A Study on Bearing Capacity Characteristics of Group Crushed-Stone Compaction Piles

군쇄석다짐말뚝의 지지력 특성에 관한 연구

  • Hwang, Geun-Bae (Research Institute of Engineering & Technology, Kyungsung Univ.) ;
  • Lee, Min-Hee (Research Institute of Engineering & Technology, Kyungsung Univ.) ;
  • Shin, Hyeon-Cheol (Audit & Inspection Office, Busan Metropolitan City) ;
  • Choi, Yong-Kyu (Dept. of Civil & Environmental Engineering, Kyungsung Univ.)
  • 황근배 (경성대학교 공학기술연구소) ;
  • 이민희 (경성대학교 공학기술연구소) ;
  • 신현철 (부산광역시 감사관실) ;
  • 최용규 (경성대학교 건설 환경공학부)
  • Published : 2005.03.25

Abstract

Among soft ground treatment methods with granular soil used in domestic, the sand compaction pile method has been utilized greatly, but, as a result of exhaustion of sand and increase of unit cost, a necessity of an alternative method is suggested. In this study, the static load tests for group crushed-stone compaction piles which were constructed at in-situ site were performed. Pile diameter was 700mm and area of loading plates were changed. The static load tests of single and group piles were performed for area replacement ratio of 20, 30 and 40%. Based on test results, bearing capacity of group crushed-stone compaction pile were estimated. The more both single pile and group pile increase, the more yield bearing capacity tended to increase. Also, the yield bearing capacity of a group pile is about 50% less than the yield bearing capacity of a single pile. If the ground reinforced with the crushed-stone compaction pile is replacement ratio of $20{\sim}40%$, RIYB of both single pile and group pile increases qualitative tendency of linear more than original ground

Keywords