Abstract
The purpose of this study was to evaluate the effect of multiple application of all-in-one dentin adhesive system on microtensile bond strength to caries-affected dentin. Twenty one extracted human molars with occlusal caries extending into mid-dentin were prepared by grinding the occlusal surface flat. The carious lesions were excavated with the aid of caries detector dye. The following adhesives were applied to caries-affected dentin according to manufacturer's directions; $Scotchbond^{TM}$ Multi-Purpose in SM group, Adper Prompt $L-Pop^{TM}$ 1 coat in LP1 group, 2 coats in LP2 group, 3 coats in LP3 group, $Xeno^{(R)}$ III 1 coat in XN1 group, 2 coats in XN2 group. and 3 coats in XN3 group. After application of the adhesives, a cylinder of resin-based composite was built up on the occlusal surface. Each tooth was sectioned vertically to obtain the $1{\times}1\;mm^2$ sticks. The microtensile bond strength was determined. Each specimen was observed under SEM to examine the failure mode. Data were analyzed with one-way ANOVA. The results of this study were as follows; 1. The microtensile bond strength values were; SM ($14.38{\pm}2.01$ MPa), LP1 ($9.15{\pm}1.81$ MPa), LP2(14.08{\pm}1.75$ MPa), LP3 ($14.06{\pm}1.45$ MPa). XN1 (13.65{\pm}1.95$ MPa). XN2 ($13.98{\pm}1.60$) MPa, XN3 ($13.88{\pm}1.66$) MPa, LP1 was significantly lower than the other groups in bond strength (p < 0.05). All groups except LP1 were not significantly different in bond strength (p > 0.05). 2. In LP1, there were a higher number of specimens showing adhesive failure. Most specimens of all groups except LP1 showed mixed failure.
이 연구의 목적은 all-in-one adhesive인 Adper Prompt $L-Pop^{TM}$과 $Xeno^{(R)}$ III를 우식이환 상아질에 다층 적용했을 때의 효과를 미세인장결합강도의 측정과 주사전자현미경을 이용한 파절양상의 관찰을 통해 알아보는데 있다. 교합면 우식이 있는 21개의 치아에서 편평한 상아질 면이 노출되도록 하여 감염 상아질을 제거한 후 3개씩 7개의 군으로 분류하였다. SM 군은 $Scotchbond^{TM}$ Multi-purpose를 적용하였다. LP1 군, LP2 군, LP3 군은 Adper Prompt $L-Pop^{TM}$을 각각 단층, 2층, 3층으로 적용하였다. XN1 군, XN2 군, XN3 군은 Xeno^{(R)}$ III를 각각 단층, 2층. 3층으로 적용하였다. 각각의 상아질 접착제 처리 후, 광중합레진인 $Filtex^{TM}$ Z-250을 10mm 높이로 적층 충전하였다. 각 치아는 가로와 세로의 길이가 각각 1 mm인 막대 모양의 절편이 되도록 수직으로 절단하였다. 그 후 미세인장결합강도를 측정하였다. 측정 후 파절된 시편을 주사전자현미경을 이용하여 파절양상을 살펴보았다. 각 군의 미세인장결합강도를 one-way ANOVA와 $95\%$ 신뢰도의 Scheffe's Test를 이용하여 분석하였다. 이 연구의 결과는 다음과 같다. 1. 미세인장결합강도를 측정한 결과, SM 군은 14.38{\pm}2.01$ MPa, LP1군, LP2 군, LP3 군은 각각 $9.15{\pm}1.81$ MPa, $14.08{\pm}1.75$ MPa, $14.06{\pm}1.45$ MPa로 측정되었고, XN1 군, XN2 군, XN3 군은 각각 $13.65{\pm}1.95$ MPa, $13.98{\pm}1.60$ MPa, $13.88{\pm}1.66$ MPA로 측정되었다. LP1 군은 다른 모든 군에 비해 낮은 미세인장결합강도를 나타내었고 (p < 0.05). LP1 군을 제외한 다른 모든 군 사이에는 유의한 차이가 없었다 (p > 0.05). 2. 파절양상을 관찰한 결과, LP1 군에서는 접착성 파절이 우세하게 나타났고, LP1 군을 제외한 다른 모든 군에서는 혼합형 파절이 주로 일어났다.