• Journal of the Korean Society of Physical Medicine
• /
• v.11 no.4
• /
• pp.49-54
• /
• 2016

PURPOSE: The purpose of this study was to determine the effect of different frequencies (4Hz and 100Hz) of transcutaneous electrical nerve simulation (TENS) on pain relief using c-fos expression in the spinal cord of rat osteoarthritis to investigate the appropriate frequency for pain relief. METHODS: Total of 30 Sprague-Dawley rats was used and randomly divided 2 groups according TENS frequency and applicate the TENS during 3 period (3 days, 7 days, 10 days). The induction of osteoarthritis by 3mg monosodium iodoacetat was injected into the right knee joint of rats. Three days later, commercially available TENS unit was used for stimulation was set to 20minutes on 3, 7, 10 days after surgery. Western blot analysis system was used to detect immunoreactive proteins. The thickness of the bands were photographically measured by Scion Image. RESULTS: When investigating the c-fos expression of TENS on spinal cord in OA knee over 10 days, between-groups differences in c-fos expression reached a significant level by day 10. For within-groups comparisons, the c-fos expression decreased significantly across days in low- and high-frequency TENS groups. CONCLUSION: Whether at low- and high-frequency, the TENS as a therapy obtained beneficial effects of pain relief and TNES at high-frequency is more beneficial effects on the pain relief when TENS applied at injury site.

• Publications of The Korean Astronomical Society
• /
• v.15 no.1
• /
• pp.61-86
• /
• 2000

Radio astronomy, on its part, requires 'quiet zones' to be able to receive incoming cosmic signals unaffected by interference to enable astronomers and others learn about universe. The agenda item 1.16 of WRC-2000 contains a number of issues relevant for radio astronomy, but some of them are more important than others. The preparations for WRC-2000 have reached a close-to-final stages, with a number of proposals to this agenda item submitted to the ITU by many countries and groups of countries, like APT, CEPT and CITEL. There is no clear preference to anyone of these proposals since their differences are only minor. However, several points remain to be solved in the APT and CITEL. Fortunately, the preparation went very well, and consensus was reached on allocations above 71 GHz and three resolutions. The radio astronomy has obtained about 100 GHz of new spectrum allocations in bands above 71 GHz. In addition, a new resolution was approved by plenary meeting of WRC-2000. It deals with the consideration by a future WRC of sharing and compatibility issues between passive and active services in adjacent bands particularly with the space services (downlinks) into radio astronomy above 71 GHz. Therefore, in future, there should be a need for studies to be made to determine if and under what conditions sharing is possible, given that modifications were made on the basis of requirements known now and that little was known of requirements and implementation plans for active services in bands above 71 GHz.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.177-183
• /
• 2019

In this paper, we proposed an application method of ICA (Independent Component Analysis) to passive line array sonar to separate interferences from target signals in low frequency band and compared performance of three conventional ICA algorithms. Since the low frequency signals are received through larger bearing angles than other frequency bands, neighboring beam signals can be used to perform ICA as measurement signals of the ICA. We use three ICA algorithms such as Fast ICA, NNMF (Non-negative Matrix Factorization) and JADE (Joint Approximation Diagonalization of Eigen-matrices). Through experiments on real data obtained from passive line array sonar, it is verified that the interference can be separable from target signals by the suggested method and the JADE algorithm shows the best separation performance among the three algorithms.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.4
• /
• pp.381-391
• /
• 2010

In this paper, a novel frequency reconfigurable active array antenna(RAA) system, which can be reconfigurable for three reconfigurable frequency bands, is proposed by using commercial RF MEMS switches. The MEMS switch shows excellent insertion loss, linearity, as well as isolation. So, the system performance degradation of the reconfigurable system by using MEMS switches can be minimized. The proposed frequency reconfigurable active antenna system is consisted with the noble frequency reconfigurable front-end amplifiers(RFA) with the simple reconfigurable impedance matching circuits(RMC), reconfigurable antenna elements(RAE), as well as a reconfiguration control board(RCB) for MEMS switch control. The proposed RAA system can be reconfigurable for three frequency bands, 850 MHz, 1.9 GHz, and 3.4 GHz, with $2{\times}2$ array of the RAE having broadband printed dipole antenna topology. The validity of the proposed RFA as well as RAA is also presented with the experimental results of the fabricated systems.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.40 no.3
• /
• pp.156-163
• /
• 2003

Most watermarking techniques insert watermarks into transform coefficients in the frequency domain because we can consider robust or imperceptible frequency bands against malicious attacks to remove them. However, parameterization of 3-D data is not easy because of irregular attribution of connectivity information, while 1-I) or 2-D data is regular. In this paper we propose a new watermarking scheme for 3-D polygonal mesh models in the DCT domain. After we generate triangle strips by traversing the 3-D model and transform its vertex coordinates into the DCT domain, watermark signals are inserted into mid-frequency bands of AC coefficients for robustness and imperceptibility. We demonstrate that our scheme is robust against additive random noise, the affine transformation, and geometry compression by the MPEG-4 SNHC standard.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.30 no.1
• /
• pp.16-30
• /
• 1997

Application of digital filter to the wave analysis is studied using the observed data by wave gauge. Sea wave data obtained from wave gauge always include long wave frequency components. In order to estimate the sea wave parameters, we must re-analyzed wave data by using a digital filter and the concept of mean sea level correction method. By the wave by wave analysis and spectral methods, sea wave parameters on the basis of wave data obtained by the conventional method and digital filter are compared. The best-fitted design filter determined by the necessary conditions of frequency responses, can be obtained by calculating various transfer functions. Thus, to get the best the digital filter design, both Butterworth filter and Savitzky-Golay filter of digital filter are used in the frequency and time domain, respectively. Three cases of observation wave data are calculated by applying digital filter. The components of different frequency bands in the surf zone are coexisted in three cases. The wave data for wind wave components is computed using the digital filter the surf zone and off-surf zone, and based on the filtered data, wave parameters are calculated by the spectral analysis and wave by wave analysis methods, respectively. As a results, when sea wave data observed by wave gauge are analyzed, the Savitzky-Golay method is recommended which can well appear cut-off frequency by experimental choosing filter length in the time domain. The better mean sea level correction method is the Butterworth filter in the frequency domain.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.5
• /
• pp.461-463
• /
• 1996

The laser-induced fluorescence excitation spectrum of 7-amino-4-(trifluoromethyl)coumarin in a supersonic jet has been recorded in the 340-352 nm region. The electronic band origin was observed at 28622.8 cm-1. Vibrational assignments for the three fundamental low-frequency modes and eight combination bands have been made for the S1 electronic excited state. The out-of-plane vibrations of this molecule have been characterized from the low-frequency assignments of the spectrum. The periodic potential energy function for the CF3 torsion, which satisfactorily fits the observed data, were also determined to be V(Φ)=95X(1-cos3Φ)-32X(1-cos6Φ) where Φ is the torsional angle. The relatively low torsional barrier of 99 cm-1 in S1 state could be explained by the small steric interactions between the functional groups attached to a bicyclic ring.

• Journal of the Ergonomics Society of Korea
• /
• v.15 no.2
• /
• pp.177-184
• /
• 1996

In light-weight hand tools, static posture may result in postural fatigue. Psotural tremor of the upper extremity in a static posture was measured to provide guidelines for hand tool weight. Postural tremor was measured on five levels of tool weitht : no weight, 400g, 800g, 1200g, and 1600g. Three types of camcorder recording postures were selected. For each condition, postural tremor was measured together with ENG of biceps, deltoid and pectoralis major, and Borg's CR-20 ratings of perceved exertion. Results of the experiment are as follows : frequency analysis of tremor revealed increased amplitude of frequency bands of 2-4Hz and 10-14Hz. Postural tremor of the upper extremeity maintained the initial level until fatigue developed. After the development of fatigue, the rate of change of postural tremor significantly increased. Different tool weights and hand postures showed different rates of tremor increase. Time tp fatigue and corresaponding endurance time were positively correlated with Borg's RPE scores.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.12
• /
• pp.4819-4834
• /
• 2015

The spectral efficiency of cellular networks can be improved when proximate users engage in device-to-device (D2D) communications to communicate directly without going through a base station. However, D2D communications that are not properly designed may generate interference with existing cellular networks. In this paper, we study resource allocation and power control to minimize the probability of an outage and maximize the overall network throughput. We investigate three power control-based schemes: the Partial Co-channel based Overlap Resource Power Control (PC.OVER), Fractional Frequency Reuse based Overlap Resource Power Control (FFR.OVER) and Fractional Frequency Reuse based Adaptive Power Control (FFR.APC) and also compare their performance. In PC.OVER, a certain portion of the total bandwidth is dedicated to the D2D. The FFR.OVER and FFR.APC schemes combine the FFR techniques and the power control mechanism. In FFR, the entire frequency band is partitioned into two parts, including a central and edge sub-bands. Macrocell users (mUEs) transmit using uniform power in the inner and outer regions of the cell, and in all three schemes, the D2D receivers (D2DRs) transmit with low power when more than one D2DRs share a resource block (RB) with the macrocells. For PC.OVER and FFR.OVER, the power of the D2DRs is reduced to its minimum, and for the FFR.APC scheme, the transmission power of the D2DRs is iteratively adjusted to satisfy the signal to interference ratio (SIR) threshold. The three schemes exhibit a significant improvement in the overall system capacity as well as in the probability of a user outage when compared to a conventional scheme.

• Korean Journal of Remote Sensing
• /
• v.27 no.2
• /
• pp.191-201
• /
• 2011

Soybean has widely grown for its edible bean which has numerous uses. Microwave remote sensing has a great potential over the conventional remote sensing with the visible and infrared spectra due to its all-weather day-and-night imaging capabilities. In this investigation, a ground-based polarimetric scatterometer operating at multiple frequencies was used to continuously monitor the crop conditions of a soybean field. Polarimetric backscatter data at L, C, and X-bands were acquired every 10 minutes on the microwave observations at various soybean stages. The polarimetric scatterometer consists of a vector network analyzer, a microwave switch, radio frequency cables, power unit and a personal computer. The polarimetric scatterometer components were installed inside an air-conditioned shelter to maintain constant temperature and humidity during the data acquisition period. The backscattering coefficients were calculated from the measured data at incidence angle $40^{\circ}$ and full polarization (HH, VV, HV, VH) by applying the radar equation. The soybean growth data such as leaf area index (LAI), plant height, fresh and dry weight, vegetation water content and pod weight were measured periodically throughout the growth season. We measured the temporal variations of backscattering coefficients of the soybean crop at L, C, and X-bands during a soybean growth period. In the three bands, VV-polarized backscattering coefficients were higher than HH-polarized backscattering coefficients until mid-June, and thereafter HH-polarized backscattering coefficients were higher than VV-, HV-polarized back scattering coefficients. However, the cross-over stage (HH > VV) was different for each frequency: DOY 200 for L-band and DOY 210 for both C and X-bands. The temporal trend of the backscattering coefficients for all bands agreed with the soybean growth data such as LAI, dry weight and plant height; i.e., increased until about DOY 271 and decreased afterward. We plotted the relationship between the backscattering coefficients with three bands and soybean growth parameters. The growth parameters were highly correlated with HH-polarization at L-band (over r=0.92).