한국구조물진단유지관리공학회 논문집 (Journal of the Korea institute for structural maintenance and inspection)

  • 제11권5호
  • /
  • Pages.144-152
  • /
  • 2007
  • /
  • 2234-6937(pISSN)
  • /
  • 2287-6979(eISSN)
한국구조물진단유지관리공학회 (Korea Institute for Structural Maintenance Inspection)
권호 표지
DOI QR코드

DOI QR Code

아라미드섬유쉬트로 휨 보강된 RC보의 부착파괴 방지에 관한 실험적 연구

An Experimental Study to Prevent Debonding Failure of RC Beams Strengthened by AFRP Sheet

  • 투고 : 2006.09.05
  • 발행 : 2007.09.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

본 연구에서는 아라미드섬유쉬트로 휨 보강된 RC 보의 파괴양상을 분석하고, 부착파괴를 방지하기 위한 실험연구를 수행하였다. 아라미드섬유쉬트의 부착파괴 방지상세에 대한 효과를 검증하기 위하여 총 5개의 실험체를 제작 실험하였다. 분석결과에 의하면 기존에 사용되어온 단순부착식이나 단부 U보강상세를 적용한 실험체는 아라미드섬유쉬트의 재료변형률보다 낮은 변형률에서 부착파괴되는 것으로 나타났다. 반면 본 연구에서 제안한 중앙부 U보강상세와 에폭시 전단키를 적용한 실험체는 아라미드섬유쉬트의 부착파괴를 억제함으로써 충분한 보강성능을 발휘하는 것으로 나타났다.

This study investigated the failure mechanism of RC beams strengthened with AFRP sheets. Total 5 half-scale RC beams were constructed and tested to estimate the effectiveness of various methods to prevent the debonding failure of AFRP sheets. From the experimental results, it was found that increasing bonded length or end U-wrappings does not prevent debonding failure. On the other hand, the beams with center U-wrappings and shear-keys reached the ultimate state with their sufficient performance. The center U-wrappings tended to control debonding of the longitudinal AFRP sheets because the growth of the longitudinal cracks along the edges of the composites was delayed. In case of shear-keys, it was sufficient to eliminate debonding and the beams failed by AFRP sheets rupture due to the sufficient bond mechanism.

키워드

참고문헌

  1. (주)한국화이바/한국카본, 탄소섬유시트 공법 기술자료(II), 해림, 1998, pp. 52.
  2. 최기선, 유영찬, 이진용, 김긍환, "유리섬유쉬트로 휨보강된 RC 보의 부착파괴 방지상세 관한 실험적 연구" 봄학술발표회논문집, 한국콘크리트학회, 제15권 1호, 2003, pp. 531-536.
  3. 건설교통부, 한국건설기술연구원, "철근콘크리트 건축구조물 보수.보강 공법의 성능평가에 관한 연구", 건설교통부 연구과제, 2003.
  4. 유영찬, 최기선, 김긍환, "An Experimental Study to Prevent Debonding Failure of Full-Scale RC Beam Strengthened with Multi-Layer CFS", 콘크리트학회논문집, 한국콘크리트학회, 제16 권 6호, 2004, pp. 867-874. https://doi.org/10.4334/JKCI.2004.16.6.867
  5. 土木學會コンクリト委員會,コンクリト構造物の補强指針(案), 土木學會, 1999, pp. 94.
  6. 日本土木學會 "連續纖維シ〡トを用いたコンクリト構造物の補修補强指針".
  7. CEB-FIP, "Externally bonded FRP reinforcement for RC structures", Trechnical report, bulletin 14, March 2001.
  8. H.Saadatmanesh et al, "Design guidelines for flexural strengthening of RC beams with FRP plates" Journal of Composite for Construction, Nov. 1998, pp. 158-164.
  9. Y. N. Ziraba, et al, "Guidelines toward the design of reinforced concrete beams with external plates" ACI Structural Journal Nov-Dec. 1994. pp. 639-646.
  10. Sergio F. Breña, et al, "Effect of Carbon Fiber Reinforced Polymer Laminate Configuration on the Behavior of Strengthened Reinforced Concrete Beams" Journal of Composite for Construction, May-June 2004, pp. 229-240.
  11. Wendel M. Sebastian, "Signigicance of midspan debonding failure in FRP-plated concrete beams", Journal of Structural Engineering, July 2001, pp. 792-798.
  12. Christopher K. Y. Leung, et al, "Empirical Approach for Determining Ultimate FRP Strain in FRP-Strengthened Concrete Beams" Journal of Composite for Construction, March-April 2006, pp. 125-138.
  13. Hota V. S. GangaRao, P. V. Vijay., "Bending Behavior of Concrete Beams Wrapped with Carbon Fabric" Journal of Structural Engineering, ASCE, Jan 1998, pp. 3-10.
  14. Hamid Rahimi, Allan Hutchinson, "Concrete beams strengthened with externally bonded FRP plates" Journal of Composites for Construction, ASCE, Feb 2001, pp. 44-56.
  15. ISIS CANADA "Strengthening Reinforced Concrete Structures with Externally Bonded Fibre Reinforced Polymer" Design Manual.
  16. L. C. Hollaway, M. B. Leeming, "Strengthening of reinforced concrete structures", WOODHEAD Publishing Ltd. 2000, pp. 94.
  17. ACI 440. 2R-02 "Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures", ACI Committee 440.
  18. Concrete Society Technical Report No. 55, "Design guidance for Strengthening concrete structures using fibre composite materials", The Concrete Society.
  19. G.Spadea, F.Bencardino, R.N.Swamy, "Structural behavior of composite RC beams with externally bonded CFRP" Journal of Composites for Construction, ASCE, Aug 1998, pp. 132-137.
  20. Marco Arduini, Angelo Di Tommaso, Antonio Nanni, "Brittle failure in FRP plate and sheet bonded beams" ACI Structural Journal, Jul-Aug 1997, pp. 363-370.
  21. Alfarabi Sharif, G.J.Al-Sulaimani, I.A. Basunbul, M. H. Baluch, B. N. Ghaleb, "Streng-thening of initially loaded reinforced concrete beams using FRP plates" ACI Structural Journal, Mar-April 1994, pp. 160-168.
  22. Anthony J. Lamanna, Lawrence C. Bank, David W. Scott, "Flexural Strengthening of Reinforced Concrete Beams by Mechanically Attaching Fiber-Reinforced Polymer Strips" Journal of Composites for Construction, ASCE, May-Jun 2004, pp. 203-210.
  23. CSA Standard, "Design and Construction of Building Components with Fibre-Reinforced Polymers", S806-02, Canadial Standards Association.