DOI QR코드

DOI QR Code

Cyclic compressive loading-unloading curves of brick masonry

  • AlShebani, Milad M. (Department of Civil Engineering, I.I.T.) ;
  • Sinha, S.N. (Department of Civil Engineering, I.I.T.)
  • 발행 : 2000.04.25

초록

Experimental investigation into the cyclic behaviour of sand plast brick masonry was performed on forty two square panels. The panels were subjected to cyclic uniaxial compression for two cases of loading: normal to bed joint and parallel to bed joint. Experimental data were used to plot the unloading-reloading curves for the entire range of the stress-strain curve. Mathematical expressions to predict the reloading and unloading stress-strain curves at various values of residual strain are proposed. A simple parabola and an exponential type formula are found adequate to model the unloading and reloading curves respectively. The models account for the potential effects of residual strain on these curves. Comparison of test results with the proposed mathematical expression shows good correspondence.

키워드

참고문헌

  1. Abrams, D., Noland, J. and Atkinson, R. (1985), "Response of clay unit masonry to repeated compressive forces", Proc. 7th Int. Brick Masonry Conf., Melbourne, 565-576.
  2. AlShebani, M.M. and Sinha, S.N. (1998), "Influence of panel aspect ratio on the cylic residual strains of brickmasonry", Proc. 8, 5th Int. Masonry Conf., Stoke-on-Trent, 316-319.
  3. AlShebani, M.M. and Sinha, S.N. (1999), "Stress-strain characteristics of brick masonry under uniaxial cyclicloading", J. of Struct. Engrg., ASCE, 125(6), 600-604. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:6(600)
  4. Bahn, B.Y. and Hsu, C.T. (1998), "Stress-strain behaviour of concrete under cyclic loading", ACI Material J.,95(2), 178-193.
  5. Chen, S.W.J., Hidalgo, P.A., Mayes, R.L., Clough, R.W. and McNiven, H.D. (1978), "Cyclic loading tests ofmasonry single piers, Volume 2-height to width ratio of 1", EERC Report No. 78/28, Univ. of Clif., Berkely.
  6. Karsan, J.K. and Jersa, J.O. (1969), "Behaviour of concrete under compressive loadings", J. of Struct. Div.,ASCE, 95(ST 12), 95, 2543-2563.
  7. Macchi, G. (1985), "Behaviour of masonry under cyclic actions and seismic design", Proc. of 6th Int. BrickMasonry Conf., Rome, Italy, LI-LXXIV.
  8. Naraine, K. and Sinha, S.N. (1989), "Behaviour of brick masonry under cyclic compressive loading", J. ofStruct. Engg., ASCE, 115(6), 1432-1445. https://doi.org/10.1061/(ASCE)0733-9445(1989)115:6(1432)
  9. Naraine, K. and Sinha, S.N. (1989), "Loading and unloading stress-strain curves for brick masonry", J. of Struct.Engg., ASCE, 115(10), 7631-7644.
  10. Sinha, B.P., Gerstle, K.H. and Tulin, L.G. (1964), "Stress-strain relations for concrete under cyclic loading", ACI Journal, 61, 195-210.
  11. Subramaniam, K.V. and Sinha, S.N. (1995), "Analytical model for cyclic compressive behaviour of brickmasonry", ACI Struct. J., 92(3), 288-294.
  12. Tomazevic, M., Lutman, M. and Petkovic, L. (1996), "Seismic behaviour of masonry walls: experimentalsimulation", J. of Struct. Engg., ASCE, 122(9), 1040-1047. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:9(1040)
  13. Yankelevsky, D.Z. and Reinhardt, H.W. (1987), "Model for cyclic compressive behaviour of concrete", J. ofStruct. Engg., ASCE, 113, 225-240.

피인용 문헌

  1. Loading–unloading curves of interlocking grouted stabilised sand-flyash brick masonry vol.40, pp.7, 2007, https://doi.org/10.1617/s11527-006-9177-x
  2. General stress-strain model for concrete or masonry response under uniaxial cyclic compression vol.14, pp.4, 2002, https://doi.org/10.12989/sem.2002.14.4.435
  3. Modeling of Out-of-Plane Behavior of Masonry Walls vol.135, pp.12, 2009, https://doi.org/10.1061/(ASCE)0733-9445(2009)135:12(1522)
  4. Experimental and analytical response of masonry elements under eccentric vertical loads vol.27, pp.8, 2005, https://doi.org/10.1016/j.engstruct.2005.02.012