콘크리트학회논문집 (Journal of the Korea Concrete Institute)

  • 제15권3호
  • /
  • Pages.433-442
  • /
  • 2003
  • /
  • 1229-5515(pISSN)
  • /
  • 2234-2842(eISSN)
한국콘크리트학회 (Korea Concrete Institute)
권호 표지
DOI QR코드

DOI QR Code

구속응력을 받는 콘크리트 구조물 해석을 위한 콘크리트 구성모델

A Concrete Model for Analysis of Concrete Structure with Confinement

  • 권민호 (경상대학교 토목공학과 공학연구원) ;
  • 조창근 (경북대학교 토목공학과 방재연구소)
  • Kwon, Min-Ho (Engineering Research Institute, Dept. of Civil Eng., Geyongsang University) ;
  • Cho, Chang-Geun (Research Institute for Disaster Prevention, KyungPook National University)
  • 발행 : 2003.06.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

본 연구에서는 단조하중, 반복하중, 비례하중, 비례하지 않는 하중을 받는 콘크리트 구조물의 3차원 유한요소해석을 위한 비선형 아소성 콘크리트 모델을 개발하였다. 이 구성모델은 등가일축변형률 개념을 기초로 하여 3차원 구성관계를 세 개의 서로 독립된 등가일축 구성관계로 바꾸고 이들 통하여 콘크리트의 거동을 예측하도록 모델되었다. 일축 구성관계는 Willam-Warnke의 파괴면을 이용하여 주응력공간에서 구해진 최대 압축응력으로부터 결정되었다. 특히 중수압축을 따라 재하되는 하중에 대한 콘크리트의 비선형 특성을 예측하기 위하여 파괴면에 캡면을 도입하였다. 일축 구성관계는 Popovis와 Saenz의 모델을 근거로 하여 구속응력이 증가함에 따라 취성에서 연성으로 변화하는 현상을 묘사할 수 있도록 새롭게 유도하였다. 개발된 모델을 모델의 성능을 평가하기 위하여 여러 실험결과와의 비교를 시도하였다. 먼저 일정한 구속응력과 단조하중을 받는 실험결과와 비교하였고, 이축압축실험과 비례하지 않는 하중과 반복하중을 받는 삼축압축 실험결과와 비교하였다.

This paper presents a hypoplastic model for three-dimensional analysis of concrete structures under monotonic, cyclic, proportional and non-proportional loading. The constitutive model is based on the concept of equivalent uniaxial strains that allows the assumed orthotropic model to be described via three equivalent uniaxial stress-strain curves. The characteristics of these curves are obtained from the ultimate strength surface in the principal stress space based on the Willam-Warnke curve. A cap model is added to consider loading along or near the hydrostatic axis. The equivalent uniaxial curve is based on the Popovics and Saenz models. The post-peak behavior is adjusted to account for the effects of confinement and to describe the change in response from brittle to ductile as the lateral confinement increases. Correlation studies with available experimental tests are presented to demonstrate the model performance. Tests with monotonic loading on specimens under constant lateral confinement are considered first, followed by biaxial and triaxial tests with cyclic loads. The triaxial test example considers non-proportional loading.

키워드

참고문헌

  1. S.S. Smith, K.J., Willam, K.H., Gerstle S., and Sture, 'Concrete over the top, or: is there life after peak,' ACI Journal,86(5), 1989, pp.491-497
  2. H.D.Kang, E. Spacone, and K.J. Willam, 'A study of compressive failure in over-reinforced concrete beams,' FRAMCOS-3, Gifu, Japan, October 12-16, 2, 1998, pp.1195-1210
  3. B.J. Hurlbut, 'Experimental and computational investigation of strain softening in concrele' Report AFOSR 80-0273 submitted to the US Air Force Office of Scientific Research, University of Colorado, Boulder, 1985
  4. D.C. Jansen, S.P. Shah, and E.C. Rossow, 'Stress -strain results of concrete from circumferential strain feedback control testing,' ACI structural Journal, 92(6), 1995, pp.419-428
  5. H.B. Kupfer, H.K. Hilsdorf and H. Rusch, 'Behavior of concrete under biaxial stresses,' ACI Journal, 66(8), 1969, pp.656-666
  6. R Scavuzzo, T. Stancowski, K Gerstle, and H-Y. Ko, 'Stress-strain curves for concrete under multiaxiaI load histories,' NSF CME 80-01508, Dept. of CEAE, University of Colorado, Boulder, 1983
  7. J.G.M. van Mier, 'Strain-softening of concrete under multiaxial loading conditions,' PhD thesis, Eindhoven Univ. of Technology, Eindhoven, the Netherlands, 1984
  8. KJ. Willam, K.J., B. Hurlbut, and S. Sture, 'Experimental and constitutive aspects of concrete failure,' Finite element analysis of reinforced concrete structures, Meyer and Okaimure, eds, ASCE, New York, N.Y., 1986
  9. D. Darwin and D.A. Pecknold, 'Nonlinear biaxial stress-strain law for concrete,' journal Engrg. Mech. Div., ASCE, Vol.l03, No.2, 1977, pp.229-241
  10. F.K. Bashur and D. Darwin, 'Nonlinear biaxial law for concrete,' Journal Struct. Div., ASCE, Vol.104, No.1, 1978, pp.157-170
  11. S.G. Lekhnitskii, Theory of elasticity of an anisotropic elastic body,' Julius Journal Brandstatter ed, HoldenDay, Inc., San Francisco, CA, 1963
  12. T.A. Balan, F.C. Filippou, and E.P. Popov, 'Constitutive model for 3D cyclic analysis of concrete structures' Journal Engrg. Mech. Div., ASCE, Vo1.123, No.2, 1997, pp.143-153
  13. A.A. Elwi and D.W. Murray, 'A 3D hypoelastic concrete constitutive relationship,' journal Engrg. Mech. Div., ASCE, Vol.105, No.4, 1979, pp.623-641
  14. K.J. Willam and E.P. Warnke, 'Constitutive model for the triaxial behavior of concrete,' Int. Assodation for Bridge and Struct. Engrg. Proc., 19, 1975, pp.1-30
  15. Ph. Menetrey and K.J. Willam, 'Triaxial failure criterion for concrete and its generalization,' ACI Structural journal, Vo1.92, No.3, 1995, PP.311-318
  16. I.P. Saenz, 'Discussion of 'Equation for the Stress-strain curve of concrete, by P. Desay and S. Krishan,' ACI Journal, Vo1.61, No.9, 1964, pp.1229-1235
  17. A. Bouzaiene and B. Massicotte, 'Hypoelastic tridimensional model for nonproportional loading of plain concrete,' Journal Engrg. Mech. Div., ASCE, Vol.123, No.11, 1997, pp.1111-1120 https://doi.org/10.1061/(ASCE)0733-9399(1997)123:11(1111)
  18. S. Popovics 'Numerical approach to the complete stress-strain relation for concrete,' Cement and Concrete Res., Vol.3, No.5, 1973, pp.583-599 https://doi.org/10.1016/0008-8846(73)90096-3
  19. W.F. Chen, 'Plasticity in reinforced concrete, McGraw-Hill, New York, N.Y , 1982
  20. Z.P. Bazant, 'Comment on orthotropic models for concrete and geomaterials,' Journal Engrg. Mech Div., ASCE, Vol.109, No.3, 1983, pp.849-865 https://doi.org/10.1061/(ASCE)0733-9399(1983)109:3(849)
  21. R.L. Taylor, FEAP User Manual v7.1, University of Califorinia, Berkeley, Department of Civil and Environmenental Engineering, 1999
  22. D. Kolymbas, 'An outline of hypoplastidty,' Arch AppI. Mech., 61, pp.143-151, 1991

피인용 문헌

  1. Performance Evaluation and Analysis Model for the Post-Installed Anchor vol.13, pp.2, 2013, https://doi.org/10.9798/KOSHAM.2013.13.2.089
  2. Seismic Retrofit of School Facilities Using Rapping and Attaching Composite Material vol.26, pp.2, 2014, https://doi.org/10.4334/JKCI.2014.26.2.135