• Journal of the Microelectronics and Packaging Society
• /
• v.8 no.3
• /
• pp.69-75
• /
• 2001

Photoimageable thick film technology is a new technology in that the lithography process such as exposure and development is applied to the conventional thick film process. Line resolution of 25 $\mu\textrm{m}$ width and 25 $\mu\textrm{m}$ space could be obtained by laminating green sheet, printing photoimageable Ag paste, exposing the test patterns, developing, and co-firing. In case of using the alumina substrate, 20 $\mu\textrm{m}$ fine line could be also obtained by similar process. Test results showed that exposing power density and developing time were the most important processing parameters for the fine line formation. Microstrip and series gap resonators with well-defined line morphology and good transmission characteristics in high frequency were formed by this new technology, and thereby dielectric constant and loss of test substrate were calculated.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.1
• /
• pp.139-150
• /
• 1997

For high-speed networks, a new ring protocal is proposed in this paper. A ring network combined with destination removal can achieve much higher network throughput than the channel transmission rate. However, such a network exhibits fairness problems. Over a past few years, global fairness algorithms such as ATMR and Metaring have been proposed to solve such problems. But the ring access time delay and fairness in such networks are sensitive to the network parameters such as network size and traffic distribution. In addition to guaranteeing fair ring access to all nodes, there are several other important performance aspects in such networks. The one is that fairness is enforced while node throughputs are kept as high as possible. And another performance measure is access delay and more specifically Head-Of-Line(HOL) delay, i.e., the amount of time the first cell in the transmission buffer of a node has to wait before it accesses the ring. HOL delay is a mijor component in the transmission jitter of the synchronous traffic transmission. A key idea of the proposed ring protocol is to find the nodes that have much more chances to access the ring than any other nodes in the independently distributed node architecture. Since destined by many cells need to share a part of the bandwidths with the next node for the fairness in as much as performance degradation does not become critical. To investigate the performance behavior of the proposed ring protocol for various network condition,s several performance parameters wuch as ring access time delay, and throughput are compared with those of the ATMR and Metaring protocols using simulation package, SIMAN.

• Journal of electromagnetic engineering and science
• /
• v.4 no.4
• /
• pp.162-167
• /
• 2004

In this paper, optimal position of optical phase conjugator(OPC) for best compensating distorted WDM channels due to both chromatic dispersion and self phase modulation(SPM) is numerically investigated, and the compensation characteristics of overall WDM channels at this position is investigated, comparing with that in case of OPC placed at mid-way of total transmission length. It is confirmed that the compensation extents in WDM system with OPC is more improved by the shifting OPC position from the mid-way of total transmission length. And, we confirmed that the optimal position of OPC must be selected to the position decreasing not only eye opening penalty(EOP) of overall WDM channels but also EOP deviation between WDM channels, and this OPC position should be altered as various system parameters such as modulation format, and fiber dispersion, etc. Using proposed configuration, it is possible to remove all in-line dispersion compensator, reducing span losses and system costs.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.39-44
• /
• 2005

A broadband DC to 40 GHz 5-bit MMIC digital attenuator has been developed. The ultra broadband attenuator has been achieved by newly inserted the transmission lines in conventional Switched-T attenuator and the optimization of the transmission line parameters. Momentum was employed in design for an accurate performance prediction at high frequencies and Monte Carlo analysis was applied to verify performance stability against the MMIC process variation. The attenuator has been fabricated with 0.15 $\mu$m GaAs pHEMT process. This attenuator has 1 dB resolution and 23 dB dynamic range. High attenuation accuracy has been achieved over all attenuation range and full 40 GHz bandwidth with the reference state insertion loss of less than 6 dB at 20 GHz. The input and output return losses of the attenuator are better than 14 dB over all attenuation states and frequencies.

• International Journal of Control, Automation, and Systems
• /
• v.3 no.spc2
• /
• pp.346-354
• /
• 2005

This paper presents a new approach to Thyristor Controlled Phase Shifter (TCPS) control. In this paper we have proposed a nonlinear coordinated generator excitation and TCPS controller to enhance the transient stability of a power system. The proposed controller is able to control three main parameters affecting a.c. power transmission: namely excitation voltage, phase angle and reactance in a coordinated manner. The TCPS is located at the midpoint of the transmission line. A nonlinear feedback control law is proposed to linearize and decouple the power system. The design of the proposed controller is based on the local measurements only. Simulation results have been shown to demonstrate the effectiveness of the proposed controller for the enhancement of transient stability of the power system under a large sudden fault.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.2
• /
• pp.139-143
• /
• 1988

A new measurement method of coupled transmission line characteristics is described. This method presents precision values of even-and odd-mode impedances as well as effective dielectric constants of symmetric parallel coupled microstrip lines from the scalar quantities obtained by transmission coefficients at two different resonance frequencies. Especially these values include dispersion effects in the measured frequency band. The measured impedances and effective dielectric constants of actually fabricated coupled lines on the Teflon substrates with low dielectric constants are good agreement with predicted values. And the experimental pass band characteristics of single section resonator by using previously designed coupled lines agree well with theoretical values.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.30A no.11
• /
• pp.40-47
• /
• 1993

In this paper, a method for analyzing coaxial collinear antenna for base station of mobile communications using the moment method and the transmission line theory is presented. The excited voltages at the junctions between elements are expressed as the matrix with transmission parameters and these voltages are applied to the integral equation for calculating current distribution. Here, the current distributions, input admittances, radiation patterns and gains are calculated. Calculated values of the current distributions and the input admittances show good agreement with measured values. In case of beamtilted collinear antenna, radiation pattern is simialar to measured result except side lobe.

• Journal of Communications and Networks
• /
• v.15 no.6
• /
• pp.614-634
• /
• 2013

The proliferation of real-time multimedia services requires huge amounts of data transactions demanding strict quality-of-service (QoS) guarantees. Multicast transmission is a promising technique because of its efficient network resource utilization. However, high head-of-line (HOL) blocking probability and lack of service-specific QoS control should be addressed for practical implementations of multicast networks. In this paper, a topology aware fanout set division (TAFD) scheme is proposed to resolve these problems. The proposed scheme is composed of two techniques that reduce HOL blocking probability and expedite packet delivery for large-delay branches regarding multicast tree topology. Since management of global topology information is not necessary, scalability of the proposed scheme is guaranteed. Mathematical analysis investigates effects of the proposed scheme and derives optimal operational parameters. The evaluation results show that the TAFD scheme achieves significant delay reduction and satisfies required delay bounds on various multicast networks.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.5
• /
• pp.2070-2076
• /
• 2015

Nano composite materials were multi-constituent combinations of nano dimensional phases with distinct differences in structure, chemistry and properties. Nano particles were less likely to create large stress concentrations and thereby can avoid the compromise of the material ductility while improve other mechanical properties. Corona discharge was an electrical discharge. The ionization of a fluid surrounding a conductor was electrically energized. This discharge would occur when the strength of the electric field around the conductor was high enough to form a conductive region, but not high enough to cause electrical breakdown or arcing to nearby objects. This paper shows all the studies done on the preparation of nano fillers. Special attention has given to the ACSR transmission line conductor, TiO₂ nano fillers and also to the evaluation of corona resistance on dielectric materials discussed in detail. The measurement of the dielectric properties of the nano fillers and the parameters influencing them were also discussed in the paper. Corona discharge test reveals that in 0%N ACSR sample corona loss was directly proportional to the applied line voltage. No significant change in corona loss between 0%N and 1%N. When TiO₂ nano filler concentration was increased up to 10%N fine decrement in corona loss was found when compared to base ACSR conductor, corona loss was decreased by 40.67% in 10%N ACSR sample. It was also found from the surface conditions test that inorganic TiO₂ nano filler increases the key parameters like tensile strength and erosion depth.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.214-222
• /
• 2008

The equivalent circuit for the RLH-TL is proposed considering radiation effects due to the inclusion of a series capacitor and shunt inductor in a unit cell for the right/left-handed transmission line(RLH-TL). The design equations to realize a specific phase shift at a given frequency is also provided. The S-parameters for unit cells with N=1, 3, 5, and 10 are analyzed in various aspects based on the EM and circuit simulations especially for the purpose of controlling radiation along RLH-TL's. A modification formula for the radiation rate per unit cell is also proposed for good agreement between the EM and circuit simulation results.