• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.5
• /
• pp.1642-1661
• /
• 2015

Wireless mesh networks are a special type of broadcast networks which cover the qualifications of both ad-hoc as well as infrastructure mode networks. These networks offer connectivity to the last mile through hop to hop communication and by comparatively reducing the cost of infrastructure in terms of wire and hardware. Channel assignment has always been the focused area for such networks specifically when using non-overlapping channels and sharing radio frequency spectrum while using multiple radios. It has always been a challenge for mesh network on impartial utilization of the resources (channels), with the increase in users. The rational utilization of multiple channels and multiple radios, not only increases the overall throughput, capacity and scalability, but also creates significant complexities for channel assignment methods. For a better understanding of research challenges, this paper discusses heuristic methods, measurements and channel utilization applications and also examines various researches that yield to overcome this problem. Finally, we highlight prospective directions of research.

• ETRI Journal
• /
• v.38 no.5
• /
• pp.922-933
• /
• 2016

IP header compression schemes offer a valuable measure for bandwidth preservation. Such schemes have been practically implemented in infrastructure-based IP networks for point-to-point links. However, minimal research and practical implementation efforts have been conducted in the direction of an IP header compression strategy that can meet the peculiar requirements of multi-hop ad hoc wireless networks. In this paper, we present a practically implemented multi-hop IP header compression scheme using the Robust Header Compression (ROHC) protocol suite. The scheme runs on a novel identifier (ID) based networking architecture, known as an ID-based ad hoc network (IDHOCNET). IDHOCNET additionally solves a number of bottlenecks of pure IP-based ad hoc networks that have emerged owing to IP address auto-configuration service, distributed naming and name resolution, and the role of an IP address as an identifier at the application layer. The proposed scheme was tested on a multi-hop test bed. The results show that the implemented scheme has better gain and requires only O (1) ROHC contexts.

• Journal of Communications and Networks
• /
• v.18 no.4
• /
• pp.580-588
• /
• 2016

Energy efficiency is the main objective in the design of a wireless sensor network (WSN). In many applications, sensing data must be transmitted from sources to a sink in a timely manner. This paper describes an investigation of the trade-off between two objectives in WSN design: minimizing energy consumption and minimizing end-to-end delay. We first propose a new distributed clustering approach to determining the best clusterhead for each cluster by considering both energy consumption and end-to-end delay requirements. Next, we propose a new energy-cost function and a new end-to-end delay function for use in an inter-cluster routing algorithm. We present a multi-hop routing algorithm for use in disseminating sensing data from clusterheads to a sink at the minimum energy cost subject to an end-to-end delay constraint. The results of a simulation are consistent with our theoretical analysis results and show that our proposed performs much better than similar protocols in terms of energy consumption and end-to-end delay.

• Journal of Korea Multimedia Society
• /
• v.21 no.5
• /
• pp.592-598
• /
• 2018

In wireless sensor networks where there is no centralized base station, each node has limited transmission range and the multi-hop routing for transmitting data to the destination is the one of the important technical issues. In particular, the wireless sensor network is not powered by external power source but operates by its own battery, so it is required to maximize the network life through efficient use of energy. To balance the power consumption, the residual power based adaptive power control is required in routing protocol. In this paper, we propose a routing protocol that prolongs the network lifetime by balancing the power consumption among the nodes by controlling the transmit power according to the residual power. We evaluate the proposed routing protocol using extensive simulation, and the results show that the proposed routing scheme can balance the power consumption and prolong network lifetime.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.3A
• /
• pp.287-295
• /
• 2010

In wireless sensor networks(WSNs), the studies that support sink mobility without global position information exploit a Backbone-based Virtual Infrastructure (BVI) which considers one-hop clusters and a backbone-based tree. Since the clusters of a sink and a source node are connected via flooding into the infrastructure, it causes high routing cost. Although the network could reduce the number of clusters via multi-level clusters, if the source nodes exist at nearest clusters from the cluster attached by the sink and they are in different branches of the tree, the data should be delivered via detour paths on the tree. Therefore, to reduce the number of clusters, we propose a novel multi-hop cluster based communication protocol supporting sink mobility without global position information. We exploit a rendezvous cluster head for sink location service and data dissemination but the proposed protocol effectively reduces data detour via comparing cluster hops from the source. Simulation shows that the proposed protocol is superior to the existing protocols in terms of the data delivery hop counts.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.4A
• /
• pp.394-400
• /
• 2010

Mobile Multi-hop Relaying (MMR) system can provide increased system capacity of wireless access network by coverage extension and enhanced transmission rate within the Base Station (BS) coverage area. The previous researches for the MMR system with a non-transparent mode Relay Station (RS) do not consider channel selection procedure of Mobile Station (MS), co-channel interference and Multi-hop Relay Base Station (MR-BS) coverage and RS coverage ratio in MMR system. In this paper, we investigate the performance of MMR uplink system in multicell environments with various topologies. The performance is presented in terms of call blocking probability, channel utilization, outage probability and system throughput by varying offered load. It is found that, for certain system parameters, the MMR uplink system achieve the maximum system throughput when MR-BS coverage to RS coverage ratio is 7.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.5 no.1
• /
• pp.105-122
• /
• 2011

The fundamental design goal of wireless sensor MAC protocols is to minimize unnecessary power consumption of the sensor nodes, because of its stringent resource constraints and ultra-power limitation. In existing MAC protocols in wireless sensor networks (WSNs), duty cycling, in which each node periodically cycles between the active and sleep states, has been introduced to reduce unnecessary energy consumption. Existing MAC schemes, however, use a fixed duty cycling regardless of multi-hop communication and traffic fluctuations. On the other hand, there is a tradeoff between energy efficiency and delay caused by duty cycling mechanism in multi-hop communication and existing MAC approaches only tend to improve energy efficiency with sacrificing data delivery delay. In this paper, we propose two different MAC schemes (ADS-MAC and ELA-MAC) using closed-loop control in order to achieve both energy savings and minimal delay in wireless sensor networks. The two proposed MAC schemes, which are synchronous and asynchronous approaches, respectively, utilize an adaptive timer and a successive preload frame with closed-loop control for adaptive duty cycling. As a result, the analysis and the simulation results show that our schemes outperform existing schemes in terms of energy efficiency and delivery delay.

• Proceedings of the Korean Information Science Society Conference
• /
• 2005.07a
• /
• pp.505-507
• /
• 2005

이 논문에서는 Wireless Network Mobility(NEMO) 환경하에서 지속적인 인터넷 연결성을 지원하고 또한 multi-angular routing 을 방지하여 최적화된 경로를 제공하기 위한 메커니즘을 제안한다. 이를 위해 각각의 NEMO 들은 parent-child 관계를 가지는 계층적 멀티 홉 NEMO 구조로 표현하고, 네트워크 이동성을 제공하기 필요한 최소한의 Mobile IPv6 Extension 에 대해서 설명한다. 또한 Wireless NEMO 환경하에서 hop by hop 터널링 기법을 이용한 최적화된 라우팅 동작에 대해 기술한다.

• Journal of information and communication convergence engineering
• /
• v.6 no.4
• /
• pp.459-465
• /
• 2008

Locations of nodes as well as gathered data from nodes are very important because generally multiple nodes are deployed randomly and data are gathered in wireless sensor network. Since the nodes composing wireless sensor network are low cost and low performance devices, it is very difficult to add specially designed devices for positioning into the nodes. Therefore in wireless sensor network, technology positioning nodes precisely using low cost is very important and valuable. This research proposes Cooperative Positioning System, which raises accuracy of location positioning and also can find positions on multiple sensors within limited times.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.7B
• /
• pp.550-564
• /
• 2012

In this work we propose a new pricing scheme for the wireless Internet services over WiMAX system. First, let us review the characteristics of wireless network which is based on multi-hop relay WiMAX system. Next, we show why usage-based and QoS-aware pricing scheme is needed in the wireless Internet. After that, we propose a theoretical model for the price of multimedia services called a DAP (DiffServ-aware pricing) scheme for the WiMAX multimedia network which takes into account the consumed radio resource of WiMAX system as well as the supported QoS in the IP backbone network. Finally, we present explicit formulae for the packet price, price of consumed radio resource, and price of consumed bytes.