through these floorbeam webs from possible fatigue damage. Conversely, the floorbeam webs themselves suffer from high stress concentrations, especially along the free edges of the additional cutouts. These stresses result from a combination of direct introduction of vertical traffic loads in the weakened web and from the truss action of the floorbeam. The latter differs from a simple beam action due to the presence of the openings and corresponds more to the behaviour of a Vierendeel truss. Close assessment of the appearing stresses, highly relevant for fatigue resistance, requires the use of elaborate finite element modelling. However, a full finite element analysis merely provides the results of total stresses, leaving the researcher or designer the difficult task of finding the origin of these stress components. This paper presents a calculation method for cutout stresses based on a combination of a framework analysis and a two dimensional finite element analysis of much smaller parts of the floorbeam. This method provides more insight in the origin of the stress components, as well as it simplifies any comparison of different additional cutout geometries, independent of the floorbeam topology.

키워드

참고문헌

  1. Beales, C. (1990),"Assessment of trough to crossbeam connections in orthotropic steel bridge decks", TRRL Research Report 276, Crowthorne, UK.
  2. Bruls, A. (1995),"Common synthesis report : measurements and interpretation of dynamic loads on bridges, Phase 4 : fatigue strength of steel bridges", ECSC, Brussels, Belgium.
  3. De Corte, W. and Van Bogaert, Ph. (2000),"Assessment of cross beam fatigue in orthotropic plated bridge decks by measurement-complying influence lines", Proc. of the Int. Conf. on Steel Structures of the 2000's, Istanbul, Turkey, September.
  4. De Corte, W. and Van Bogaert, Ph. (2002),"Fatigue assessment of orthotropic bridge crossbeams : a combined framework - F.E. approach", Eurosteel 2002, Coimbra, Portugal, September.
  5. De Corte, W., Van Bogaert, Ph., De Backer, H. and De Pauw, B. (2004),"Orthotropic plated bridge deck analysis : A road railway comparison", Proc. of the 10th Nordic Steel Conference, Copenhagen, Denmark, June.
  6. De Corte, W. (2004),"Assessment of fatigue strength of steel orthotropic plated bridge decks from continuous measured stress spectra", Proc. of the 1st Orthotropic Bridge Conference, Sacramento, CA, United States, August.
  7. De Corte, W. and Van Bogaert, Ph. (2004),"Fatigue strength verification of a steel orthotropic plated bridge deck for railway traffic", Proc. of the 1st Orthotropic Bridge Conference, Sacramento CA, United States, August.
  8. De Corte, W., Van Bogaert, Ph., De Backer, H. and De Pauw, B. (2004),"Verification of local and global action of a tied arch railway bridge with orthotropic deck during consecutive test phases", Arch '04, Barcelona, Spain, November.
  9. De Corte, W. (2005),"Fatigue of steel orthotropic plated bridge decks subject to traffic loads", Ph Thesis, Academia Press, Ghent, 2005 (in Dutch).
  10. De Corte, W. and Van Bogaert, Ph. (2006),"The effect on the moment distribution in orthotropic plated decks of shear deformation in floor beams : an addition to the Pelikan -Esslinger method", J. Constr. Steel Res., to be published.
  11. Dexter, R. and Fisher, J. (1995),"Fatigue cracking of orthotropic steel decks", Proc. of the Nordic Steel Conference 1995, Malmo, Sweden.
  12. Haibach, E. and Plasil, I. (1983),"Untersuchungen zur Betriebsfestigkeit von Stahlleichtfahrbahnen mit Trapezhohl-steifen im Eisenbahnbruckenbau", Der Stahlbau, 9/83, 269-274.
  13. Lehrke, H. (1989), Messung und Interpretation von dynamischen Lasten an Stahlbrucken. Phase 3 : Schwingungsfestigkeitsverhalten von orthotropen Platten in Stahlstrassenbrucken, Fraunhofer-Institut fur Betriebsfestigkeit, Darmstadt, Germany.
  14. Pelikan, W. and Esslinger, M. (1957), Die Stahlfahrbahn - Berechnung und Konstruktion, M.A.N. Forschungsheft, No7.
  15. Troitsky, M.S. (1968), Orthotropic Bridges: Theory and Design, 2nd Printing, Cleveland, Ohio.
  16. Van Bogaert, Ph. and De Corte, W. (2001),"Influence of crossbeam topology on the stress distribution in closed stiffener orthotropic bridge decks", Proc. of the First Int. Conf on Steel & Composite Structures, Pusan, Korea.
  17. Wolchuk, R. (1963), Design Manual for Orthotropic Steel Plate Deck Bridges, AISC.
  18. Wolchuk, R. (1992),"Secondary stresses in closed orthotropic deck ribs at floor beams", J. Struct. Eng., 118(2), 582-595. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:2(582)

피인용 문헌

  1. Transient and Long-Term Changes in Seismic Response of the Natural Resources Building, Olympia, Washington, due to Earthquake Shaking vol.16, pp.5, 2012, https://doi.org/10.1080/13632469.2012.655060
  2. Fracture behavior analyses of welded beam-to-column connections based on elastic and inelastic fracture mechanics vol.10, pp.3, 2010, https://doi.org/10.1007/BF03215835
  3. Parametric study of floorbeam cutouts for orthotropic bridge decks to determine shape factors vol.5, pp.2-3, 2009, https://doi.org/10.1080/15732480903142518
  4. Rehabilitation of Steel Moment Connections with Cover Plates under Initial Loading vol.14, pp.5, 2011, https://doi.org/10.1260/1369-4332.14.5.789
  5. Experimental study on fatigue failure of rib-to-deck welded connections in orthotropic steel bridge decks vol.103, 2017, https://doi.org/10.1016/j.ijfatigue.2017.05.021
  6. An Evaluation of the Use of Fracture Mechanics Techniques for the Design of Orthotropic Decks vol.348-349, pp.1662-9795, 2007, https://doi.org/10.4028/www.scientific.net/KEM.348-349.285
  7. Floor-Beam Web Cutout Shape Analysis to Improve the Fatigue Resistance in Orthotropic Steel Bridge Decks vol.452-453, pp.1662-9795, 2010, https://doi.org/10.4028/www.scientific.net/KEM.452-453.161
  8. Influence of Finite Element Modeling Choices in the Assessment of Stress Concentrations at Fatigue Prone Locations in Orthotropic Bridge Decks vol.525-526, pp.1662-9795, 2012, https://doi.org/10.4028/www.scientific.net/KEM.525-526.37
  9. Review of FE-Based Fatigue Evaluation Methods for the Rib to Floorbeam Welds in Orthotropic Bridge Decks vol.627, pp.1662-9795, 2014, https://doi.org/10.4028/www.scientific.net/KEM.627.337
  10. Orthotropic Analysis of Steel Deck–Girder–Rib Systems Subjected to Transverse Load pp.2093-6311, 2018, https://doi.org/10.1007/s13296-018-0180-1
  11. Fatigue study on additional cutout between U shaped rib and floorbeam in orthotropic bridge deck vol.28, pp.3, 2007, https://doi.org/10.12989/scs.2018.28.3.319
  12. Parametric Optimization of Orthotropic Girders in a Cable-Supported Bridge vol.24, pp.12, 2019, https://doi.org/10.1061/(asce)be.1943-5592.0001499
  13. Fatigue property analysis of U rib-to-crossbeam connections under heavy traffic vehicle load considering in-plane shear stress vol.38, pp.3, 2007, https://doi.org/10.12989/scs.2021.38.3.271