• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.200-207
• /
• 2009

This paper presents a compact, low insertion loss, sharp rejection and wide band microstrip band pass filter that is composed rectangular loop resonator and Step-Impedance-Open-Stub(SIOS). The SIOS can be reduce length about 30 % more than general 0.25 $\lambda$ open stub. And the stub can the advantage of tuning impedance magnitude. In order to demonstrate agrement of this paper prove, the optimized wide band pass filters are realized and experimented. A transmission line model used to calculate the frequency response of the new filters shows good agreement with measurements. The filter has 3 dB fractional bandwidth of 51.75 %(3.206 GHz), an insertion loss of better than 0.44 dB from 4.587 GHz to 7.793 GHz, and two rejection of greater than 30 dB within 221 MHz($4.326{\sim}4.587\;GHz$) at low frequency band, 181 MHz($7.739{\sim}7.954\;GHz$) at high frequency band. Maximum rejection characteristics of the filter are -61.8 dB at low frequency and -76.3 dB at high frequency.

• The Journal of the Acoustical Society of Korea
• /
• v.28 no.6
• /
• pp.491-498
• /
• 2009

This paper presents the design method of an impedance matching network using an isolation transformer and the Chebyshev filter function for the high efficiency and the flat power driving of an underwater acoustic piezoelectric transducer. The proposed impedance matching network is designed for minimizing the reactance component of transducer and having the flat power response in the wide frequency range. We design a low pass filter with ladder-type circuit using the Chebyshev function as standard prototype filter function. In addition, we design the impedance matching network which is suitable for the equivalent circuit of transducer and the turn ratio of transformer through the bandpass frequency transformation. The proposed method is applied to the simulated dummy load of the tonpilz-type transducer operating in the middle frequency range. The simulation results are compared with the measured characteristics and the validity of the proposed method is verified.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.2B
• /
• pp.167-173
• /
• 2004

This paper reports on the development of a 60㎓ wide bandwidth wireless transceiver using NRD waveguide. We fabricated a wireless transceiver using NRD waveguide, which consists of a 3 dB directional coupler, a bandpass filter, a Gunn oscillator, an ASK modulator, and a Balanced Mixer. The new transceiver is capable of transmitting an output power of 10mW to a distance of more than 1 Km, operating in 60㎓ frequency and bandwidth of 2㎓. The value of BER reached approximately 10 when the transceiver was tested at the 155.52Mbps ATM(OC 3) at the communication distance of 1 km. It demonstrated an impressively stable transmission feature of BER l0$^{6}$ even in the heavy rainfall.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.12
• /
• pp.1-7
• /
• 2007

This paper proposes the design method based on the composite right/left-handed (CRLH) structure to miniaturize and enhance the rejection performance in the stopband. For realization, we used the 0-th order resonance point of the unbalanced case of the CRLH and the simple theory of Inverter. The proposed technique is validated by the performance predictions and experiments, and it is found out that the suggested method enables the sire reduction of over 65 % from the conventional filters such as the parallel coupled type.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.307-314
• /
• 2010

In this paper, a novel ultra-wideband microstrip-to-suspended stripline(SSL) transition is proposed, and SSL filters with low-loss and high selectivity have been realized using this transition. Since the proposed transition has low-loss and wide bandwidth characteristic, the design procedure of SSL filters become simplified. Additionally, the designed filters do not require extra time-consuming tuning. As design examples, SSL low-pass and high-pass filters have been implemented, and a implemented bandpass filter with connection of the low and high-pass filters performs 2.3~10.5 GHz bandwidth with less than 1.2 dB insertion loss and high selectivity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.4 s.95
• /
• pp.380-388
• /
• 2005

This paper presents analysis results of the effects of RF filter characteristics on the system performance of impulse radio. The impulse radio system transmits modulated pulses having very short time duration and information can be extracted in receiver side based on cross-correlation between received and transmitted pulses. Accordingly, the pulse distortion due to in-band group delay variation can cause serious system performance degradation. In general, RF bandpass filters inevitably cause group delay difference to the signal passing through the filter which is proportional to its skirt characteristic due to its resonance phenomenon. For time as well as frequency domain analysis, small signal scattering parameter $S_{21}$ and its Fourier transform are used to characterize output pulse waveform under the condition that the input and output ports are matched. The output pulse waveform of the filter is predicted based on convolution integral between input pulse and filter transfer function, and resulting BER performances in the BPM and PPM based impulse radio system are calculated.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.1
• /
• pp.117-122
• /
• 2006

A CMOS LNA based on a single-stage cascode configuration is designed for MB-OFDM ultra-wide band(UWB) systems. Wideband($3.1GHz\~4.9GHz$) input matching is performed using a simple bandpass filter to minimize the chip size and the noise figure degradation. The simulation results using $0.18{\mu}m$ CMOS process parameters show a power gain of 9.7dB, a 3dB band width of $2.1GHz\~7.1GHz$, a minimum NF of 2dB, an IIP3 of -2dBm. better than -11.8dB of input matching while occupying only $0.74mm^2$ of chip area. It consumes 25.8mW from a 1.8V supply.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.16 no.1
• /
• pp.1-9
• /
• 1996

Many signal-processing techniques have been found to be useful in ultrasonic and nondestructive evaluation. Among the most popular techniques are signal averaging, spatial compounding, matched filters and homomorphic processing. One of the significant new process is split-spectrum processing(SSP), which can be equally useful in signal-to-noise ratio(SNR) improvement and grain characterization in several specimens. The purpose of this paper is to explore the utility of SSP in ultrasonic NDE. A wide variety of engineering problems are reviewed, and suggestions for implementation of the technique are provided. SSP uses the frequency-dependent response of the interfering coherent noise produced by unresolvable scatters in the resolution range cell of a transducer. It is implemented by splitting the frequency spectrum of the received signal by using gaussian bandpass filter. The theoretical basis for the potential of SSP for grain characterization in SUS 304 material is discussed, and some experimental evidence for the feasibility of the approach is presented. Results of SNR enhancement in signals obtained from real four samples of SUS 304. The influence of various processing parameters on the performance of the processing technique is also discussed. The minimization algorithm, which provides an excellent SNR enhancement when used either in conjunction with other SSP algorithms like polarity-check or by itself, is also presented.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.94-100
• /
• 2017

In this paper, we suggest a design method of a metamaterial-based low-profile antenna working at 425 MHz for LEO/Cube satellites. Satellites play an important role in linking th remote nodes in a wireless communication network and covering wide areas of the globe. Especially, an increasing number of universities or individuals aspire having their own satellites and build low-budget structures such as cube satellites in LEO and the ways to reduce the sizes of their satellites. Since the antenna occupies a major portion of the satellite surface, the antenna should be miniaturized for lighter weight. The proposed metamaterial low-profile antenna, unlike the conventional patch antenna, produces such a zeroth-order resonance to create an omnidirectional radiation pattern. Also, it is connected to a UHF waveguide bandpass filter as the feeding system to examine the possible change in the situation that the antenna is combined with the system. The performances of the monopole and proposed metamaterial antennas are compared to one another.