A STUDY ON THE INFLUENCE OF PRETREATMENT ON THE BOND STRENGTHS OF SOME PIT AND FISSURE SEALANTS

수종의 치면열구 전색재의 전처리가 결합강도에 미치는 영향

  • Min, Yun-Kyung (Dept. of Pediatric Dentistry, College of Dentistry, Pusan National University) ;
  • Jeong, Tae-Sung (Dept. of Pediatric Dentistry, College of Dentistry, Pusan National University) ;
  • Kim, Shin (Dept. of Pediatric Dentistry, College of Dentistry, Pusan National University)
  • 민윤경 (부산대학교 치과대학 소아치과학교실) ;
  • 정태성 (부산대학교 치과대학 소아치과학교실) ;
  • 김신 (부산대학교 치과대학 소아치과학교실)
  • Published : 1998.05.30

Abstract

For the purpose of comparing the shear bond strengths of pit and fissure sealants, and finding out the more efficient method of tooth surface treatment when the etched surface is contaminaed by saliva or moisture, an experiment was performed on 3 types of pit and fissure sealants. 120 extracted human molars were divided into 3 groups, each of which was composed of 40 specimens sealed with Helioseal, Teethmate-F and Fuji III respectively. And each groups was again divided into 4 subgroups according to tooth surface treatment. The shear bond strengths of each groups and subgroup was measured and statistically analyzed. The results obtained were as follows : 1. Shear bond strengths of nonfluoridated resin sealant, Helioseal were shown to be higher than those of fluoridated resin sealant, Teethmate-F, but, not significantly different. 2. Shear bond strengths of GI sealant, Fuji III were to be markedly lower than those of two resin sealants. 3. When there is moisture contamination, applying primer under sealant(Group IV) results in a significantly stronger bond strength of sealant to enamel than when using sealant alone(Group II) in case of all sealants. 4. When there is no moisture contamination, using primer under sealant (Group III) results in bond strength equivalent to bond strength on using sealant alone (Group I). 5. Based on the results above, it was demonstrated that the bond of sealant to tooth surface is greatly affected by saliva contamination and that the complete tooth isolation method should be fully emphasized. The application of primer is recommended when performing sealant under the environment very susceptible to saliva contamination.

Keywords