Abstract
Recently, HT steel has been widely used in structure, and this enables to reduce the plate thickness. To use the HT steel effectively for a ship hull, the plate thickness becomes thin so that plate buckling may take place. Therefore, precise assessment of the behaviour of plat above primary buckling load is important. The plate under the load, that is called, secondary buckling load may undergo abrupt changes in wave form after primary buckling. This is very important when the collapse strength of the whole structures is considered. From this point of view, this paper discusses secondary buckling behaviour of thin plate under inplane compressive loading. A elastic large deflection analysis of plates with initial imperfection is performed assuming uniaxial compression, respectively, and the influence of secondary buckling is investigated. It is known that square plate is not influenced by non-symmetrical deflection coefficient but influenced by symmetrical deflection coefficient. Also, it has been found that rectangular plate($\alpha$=a/b) is influenced by all deflection coefficient, and the reduction of inplane stiffness of the plate after primary buckling is continued.
최근 고장력강(高張力鋼)이 구조물에 폭넓게 사용되고 있어서 판두께가 얇아지고 있다. 판두께가 얇아지므로해서 좌굴(座屈)이 발생하기 쉽다. 그러므로 좌굴(座屈)발생후 판의 거동(擧動)을 정확하게 파악하는 것은 중요하다. 좌굴(座屈) 발생후 2차좌굴(次座屈)이라고 하는 하중하(荷重下)에서는 판(板)의 처짐모드가 갑자기 변한다. 전체구조물의 붕괴강도(崩壞强度)를 고려할 때 2차좌굴(次座屈)은 매우 중요하다. 이런 관점에서 본 연구에서는 면내압축하중(面內壓縮荷重)을 받는 판(板)의 2차좌굴거동(次座屈擧動)에 관하여 연구하였다. 초기처짐을 갖는 판(板)을 대상으로 하여 탄성대변형해석(彈性大變形解析)을 실시하여, 2차좌굴(次座屈)의 영향을 검토하였다. 그 결과로서 다음과 같은 결론(結論)을 얻었다. 즉, 정사각형판은 대칭의 처짐성분은 영향이 있으나 비대칭의 처짐성분은 영향이 전혀 없다. 또한, 종횡비(縱橫比)를 갖는 판(板)은 모든 처짐성분의 영향이 있으며 초기좌굴(初期座屈)후 면내강성(面內剛性)이 계속적으로 감소한다.