• Journal of the Korea Convergence Society
• /
• v.9 no.4
• /
• pp.137-142
• /
• 2018

This paper is studied, as basic research for measuring the accurate fuel amount of the CNG tank by using the transmit-receive ultrasonic sensor, the receiving sensitivity according to changed the pressure inside the tank and the contact surface of the ultrasonic sensor is analyzed. Measurement was carried out while changing the contact surface of the tank and the sensor to three shapes of Point, Line, and Surface and charging the pressure in the tank at an interval of 1 bar from 0 bar to 5 bar. Experiment results, as the pressure in the tank increased the tendency of the received signal value of the ultrasonic sensor to decrease was confirmed. As the contact area between the tank and the sensor increased, the value of the received signal increased, but the noise also increased. The results of experiment, it is judged that accuracy can be improved by changing the contact surface of the sensor.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.18 no.1
• /
• pp.11-15
• /
• 1982

The authors carried out an experiment to find out the response of filefish, Navodon modestus (Gunther), to the colored nets. The experimental tank of dimensions 360L$\times$50W$\times$55H cm was set up in a dark room. Six longitudinal sections, each being 60cm intervals, are marked in the tank to observe locations of the fishes. The depth of water in the tank was 50 cm. Two light bulbs of 30 W, placed at the both ends of the tank, projected the light horizontally into the tank. Two different colored nets selected from seven colors(white, black, gray, red, green, blue, and yellow) were placed 60 cm distance from each side of the tank. The fishes were acclimatized in the dark for 60 minutes before they were employed in the experiment. After the light was turned on, the number of fish in each section of the tank was counted for an hour in every 2 minutes into interval, the mean value of fishes in each section was used as the distribution rate of the fish. The order of colors disliked by fishes was found to be white, red, green, black, blue, yellow and gray. The distribution rate of fish in front of colored net shows a decreasing tendency as the lapse of illumination time increases.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2001.11a
• /
• pp.70-75
• /
• 2001

There is a problem to be solved for improvement of durability and safety for concrete When the waterproofing and anticorrosive work of main concrete are design, the material a of construction need to be correctly applied to appropriate circumstance conditions. Epoxy mostly been used for concrete water tank structure. Lately, lots of subjects on adaption res in mortar for waterproofing and anticorrosive are under discussion. Then, we attempt to approach by evaluating and comparing every capabilities with waterproofing materials in this experiment. Capability evaluation items include the bond age and curing conditions, the bond strength after accelerated weathering test and fret impact resistance, a mount of water, seepage quan Through the experiment analysis, we found that waterproofingtity, drinking water chemicals resistance. and anticorrosive resin mortar used with glass fiber cloth, inorgar material is dominantly superior to other waterproofing materials. According to this paper, we suggest the resin mortar as a new surface treatment material water tank structure.

• Proceedings of the KIEE Conference
• /
• 2003.07a
• /
• pp.280-282
• /
• 2003

In this paper we tried to analyze through the water tank model to solve these kinds of problems about the square plate earth electrode using general facilities with being compared with the theory formula announced before. The square plate earth electrode that haven't investigated so far is analyzed by being based on laid rod electrode. And the each kind of calculation model was investigated with the experiment of water tank. An experiment of the vertical square Plate electrode about laying depth in the center of the surface of the water has already done with the practical models that have different forms of electrodes.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.17 no.4
• /
• pp.341-346
• /
• 2005

The simplification of solar thermal systems reduces the possibility of operating trouble and lowers the cost of the initial investment and maintenance. This also leads to increased competitiveness in the energy market. We proposed a spiral-jacketed storage tank that functions both as a heat exchanger and expansion tank, which removes the secondary piping and markedly simplifies the entire system. The new storage tank was designed and manufactured to maintain the same performance as the conventional system and the exiting system was remodelled by adopting the newly proposed storage tank. This experiment was conducted under real conditions over a period of several months. The retrofitted system with the spiral-jacketed storage tank showed good performance that is on a similar level as the previous system having a typical storage tank and heat exchanger.

• Korean Journal of Soil Science and Fertilizer
• /
• v.39 no.3
• /
• pp.136-143
• /
• 2006

The study was carried out to evaluate odor emission during storage time and quality of liquid slurry fertilizer along with three storage container types installed at farmer's fields in Cheorwon. Liquid slurry manure stored in the liquid-circulated or the air-injected tank was very homogeneous in concentration of nutritional elements because of well mixing operation, while nutritional concentration of the manure stored in the non-treated tank was significantly different from top to bottom in the tank, which may bring about partially irregular growth of plant after its application. The potential capacity of offensive odor emitted from liquid slurry manure stored in the liquid-circulated or the air-injected tank was much lower than that emitted from manure stored in the non-treated tank. Low potential capacity may less emit offensive odor after application of piggery liquid slurry on the field. The efficiency in oder to reduce odor emission from liquid manure was slightly higher in the liquid-circulated tank than the air-injected tank

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.22 no.4
• /
• pp.56-60
• /
• 1986

The purpose of this study is to find the light intensity which induced maximum gathering rate and to observe the variation of the gathering rate both in daytime and at night by using rock trout, He.'~agrammos otakii (Jordan et starks). An experimental tank (360L x SOW x 55H cm) was set up in a dark room. An illumination system was attached to the end of one side of the tank to control horizontal light intensity. Six artificial light sources were prepared by combination of two light bulbs (5 W, 150 W) and seven filters. During the experiment water depth was maintained 50 em level in the tank. The tank was marked into six longitudinal sections each being 60 em long to observe the distribution of fish. The fish were acclimatized in dark condition for 50 minutes prior to the main experiment. Upon turning on the light, the number of fish in each section was counted 40 times every 30 seconds. and the gathering rate was obtained from the average number of fish in each section. The light intensity inducing maximum gathering rate was O. 7 lux (0. 5~1. 1 lux) in the daytime and 5. 2/ux (3.2-7.7 lux) at night. The variation of the gathering rate of fish in illumination time was sma II and showed the decreasing trend.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.44 no.2
• /
• pp.148-156
• /
• 2008

In this study it will be discussed how to solve the problem of discomfort from rolling motion on the fishing boats. Most discomfort is caused by the short cycle of rolling due to the light weight of the boats. The light weight is due to the FRP material which dries a boat. A way to improve the feeling of boarding by using fish hold was researched. The experiment was done on experimental fishing boat made by FRP in Jeju. An existing fish hold was designed and manufactured through the rolling test and that was used for a marine experiment. The rolling condition of the U-tank boat ideally designed was compared to that of an existing fishing boat using the same conditions. The experiments were carried out two times on the stop engine in the outward Sehwa fishing port, which the experimental data had analysed for effects of rolling reduction to compare the U - tank with the of exiting fish hold. The results were confirmed that the U-boat tank in the roll period and GoM were more safe than the existing fish hold and the average amplitude and significant of rolling angles were decreased relatively.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.17 no.4
• /
• pp.456-465
• /
• 1988

The performance of the cold latent heat storage is investigated by experiment and by a simplified analytic approach. The heat storage tank has eight horizontal circular tubes and one path of refrigerant evaporating tube. The phase change material in the heat storage tank is water which is frozen by evaporating refrigerant of refrigeration system and melts by the warm air in the heat storage tank. In the experiment, the performance has been studied by the various conditions including the initial water temperature on solidification and flow rate and temperature of air. The rate of recovered heat has been simulated by a simplified model and the results shows a good agreement. In solidification process, initial water temperature causes time delay corresponding to the sensible heat and it is found that the shape of evaporator is important. In melting process, the recovered heat rate from the heat storage tank is proportional to $Re^{0.8}(T_{bi}-T_f)$ of air where $T_{bi}$ and $T_f$ indicate temperatures of inlet air and phase change, respectively. And the deminishing rate of the recovered heat is higher for the higher heat rate.

• Journal of the Korean Solar Energy Society
• /
• v.22 no.2
• /
• pp.11-17
• /
• 2002

This paper is concerned with the development of a new method for making, separating ice and storage floated ice by installing an evaporation plate at under-water within a storage tank. In a conventional harvest-type ice storage system, a tank saves ice by separating an ice from an installed evaporation plate, which is located above an ice storage tank as an ice storage system. Developed new harvest-type method shows good heat transfer efficiency than a convectional method. It is because the evaporation panel is directly contacted with water in a storage tank. Also, at a conventional system a circulating pump, a circulating water distributor and a piping are installed, however these components are not necessary in a new method. In this study ice storage systems are experimentally investigated to study the charge and discharge of thermal energy. The results show the applicable possibility and performance enhancement of a new type.