• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.11
• /
• pp.972-977
• /
• 2016

This paper introduces development process and results of HF & UHF band(13.56 MHz, 920 MHz) tag antennas using a single-side printing method on a PE film. The size of tag antenna is designed in the area of $80mm{\times}50mm$, little bit smaller than a credit card. The UHF tag antenna, $76mm{\times}44mm$, is located at the outside of the card size tag antenna, and the HF tag antenna, $40 mm{\times}42 mm$, is located at the center of the UHF tag antenna. The UHF and HF tag antennas are designed with consideration of coupling effects. The single-side printing method with a jumper structure without using a via is used to make a loop antenna of HF tag antenna. The reading range of UHF tag antenna is about 6m, and the reading of HF tag antenna is about 5 cm. The designed tag antennas have long enough reading ranges for both bands. The tag is applicable to logistics and authentification.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.7
• /
• pp.1056-1060
• /
• 2012

Online monitoring system is becoming an essential element of railway traction system for utilized to condition based malignance management and various techniques currently employed in railway traction system. Among the various techniques, it is efficient to detect partial discharge signals by electromagnetic wave detection in order to detect insulation fault of rectifier. Although VHF (Very High Frequency), UHF (Ultra High Frequency) sensors were adopted to detect partial discharge of power facilities, due to characteristics of urban railway, excessive noise occurs from 500 MHz to 1.5 GHz on UHF bandwidth. In this paper a new measurement system able to monitoring the conditions of power facilities on DC substation in metro was studied and set up. The system uses UHF sensors to measure the partial discharge of the rectifier due to electric faulting and dielectric breakdown. Comparison and estimation for performance of SHF sensor which had devised to detect partial discharge signal of urban railway rectifier has conducted. In order to estimate performance of SHF sensor, we have compared the sensor with existing UHF sensor on sensitivity upon frequency bandwidth generated by pulse generator, and also we have verified performance of the SHF sensor by detection results of partial discharge signal from urban railway rectifier.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.3C no.6
• /
• pp.224-229
• /
• 2003

An ultra high frequency (UHF) coupler possessing ultra wide band (UWB) characteristics ranging from hundreds of MHz to several GHz is desirable for the detection of the partial discharge (PD) pulses because the pulses propagate with rise time shorter than one nanosecond in a gas-insulated substation (GIS). Thus, the authors have proposed a log-periodic antenna for GIS PD detection. Various parameters of the coupler such as frequency bandwidth, coupler gain, radiation pattern, and coupler geometry were considered throughout the simulations. The experiments for the detection characteristics of the coupler were carried out in the mock-up GIS chamber. The results indicated that the detection characteristics of the coupler are dependent on the installation angle of the coupler, the position of the coupler in the hand hole and the existence of the spacer.

• Journal of the Korea Society of Computer and Information
• /
• v.23 no.1
• /
• pp.1-7
• /
• 2018

The Korean Air Force FA-50 aircraft currently operating in the Air Force is using Ultra High Frequency (UHF) frequency communications for navigation communications with ground control stations or other aircraft. The pilot communicates by changing frequency at any time during flight, and performs communication by directly inputting from the Integrated Up-Front Controller installed in the cockpit. The frequency is designated as secret, and the pilot receives the task with the frequency channel number (001~xxx) and finds the frequency of the channel in the list of 4,000 frequency channels and inputs it manually. This reduces the safety and convenience of pilots' operations and exposes them to hazards that may occur especially during night flight missions. In this paper, we propose a function to embed the frequency corresponding to the frequency channel list in IMDC, the aircraft mission computer, and to automatically change the frequency when the pilot only inputs the channel number.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.1857-1859
• /
• 2004

It is widely known that the ultra high frequency (UHF) method that detects the electromagnetic wave of the PD pulses in the gas insulated space is one of the most competitive methods for its high sensitivity. From the above point of view, this paper describes the noise suppression methods and the PD measurement results of the in-service substation by the developed UHF PD measurement system which consists of the external UHF coupler, the UWB LNA and the digital storage oscilloscope. As results, it was found that the effect of the noise suppression methods were verified and that the developed external UHF coupler showed a better detection sensitivity than a conventional external coupler.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.1915-1917
• /
• 2000

Laboratory experiments and on site measurements were conducted to detect partial discharges in GIS(Gas Insulated Switchgear) using the UHF(Ultra High Frequency) technique that has been applied many places in the world. Experimental results were in good agreement with calculation in locating a partial discharge source using mock-up GIS. Defect type and its location were inferred after a measurement on 345 kV GIS that showed some abnormal phenomenon. Precise examination inside the GIS coincided with the results inferred from the measurement. High reliability of UHF technique for site application was confirmed.

• Journal of the Institute of Convergence Signal Processing
• /
• v.19 no.3
• /
• pp.89-96
• /
• 2018

This study aims to develop a fully passive smart sensing tag utilizing RF (Radio Frequency) energy harvesting technology at UHF (Ultra High Frequency) band of 915MHz. To optimize the power collected under various radiated conditions, an efficient energy harvesting module exploiting a boost circuit with maximum power point tracking (MPPT) is employed. Specifically, the proposed tag features two orthogonal antennas to enhance its capability of both energy scavenging and data transmissions. The experimental result shows that the developed smart sensor tag can scavenge an RF input power of as low as 0.19mW at a distance of 4 meters for a 3.6Vdc output. Furthermore, the proposed smart sensor tag performs the feasibility of completely autonomous monitoring food freshness at 2 meters with a low-power sensor array.

• Journal of Advanced Navigation Technology
• /
• v.21 no.4
• /
• pp.413-421
• /
• 2017

In this paper, we designed and fabricated a compact UHF receive module for efficient operation such as tactical and operation situation, target location information confirmation, target reset using Link-K(Korean joint tactical data link system). And the effect of target reset was analyzed by simulation. The designed module consists of UHF(ultra high frequency) receiver section, control section, and power distribution section. The UHF receiver section performs frequency down conversion, filtering and automatic gain control, etc. The control section demodulates frequency down-converted signals, extracts information, and performs external interworking. The power distribution section supplies external power, generates and supplies the power required by each section. The fabricated module was dimension of $105{\times}105{\times}80mm$ and weighed 1.10 kg and The receiving distance is more than 50 km.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.1840-1842
• /
• 2000

GIS(Gas Insulated Switchgear) 내부에서 부분방전 신호를 검출 할 수 있는 UHF(Ultra High Frequency) 센서를 제작하고 그 특성을 조사하였다. UHF 센서는 GIS 내부에서 전기적, 기계적으로 안정된 형태로 제작되었으며, 영국의 NGC(National Grid Company)에서 제시한 규격을 충분히 만족함을 확인하였다. 부분방전 신호가 발생되는 모형 GIS 내에 UHF 센서를 장착하여 실제 부분방전 산호가 잘 측정됨을 확인하였다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.12A
• /
• pp.1014-1022
• /
• 2009

In this paper, interference analysis is carried out to obtain the operating criterion and coexistence condition between digital television devices and cognitive radio-based mobile wimax devices in the UHF (Ultra High Frequency) broadcasting frequency bands. To this end, an efficient interfering calculation tool known as SEAMCAT (Spectrum Engineering Advanced Monte-Carlo Analysis Tool) is employed to acquire the coexistence criterions between heterogeneous radio links operating in the same portion of spectrum. As a result, these criterions will be used to achieve interference temperature limit level applied to interference temperature model for analyzing the capacity of cognitive radio receivers accurately.