• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.48 no.10
• /
• pp.1279-1286
• /
• 1999

In conventional GPS/DR integration schemes, the GPS position (or pseudo-range) information is used in calibrating DR sensors. In those schemes, however, an inaccurate calibration may degrade the position accuracy when the GPS measurement is not available. This paper presents a new integration scheme where the GPS velocity information is used in calibrating DR sensors. Also proposed is a new error model of DR sensors for calibrating the bias error and the tilt error in dynamic environments. The proposed model makes it possible that the errors of both the DR sensor parameters and the velocity are calibrated using the GPS carrier-based velocity(or the pseudo-range rate) measurement while the DR position error is calibrated using the GPS position measurement. Since the DR sensors are calibrated accurately, the positioning accuracy is drastically improved when the GPS measurements are unavailable.

• Journal of Navigation and Port Research
• /
• v.38 no.6
• /
• pp.577-583
• /
• 2014

A ship-to-ship (STS) lightering operation takes place in order to transfer cargo (e.g. crude oil or petroleum products) between an ocean-going ship and a service ship alongside it. Instrumental measurements to accurately determine the relative speeds and distances during the approach between the vessels would benefit the operational safety and efficiency. A velocity information GPS (VI-GPS) system, which uses the instantaneous velocity measures from carrier-phase Doppler measurement, has been applied in a field observation onboard a service ship (Aframax tanker) approaching a ship-to-be-lightered (VLCC) in open waters. This article proposes to apply VI-GPS as the input sensor to a guidance and decision-support system aiming to provide accurate velocity information to the officer in charge of an STS operation. A method for precise velocity measurement using VI-GPS was described and the measurement results were compared each other with the results of Voyage Data Recorder (VDR) and VI-GPS that showed the concept of a guidance and decision-support system applying VI-GPS with the field test results during STS operations. Also, it turned out that VI-GPS has sufficient accuracy to serve as an input sensor from the field test results.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.13 no.3
• /
• pp.342-347
• /
• 2003

It is essential to develop an algorithm for the estimate of link travel velocity and for the supply and control of travel information in the context of intelligent transportation information system. The paper proposes the fuzzy logic based prediction of link travel velocity. Three factors such as time, date and velocity are considered as major components to represent the travel situation. In the fuzzy modeling, those factors were expressed by fuzzy membership functions. We acquire position／velocity data through GPS antenna with PDA embedded probe vehicles. The link travel velocity is calculated using refined GPS data and the prediction results are compared with actual data for its accuracy.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.6
• /
• pp.603-607
• /
• 2008

This paper proposes a fast acquisition method using INS velocity and multiple correlators for high speed vehicles. In order to reduce acquisition time in GPS receiver, the method utilizes inertial velocity information and multiple correlators. Search range of the Doppler frequency is reduced by using INS velocity and the number of cells at one search can be increased by using multiple correlators. By using both multiple correlators and the INS velocity in the acquisition, search space can be greatly reduced. Experimental results show that the method gives faster signal acquisition performance than the conventional method.

• Journal of Navigation and Port Research
• /
• v.33 no.2
• /
• pp.99-104
• /
• 2009

The Kinematic GPS is well known to provide a quite good accuracy of positioning within an level. Although kinematic GPS assures high precision measurement on the basis of an appreciable distance between a reference station and an observational point, it has measurable distance restriction within 20 km from a reference station on land. Therefore, it is necessary to make out a simple and low-cost method to obtain accurate positioning information without distance restriction In this paper, the velocity integration method to get the precise velocity information of a ship is explained. The experimental results of Zig-zag maneuver and Williamson turn as the ship's maneuvering test, and other experimental results of ship's movement during leaving and entering the port with low speed were shown. From the experimental results, ship's course, speed and position are compared with those obtained by kinematic-GPS, velocity integration method and dead reckoning position using Gyro-compass and Doppler-log.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2006.10a
• /
• pp.49-55
• /
• 2006

Kinematic GPS provides quite good accuracy of position in cm level. Though K-GPS assures high precision measurement in cm level on the basis of an appreciable distance between a station and an observational point, but it has measurable distance restriction within 20 km from a reference station on land. So it is necessary to make out a simple and low-cost method to obtain accurate positioning information without distance restriction. In this paper, the velocity integration method to get the precise velocity information of ship is explained. Next two experimental results (Zig-zag maneuvering test and Williamson turn) as the ship's maneuvering test and also the experimental results of leaving and entering port as slow speed ship's movement were shown. In these experimental results, ship's course, speed and position are compared with those obtained by kinematic-GPS, velocity integration method and dead reckoning position using Gyro-compass and Doppler-log.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.8
• /
• pp.739-745
• /
• 2006

This paper presents performance improvement of the INS velocity-adided GPS carier tracking loop. To this end, INS velocity-aided GPS carrier tracking loop was modeled as a feedfoward and a feedback loop system. In the phase tracking loop, it was shown that the tracking error caused by the dynamic motion of the vehicle can be compensated with the aiding of the INS information irrespective of the loop order and bandwidth. However, the signal trcking error increases as the INS error increases. It was also shown that in order to remove the tracking error caused by INS bias error, more than or equal to 2nd order PLL should be used. Experiments were carried out and the experimental results were compared with the analysis results.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.11
• /
• pp.159-166
• /
• 2012

There are several ways such as GPS(Global Positioning System) and INS (Inertial Navigation System) to track the location of moving vehicle. The GPS has the advantages of having non-accumulative error even if it brings about errors. In order to obtain the position information, we need to receive at least 3 satellites information. But, the weak point is that GPS is not useful when the 혠 signal is weak or it is in the incommunicable region such as tunnel. In the case of INS, the information of the position and posture of mobile with several Hz~several hundreds Hz data speed is recorded for velocity, direction. INS shows a very precise navigational performance for a short period, but it has the disadvantage of increasing velocity components because of the accumulated error during integration over time. In this paper, sensor fusion algorithm is applied to both of INS and GPS for the position information to overcome the drawbacks. The proposed system gets an accurate position information from experiment using SVD in a non-accessible GPS terrain.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.20 no.4
• /
• pp.497-502
• /
• 2010

The accurate estimation of position and direction of the mobile robot is essential for preparing precise movement and works in the inner complex environment. In this paper, we propose a robust estimation method of location and direction using the velocity of mobile robot in the inner GPS environment. The estimation using the inner GPS with ultrasonic sensors have to consider with various acoustic noise and sensor errors. We design a robust estimation method using a membership function based on uncertainty of the obtained information and robot velocity. The simulation results of the proposed method show effectiveness in the contaminated environment with position errors.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1524-1529
• /
• 2003

In this paper deals with a unique method for measuring vehicle states such as body sideslip angle and tire sideslip angle using GPS velocity information in conjunction with other sensors. A method for integrating Inertial Navigation System (INS) sensors with GPS measurements to provide higher update rate estimates of the vehicle states is presented, and the method can be used to estimate the tire cornering stiffness. The experimental results for the GPS velocity-based sideslip angle measurement and cornering stiffness estimates are compared with the theoretical predictions. From the experimental results, it can be concluded that the proposed method has an advantage for future implementation in a vehicle safety system.