• 한국식품과학회지
• /
• 제19권6호
• /
• pp.543-549
• /
• 1987

식품에 수은이 오염(汚染)되었을 경우 수세(水沈) 및 조리(調理)중 수은함량에 어떠한 변화가 일어나는가를 알아보기 위해 수은 오염이 우려되는 쌀, 콩나물, 물고기가 사용되었으며 수은의 검출은 무염화(無炎火) 원자흡광법에 의해 측정되었다. 수은을 인위적으로 1ppm수준으로 오염시킨 쌀을 3회 수세시 전체 수은량의 24%가, 4회 수세시 31%가 감소되었으나 취반(炊飯)에 의해서는 유의적인 함량변화를 보이지 않았다. 수은 80ppm으로 오염된 콩나물을 3회 수세한 경우 수은잔류량의 약 26%가 감소하였으나 가열조리에 의해서는 전체 수은량의 감소가 없었다. 콩나물의 가열조리시 수은은 고형물에서 국물로 용출(溶出)되었으며 용출량은 가열시간, 소금농도와 첨가하는 물의 양에 따라 23-41%의 범위에서 다르게 나타났다. 수은 1ppm으로 오염된 물고기의 가열조리시 전체 수은량의 감소는 없었으나 이때 수은은 고형물에서 국물로 용출되었으며 용출량은 조리용수(調理用水)의 소금농도에 의해 2-10%의 범위에서 달리 나타났다. 물고기를 조리후 비가식부(非可食部)를 버리는 경우 오염(汚染)된 수은의 32%가 제거되었다.

• 분석과학
• /
• 제8권4호
• /
• pp.799-806
• /
• 1995

In industrial field, a large volume of regenerants (acid and caustic soda) and their washing effluents are regularly disposed off from the water demineralization plant during regeneration of the ion-exchanger units. Of these waste effluents, a part of the wash water discharged from the single bed Anion and Mixed Bed units can be utilized at a certain stage of their washing cycles when its conductivity is fallen down and becomes considerably less than that of the input raw water. The main aim of this specific waste effluent utilization is to dilute the TDS concentration of the input raw water (fed into the single bed ion-exchanger units) by blending. The achievement is the increase of the longevity of the production cycles of the I.E. units along with the improvement of the production quality and decrease of the regeneration frequencies. As a result, regenerant consumption would be saved because of the reduction of ionic load in feed water which will ultimately reduce the water purification cost. At the same time, the environment pollution will also be protected to a considerable extent. This operational measure is quite effective and useful specially where high TDS water is demineralized only by single bed ion-exchangers. In such case, the water treatment plant is very often found to suffer from both production quality and quantity in addition to carrying out of random and restless regenerations. Proper reuses of the aforesaid wash water effluents of the Anion and MB units excellently minimizes the difficulties experienced in practice. This paper contains the utilities and techniques of reuses of the different kinds of waste effluents of the industrial water treatment plant in addition to the specific reuses of the post-regeneration wash waters of the Anion and MB ion-exchanger units.

• 자원리싸이클링
• /
• 제26권2호
• /
• pp.66-70
• /
• 2017

본 연구에서는 바다모래 세척 시 밀도 변화를 평가하기 위하여 채취와 판매되는 현장조건의 바다모래에 대하여 함수비, 진밀도, 들밀도 그리고 모래 운반차량 직접 계근을 통한 밀도 분석을 수행하였다. 바지선과 덤프의 진밀도는 각각 평균 $2.666g/cm^3$ 및 $2.651g/cm^3$로 전체적으로 거의 유사하였다. 또한, 바지선과 덤프의 습윤밀도는 각각 평균 $1.716g/cm^3$ 및 $1.331g/cm^3$로 나타남으로써, 모래 1톤이 차지하는 부피로 환산할 경우 각각 $0.583m^3$ 및 $0.751m^3$로 평균 약 28.8% 정도의 부피변화가 수반되는 것으로 나타났다. 또한, 모래 운반차량을 직접 계근하여 측정된 출하 모래와 바지선 모래의 밀도는 각각 평균 $1.398g/cm^3$ 및 $1.716g/cm^3$로 분석되었는데, 이 값을 모래 1톤이 차지하는 부피로 환산하면 각각 $0.715m^3$ 및 $0.583m^3$로 바다모래 채취량과 판매량 간에 평균 약 22.6% 정도의 부피 변화가 수반되었음을 알 수 있었다.

• Environmental Analysis Health and Toxicology
• /
• 제11권1_2호
• /
• pp.19-29
• /
• 1996

Human exposure to volatile compounds in tap water can occur from inhalation and dermal absorption as well as direct ingestion. The relative contribution to total human exposure from these pathways has been considered to be important especially for VOC's (volatile organic compounds). In an attempt to reduce the uncertainty of the risk assessment, it has been suggested that the exposure assessment process could be significantly improved by adopting Monte-Carlo simulation. However, there is no actual data in Korea for each exposure parameter to determine the level of exposure, and the distributional pattern. Therefore, we surveyed water use patterns and behavior related to multi-route exposure to VOC's in household tap water in Korea, and compared these values to the those in western countries. In the first survey, we calculated daily water intake using data from a sample of 1322 persons of several cities in Korea. In the second survey, we obtained questionnaire data on exposure time for showering, bathing and household activities, and tap water intake from 851households in Korea. In the last survey, we measured the exposure parameters (exposure time, water use rate etc.) related to showers, baths, toilets, dish washing, washing and cooking, and tap water intake was surveyed. Also, the subjects were measured their body weight, height and tidal volume, etc. A diary, a flow meter and a measuring cup were used to measure these values as precisely as possible. Average daily water intake was ranged 0.79-1.71 L/day for adults in three surveys. Tap water intake measured by log-sheet during one week in third survey was 1.26 (average), 1.98 L/day (90 percentlie), respectively. These results were comparable with results from EPA (1.4, 2L/day). The average amount of water used by housewives in the third survey was 515.0 $\pm$ 564.6L/day. In usual activity, the amount of water used in the bathroom, the laundry and the kitchen was 140.0 $\pm$ 538.9, 148.0 $\pm$ 174.5, 229.3 $\pm$ 205.4 L/day, respectively. Exposure parameters such as water intake rate, exposure duration, body weight, inhalation rates in surveyed data of Korean people differed from those published from western countries. This could be attributed to variations in lifestyle, dietary habits and physiological characteristics.

• 약학회지
• /
• 제40권6호
• /
• pp.659-665
• /
• 1996

Zinc white is mainly used as a mild astringent, protectant. and has weak antiseptic action. It is well known that the yield of zinc white produced is greatly affected by the syn thetic conditions such as the reactant concentration, reaction temperature, washing water temperature, mole ratio of reactants, and drying temperature, calcination temperature, etc. The purpose of this study is to investigate the optimal synthesis conditions of zinc white produced. A randomized complete block design suggested by G.E.P. Box and K.B. Wilson was applied for this purpose. Basic zinc carbonate was prepared by reacting zinc sulfate and sod. carbonate solution in this study. Zinc white comes when prepared by calcination of basic zinc carbonate. The optimum synthesis conditions of zinc white obtained from this study is as follows: 1) The reacting temperature range is: 92-100$^{\circ}C$, 2) The concentration of reactant solution is 23.6-27%, 3) The optimum mole-ratio: [ZnSO4]/[Na2CO3] is 1.74~1.96, 4) The washing water temperature is 36$^{\circ}C$, 5) The drying temperature range is 68-74$^{\circ}C$, 6) The calcination temperature is 600$^{\circ}C$. The outcome of DSC indicated a desolvation of basic zinc carbonate occurred at about 133.3$^{\circ}C$. The dehydration of the compound ceased at about 267.9$^{\circ}C$ and the decarboxylation ceased at about 379.9$^{\circ}C$. The physical and chemical properties of zinc white as medicine were studied by use of Volume Test.

• Membrane and Water Treatment
• /
• 제9권1호
• /
• pp.43-51
• /
• 2018

Hollow fiber (HF) membranes are gaining wide interest over flat membranes due to their compaction and high area to surface volume ratio. This work addresses the fabrication of HF from polysulfone (PS) and polyethersulfone (PES) using N-methylpyrrolidone (NMP) as solvent in addition to other additives to achieve desired characteristics. The semi-pilot spinning system includes jacketed vessel, four spinneret block, coagulation and washing baths in addition to dryer and winder. Different parameters affecting dry-wet spinning phase inversion process were investigated. Dope compositions of PES, NMP and polyvinyl pyrrolidone (PVP) of varying molecular weights as additive were addressed. Some critical parameters of importance were also investigated. Those include dope flow rate, air gap, coagulation & washing baths and drying temperatures. The measured dope viscosity was in the range from 1.7 to 36.5 Pa.s. Air gap distance was adjusted from 20 to 45 cm and coagulation bath temperature from 20 to $46^{\circ}C$. The HF membranes were characterized by scanning electron microscope (SEM), atomic force microscope (AFM) and mechanical properties. Results indicated prevalence of finger like structure and average surface roughness from about 29 to 78.3 nm. Profile of stress strain characteristics revealed suitability of the fibers for downstream interventions for fabrication of thin film composite membrane. Different empirical correlations were formulated which enable deeper understanding of the interaction of the above mentioned variables. Data of pure water permeability (PWP) confirmed that the fabricated samples fall within the microfiltration (MF)-ultrafiltration (UF) range of membrane separation.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 추계 학술발표회 논문집
• /
• pp.517-520
• /
• 2006

The production of recycling aggregate is used to process in the crushing that recycling aggregate isn't perfect the concrete aggregate in Korea. This study is examine to the properties of recycling aggregate used method of trituration. Test item is the fineness, density and percent of absorptance, solid volume percentage of aggregate. The result is that first, the method of trituration is excellent to increase the time of trituration and steel ball but decrease washing water. Second, method of trituration is improve to the properties of recycling aggregate but aggregate of production is irregularity. And method of trituration have to study of the many test items.

• 한국의류산업학회지
• /
• 제3권5호
• /
• pp.455-465
• /
• 2001

Assessing soil removal is of interest to the washing machine industry because of government-mandated energy savings and changes in detergent formulation and consumer laundry practices. We designed this study to examine the laundry process from a holistic perspective by integrating factors perceived to be of importance. Our purpose was to assess the impact of selected variables (fabric and soil type, wash temperature and time. detergent amount, and degree of agitation) on soil removal using accelerated laundry conditions. We used the Taguchi method to develop the research design and ANOVA to analyze the data. Although soil removal was affected by fabric type, soil type, type and amount of detergent, degree of agitation, wash time and temperature, and water hardness and volume, wash temperature was the most significant variable.

• 약학회지
• /
• 제45권1호
• /
• pp.23-28
• /
• 2001

Hydrotalcite was prepared by reacting with sodium carbonate, magnesium hydroxide and aluminum chloride solutions in this study. The optimum synthesis conditions based on the yield of the product were established by applying Box-Wilson experimental design. It was found that the optimum synthesis conditions of hydrotalcite were as follows ; reacting temperature : 63~9$0^{\circ}C$, concentration of reactant solution : 18.20~19.82%, molar concentration ratio of two reactants [Mg(OH)$_2$] / (AICl$_3$.6$H_2O$) : 6.0, temperature of washing water : 29.0-34.4$^{\circ}C$, drying temperature : 56-77.6$^{\circ}C$. The physicochemical properties of hydrotalcite as medicine were studied by use of chemical analysis, bulk volume test and acid consuming capacity measurements.

• 약학회지
• /
• 제43권6호
• /
• pp.689-695
• /
• 1999

Hydrotalcite was prepared by reacting with sodium carbonate, magnesium oxide and aluminum sulfate solutions in this study. The optimum synthesis conditions based on the yield of the product were established by applying Box-Wilson experimental design. It was found that the optimum synthesis conditions of hydrotalcite were as follows; reacting temperature : 48~63$^{\circ}C$, concentration of reactant solution : about 20%, molar concentration ratio of two reactants [MgO]/[Al. sulfate] ; 7.35~8.1, temperature of washing water : 34.4~37.4$^{\circ}C$, drying temperature : 74~81.5$^{\circ}C$. The physicochemical properties of hydrotalcite as medicine were studied by use of chemical analysis, D.S.C. thermogram, bulk volume test and acid consuming capacity measurements.