DOI QR코드

DOI QR Code

필릿 용접변형에 대한 간이 예측 모델 개발

Development of Simple Prediction Model for Fillet Welding Deformation

  • 김상일 (대우조선해양 (주) 선박해양구조연구팀)
  • 발행 : 2003.04.01

초록

The welding deformation of a hull structure in the shipbuilding industry is Inevitable at each assembly stage. The geometric inaccuracy caused by the welding deformation tends to preclude the introduction of automation and mechanization and needs the additional man-hours for the adjusting work at the following assembly stage. To overcome this problem, a distortion control method should be applied. For this purpose, it is necessary to develop an accurateprediction method which can explicitly account for the influence of various factors on the welding deformation. The validity of the prediction method must be also clarified through experiments. This paper is aimed at deriving the simple prediction model for fillet welding deformations. For this purpose, the thermal elasto-plastic analysis varying the welding conditions and plate thickness has been performed. On the basis of numerical results, the formulae for angular distortion and transverse shrinkage have been derived through the regression analysis. Experimental work has been also carried out to clarify the validity of numerical results. It has been found that the numerical results show a good agreement with those of experiments

키워드

참고문헌

  1. Fujita, Y. and Nomoto, T., 1972, Studies on thermal elasto-plastic problems(1st report), Journal of the Society of Naval Architects of Japan, Vol. 130, pp.183-191
  2. 방한서, 1990, 유한요소법비정상 열전도해석, 대한조선학회논문집, 제27권, 제4호, pp.43-50
  3. Ueda, Y. et al., 1992, Simulation of welding deformation for accurate ship assembling(1st report), Journal of the Society of Naval Architects of Japan, Vol. 171, pp.395-404
  4. 장창두, 서승일, 1994, 용접 조립보의 변형 예측에 관한 연구, 대한조선학회논문집, 제31권, 제3호, pp.145-153
  5. 김상일, 1999, 선체 구조의 용접변형 제어법 개발, 울산대학교 공학박사 학위 논문
  6. 장창두, 이창현, 2000, 선체 블록의 용접변형 예측 및 제어를 위한 연구, 대한조선학회논문집, 제37권, 제2호, pp.127-136
  7. Kim, S.I., Kang, J.K. and Han, J.M., 2002, Development of welding deformation control method for hull structure of Ro/Ro passenger ferry Proceedings of ISOPE-2002, pp.314-320
  8. Watanabe, M. and Satoh, K., 1956, Control of angular distortions due to welding conditions in T-fillet welding joints-shrinkage distortion in welded joints(2nd report)-, Journal of the Japanese Welding Society, Vol. 25, No. 6, pp.343-348 https://doi.org/10.2207/qjjws1943.25.343
  9. Satoh, K. and Terasaki, T., 1976, Effect of welding conditions on residual stress distributions and welding deformations in welded structural materials, Journal of the Japanese Welding Society, Vol. 45, No. 1, pp.42-53 https://doi.org/10.2207/qjjws1943.45.42