DOI QR코드

DOI QR Code

Formation of nickel oxide thin film and analysis of its electrical properties

  • Published : 2005.01.30

Abstract

Ni oxide thin films with thermal sensitivity superior to Pt and Ni thin films were formed through annealing treatment after Ni thin films were deposited by a r.f. magnetron sputtering method. Resistivity values of Ni oxide thin films were in the range of $10.5{\mu}{\Omega}cm$ to $2.84{\times}10^{4}{\mu}{\Omega}cm$ according to the degree of Ni oxidation. Also temperature coefficient of resistance(TCR) values of Ni oxide thin films depended on the degree of Ni oxidation from 2,188 ppm/$^{\circ}C$ to 5,630 ppm/$^{\circ}C$ in the temperature range of $0{\sim}150^{\circ}C$. Because of the high linear TCR and resistivity characteristics, Ni oxide thin films exhibit much higher sensitivity to flow and temperature changes than pure Ni thin films and Pt thin films.

Keywords

References

  1. J. E. Sundeen and R. C. Buchanan, 'Electrical properties of nickel-zirconia cermet films for temperature and flow-sensor application', Sens, and Actuators, A 63, pp. 33-40, 1997 https://doi.org/10.1016/S0924-4247(97)80426-8
  2. A. F. P. Van Putten and S. Middlehoek, 'Integrated silicon anemometer', Electronic Letters, 10, pp. 425-426, 1974 https://doi.org/10.1049/el:19740339
  3. K. Petersen and J. Brown, 'Higj-precision. high-performance mass-flow sensor with integrated laminar flow micro-channels', Proc. Trans., 85, pp. 361-363, 1985
  4. P. Rudent and P. Navratil, 'Design of a new sensor for mass flow controller using thin-film technology based on an analytical thermal model', J. Vac. Sci. Technol., A 16, pp. 3559-3563, 1998 https://doi.org/10.1116/1.580998
  5. S. K. Park, S. H. Kim, S. H. Kim and Y. D. Kim, 'A flow direction sensor fabricated using MEMS technology and its simple interface circuit', Sens. And Actuators, B 91, pp. 347-352, 2003 https://doi.org/10.1016/S0925-4005(03)00109-6
  6. J. E. Sudden and R. C. Buchanan, 'Thermal sensor properties of cermet resistor films on silicon substrates', Sens. And Actuators, A 90, pp. 118-124, 2001 https://doi.org/10.1016/S0924-4247(00)00562-8
  7. J. M. Nel, F. D. Auret, L. Wu, M. J. Legodi, W. E. Meyer and M. Hayes, 'Fabrication and characterisation of NiO/Zno structures', Sens, and Actuators, B 100, pp. 270-276, 2004 https://doi.org/10.1016/j.snb.2003.12.054
  8. S. S. Noh. C. S. Lim, G. S. Chung, and K. H. Kim, 'Fabrication of PRTs and analysis of characteristics', IEE Elect. Letters, 39, pp. 1179, 2003
  9. S. S. Noh, D. H. Kim, G. S. Chung, H. P. Kim and K. H. Kim, 'Development of Trimming Technology in High-fine Resistor Using U.V. Laser', J. Kor. Sens. Society, 11, pp. 6, 2002
  10. J. Zang, Y. Nagao, S. Kuwano and Y. Ito, 'Micro-structure and Temperature Coefficient of Resistance of Platinum Films', Jpn. J. Appl. Phys., 36 pp. 834, 1997