Abstract
This paper deals with implementation of network for distributed control system of a humanoid robot ISHURO(Inha Semyung Humanoid Robot). A humanoid robot needs much degree of freedom structurally and much data for having flexible movement. To realize such a humanoid robot, distributed control method is preferred to the centralized one since it gives a compactness, modularity and flexibility for the controllers. For organizing distributed control system of a humanoid robot, a control processor on a board is needed to individually control the joint motor and communication technology between the processors is required to transmit its information within control time. The processor is DSP-based processor and includes CAN network on a chip. It shares the computational load such as monitoring the sensor information and controlling the actuator between each of modules. In this paper, the communication architecture is suggested and its message protocol are discussed including message structure, time consumption for transmission, and controller structure at the view of distributed control for a humanoid robot. All of the sequence are simulated with Matlab and then verified with real walking experiment by ISHURO.
본 논문은 휴머노이드 로봇 ISHURO의 분산 제어를 위한 네트웍 구현에 대해 다루고 있다. 일반적으로 휴머노이드형 로봇은 기구학적으로 유연한 동작을 위해 다수의 자유도가 필요하다. 이를 구현하기 위해서는 중앙에서 일괄적으로 처리 하는 것 보다 간결 하면서도 유연성을 줄 수 있는 분산 처리 방법이 선호되고 있다. 분산 처리를 위한 제어기를 구성할 때는 로봇의 모터를 독립적으로 제어하기 위한 제어기가 별도로 필요하며 모듈 간에는 정해진 시간 내에 데이터를 교환할 수 있는 통신 기법이 필요하다. ISHURO의 각 관절은 자체 내에 독립된 DSP를 내장하고 있으며 CAN 네트웍을 이용하여 모듈간의 통신을 하여 구동기를 재어하거나 센서의 값을 모니터링 할 수 있게 되어 있다. 본 논문에서는 이를 위한 통신 구조를 제안하고 필요한 전송 메시지를 정의하고, 전송시간을 분석하여 로봇 분산 제어기 구조에 적절한 전송 프로토콜을 제시하였다. 모든 과정은 Matlab을 이용하여 컴퓨터모의실험을 수행하였고 실제 휴머노이드 로봇에 적용하여 보행실험을 통해 검증 하였다.