• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.1
• /
• pp.19-26
• /
• 2012

Soils exhibit creep behavior in which deformation and movement proceed under a state of constant stress or load. In this study, A series of triaxial tests were performed under constant principal stress in order to interpret the undrained creep characteristics of silty sands. Although samples are non-plastic silty sands, the results of tests show that the creep deformation increasing over time. Based on the results of test, Singh-Mitchell model parameters and Generalized model coefficients were calculated. Generalized model showed slightly larger deformation in the primary creep range but secondary creep deformation was almost identical. Although Singh-Mitchell model showed relatively large errors compared to Generalized model because it uses the average of test results, but Singh-Mitchell model can be easily represented by three creep parameters.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.09a
• /
• pp.73-78
• /
• 2000

The reinforced soil has been widely used for constructing retaining walls and embankment with steep slope. However, the benefits of soil reinforcing are often-restricted by a lack of good quality backfill material. In this study, plane strain compression tests were carried out to study the effects of preloading on the behavior of geosynthetic-reinforced saturated clay. For the unreinforced and reinforced soil, drained and undrained shearing tests were peformed after anisotropic consolidation in a constant strain rate. A preoading test was carried out by preloading, creep, unloading, aging and undrained shearing after anisotropic consolidation(K=0.3, σ'₃=50 kPa). It was observed that a reinforced clay, Kanto loam, can have a great initial secant modulus in undraind condition by well compaction and over consolidation. The results shown that the increasing of drained strength should be used to apply a large preloading in the case of reinforced clay.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.311-317
• /
• 2008

This study was carried out to improve our understanding about the influence of silt content on the stress-strain of sand under cyclic loading. Soil specimens were prepared by wet-tamping method as same void ratio and specimen's silt contents on total weights was changed from 0% to 20%. Also, effects of the silt contents on the stress-strain response were studied at different anisotropic consolidation ratio, Kc=1.0, 1.5, 2.0 condition. As a result, cyclic shear strength decreased as silt contents increased in same stress ratios. In same silt contents, cyclic shear strength increased as Kc increased in lower silt contents, but in higher silt contents, it had reverse results.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.681-686
• /
• 2006

This study is to examine slope activity safety ratio on the strength of the natural sample or soil collected through field test in the slope activity region during destruction happened in the course of soil-relocating work planned for ground improvement under strict supervision at the house-building site, using Bishop's slope analysis method and investigate relationship between slope analysis theories and actual destruction so as to compare determining method of clean water of soil essential for slope activity analysis and accuracy of resulting value of clean water of soil.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.1047-1054
• /
• 2005

The purpose of this study is the understanding to changes in the characteristic of soil structure and classification, atterberg limits, undrained shear strength and consolidation of clayey soil dependent on pH of soil pore water. A series of tests including consistency tests, uniaxial compressive tests, vane tests and oedometer tests are performed on. The test results indicated that pH changes in the soil pH resulted in changes in the soil structure and classification, stress-strain behavior. Specially, when pH is conditioned to 7, liquid limit, undrained shear strength and preconsolidation pressure are the largest.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.1245-1251
• /
• 2005

The deformation modulus is an important variable which can be used to predict settlement of structures, analyze horizontal directions of piles and design roads. Though to predict deformation modulus relationships using standard penentration test N-value and undrained shear strength were suggested , these relationships are not appropriate in domestic areas because these relationships are based on foreign areas. Therefore, in this study, with field test results, reasonable equations in domestic area are suggested to estimate deformation modulus.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2001.03a
• /
• pp.175-182
• /
• 2001

The PMT test results are compared with other in situ test such as Standard Penetration Test (SPT), Cone Penetration Test (CPT), Field Vane Test (FVT) and the laboratory test in order to investigate the correlationships for the strength parameters obtained from Busan and Incheon areas. Many proposed correlation formulas also make a comparative study and new correlation formulas for domestic soils are introduced. Limit pressure ( $P_1$) could be determined by P-log($\Delta$V/V) and Relative volume Method. PMT for the granular soils showed relatively high correlation with SPT, while CPT has good correlation with PMT for cohesive soil. The predicted undrained shear test ( $S_{u}$) by the PMT test results for Incheon and Busan samples showed low correlativity with proposed equations, therefore, new correlation formulas are proposed for domestic soils.s.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2001.03a
• /
• pp.215-222
• /
• 2001

Uncertainty study of shear strength characteristics of the marine clays was carried out based ell In-situ tests and laboratory tests on tile south-east coastal region of the Korean peninsula. Theoretical analyses were studied using both tile spherical cavity expansion theory in finite soil mass and the strain path method to determine tile cone factor using the undrained shear strengths obtained by in-situ tests, and the empirical methods in accordance with the ultimate resistance theory were also discussed. Analysis show that the empirical methods suggest more reasonable value than that of theoretical methods in terms of comparing the cone factor estimated using linear regression and frequency distribution analyses. The cone factors obtained by the empirical methods are 18, 15, and 6 respectively, from the results of total cone resistance, effective cone resistance, and excess porewater cone resistance method, and the estimated were similar to those of previous researcher's.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1992.10a
• /
• pp.145-148
• /
• 1992

This paper reports the application of field tests to weak ground. In this study, field and laboratory tests were performed in the west seashore of KOREA(Ildo, Sore, Kunsan, Youngam). Applied tests are standard penetration test, cone penetration test, dilatometer test, field vane test, unconsolidated undrained test, oedometer test and other fundametal material properties tests. The results of in-situ test are used to estimate soil types and undrained shear strengths of five clay local deposits. SPT results showed low reliability and FVT war also demonstrated the best field test to weak clayey deposits.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.4
• /
• pp.137-143
• /
• 2003

The initial condition of $\Delta \sigma_3 \;=\; \Delta u$ is used for analyzing the time dependent behavior of ground. This is based on the concept that the coefficient of pore water B is the unity on the condition of saturation. but some measured consolidation data in the field showed that the pore water pressure was not dissipated as time elapsed but it was maintained constant value or it's dissipation rate was slower than that of the predicted. and so the measured data of pore water pressure was not consistent with that of settlement. In this study, the rheological model for the pore water pressure behavior on undrained condition was induced and compared with the experiment data of the literature. The result showed that the suggested model was consistent well with the result of experiment, but the suggested model could not explain the effect of the decrease of void ratio according to consolidation.