• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.1
• /
• pp.75-84
• /
• 2000

Performance and flow characteristics of a small forward swept propeller fan for home refrigerators are studied experimentally. An unusual discontinuity is observed in the performance curve of the fan. Mean flow fields measured with as-hole Pitot probe reveal that the flow is axial at the high flow rate and radial at the low flow rate. The flow structure changes abruptly across the discontinuity. Unsteady flow measurements with a set of hot-wire probes indicate that near the discontinuity a single-cell stall rotates at 40% speed of the fan speed, while away from the discontinuity the flow shows periodic variation corresponding to the blade passage frequency. Phase-lock averaged flow fields measured with a triple-sensor hot-wire probe show that there appears radially inward flow over the pressure side of the blade and the outward passage flow over the tip.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.12 no.5
• /
• pp.110-120
• /
• 2009

The hipped roof on the research building, which was constructed 51.9m above sea level on a hillock by Korea National University of Education in June 1999, is composed of four inclined planes which are 12m in breadth, 8m in length and have a 30 degree gradient. For the roof vegetation, the yellow earth collected from around the building was laid on top. It was designed to supply the soil on the slope with water for a considerable period by making rainfall pool at the edges. In order to prevent the soil on the slope from being swept away, 31 sorts of grass seeds were imported from Germany and sown in the soil. At the present day, 10 years after the seeds began to sprout and inhabit the settled slope, 30 individual plant species were identified in the period between April 2008 and March 2009. Out of 31 species were seeded on the slanted, soiled roof, only 8 were still alive. It was confirmed that the Artemisia Princeps var, Chrysantheum, Prunella Vulgaris and Lespedeza Cuneata have been the major species inhabiting the east, west, south and north inclined planes respectively. The Phragmites Communis was inhabiting the edge of the roof where the water supply was adequate, while the Dianthus Barbatus was primarily inhabiting the south-east side of the roof. As a whole, 26 identifiable plants and 4 unidentified plants were observed on the inclined planes of the hipped roof. In consideration of the plant distribution on the slope, it was confirmed that the selection of seeds may have had an effect on the slope vegetation. As for the yellow earth laid on the roof, it was discovered that about 2~3cm thickness around the ridge was swept away, but the rest of the slope was in relatively good condition. Accordingly, it has been proven that vegetations can be applied to hipped roofs by using ordinary plants without any special structural measures.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.3
• /
• pp.338-348
• /
• 2004

The present study is conducted to investigate the effect of rib arrangements on an impingement/effusion cooling system with initial crossflow. To simulate the impingement/effusion cooling system, two perforated plates are placed in parallel and staggered arrangements with a gap distance of 2 times of tile hole diameter. Initial crossflow passes between the injection and effusion plates, and the square ribs (3mm) are installed on the effusion plate. Both the injection and effusion hole diameters are 10mmand Reynolds number based on the hole diameter and hole-to-hole pitch are fixed to 10,000 and 6 times of the hole diameter, respectively. To investigate the effects of rib arrangements, various rib arrangements, such as 90$^{\circ}$transverse and 45$^{\circ}$angled rib arrangements, are used. Also, the effects of flow rate ratio of crossflow to impinging jets are investigated. With the initial crossflow, locally low transfer regions are formed because the wall jets are swept away, and level of heat transfer rate get decreased with increasing flow rate of crossflow. When the ribs are installed on the effusion plate, the local distributions of heat/mass transfer coefficients around the effusion holes are changed. The local heat/mass transfer around the stagnation regions and the effusion holes are affected by the rib positions, angle of attack and rib spacing. For low blowing ratio, the ribs have adverse effects on heat/mass transfer, but for higher blowing ratios, higher and more uniform heat transfer coefficient distributions are obtained than the case without ribs because the ribs prevent the wall jets from being swept away by the crossflow and increase local turbulence of the flow near the surface. Average heat transfer coefficients with rib turbulators are approximately 10% higher than that without ribs, and the higher values are obtained with small pitch of ribs. However, the attack angle of the rib has little influence on the average heat/mass transfer.

• Journal of Welding and Joining
• /
• v.19 no.3
• /
• pp.267-273
• /
• 2001

In this study, welding phenomena involved in formation of penetrators during high frequency electric resistance welding were investigated. High speed cinematography of the process revealer that a molten bridge between neighboring skelp edges forms at apex point and travels along narrow gap toward to welding point at a speed ranging from 100 to 400 m/min. The bridge while moving along the narrow gap swept away oxide containing molten metal from the gap, providing oxide-free surface for a forge-welding at upsetting stand frequency of the budge formation, travel distance and speed of the bridge were affected by the heat input rate into strip. The travel distance and its standard deviation were found to have a strong relationship with the weld defect density. Based on the observation, a new mechanism of the penetrator formation during HF ERW process is proposed.

• Proceedings of the KSR Conference
• /
• 2002.10a
• /
• pp.587-595
• /
• 2002

Geotextile containers for restoration of slopes form the interface between the containers during the restored to lost slopes, and therefore the relation displacements are developed including the sliding on the surface. Since, the shear strength on these interfaces is less than that of fill material in the container, the characteristics of shear strength on the interface governs the behavior of the restoration slopes. In general, a lot of natural properties of geotexiles is required to evaluate the safty of the geotextiles, Among the properties, the shear characteristics between geotextiles and soil is a important variable to assess the safety. From the results of full scale direct shear test, the residual shear strength is recommanded to use for design factors since a large deformation possibly occures on the geotextile containers.

• Journal of Wetlands Research
• /
• v.20 no.1
• /
• pp.35-42
• /
• 2018

This study presents the flow response and habitat region of the aquatic plants in the urban streams. Phragmites japonica, Phragmites communis, Miscanthus sacchariflorus, Persicaria blumei and Persicaria thunbergii were selected as for typical plants. Flow response and habitat region were determined by flow velocity/depth and vegetation growth. Stages for flow response of the aquatic plants were classified into stable, recovered, damaged and swept away. Criteria between the recovered and damaged stage was determined by the bending angle of $30{\sim}50^{\circ}$. Capability against flow was high in the order of Phragmites japonica, Phragmites communis, Miscanthus sacchariflorus, Persicaria blumei and Persicaria thunbergi. Phragmites japonica and Phragmites communis were capable of coping with flow depth 0.9 m, flow velocity 1.5 m/s and with flow depth 1.0 m, flow velocity 0.9 m/s, respectively. Miscanthus sacchariflorus was capable within the region of flow depth 1.0 m and flow velocity 0.6 m/s. Persicaria blumei and Persicaria thunbergii were less capable than the other aquatic plants and were vulnerable exceeding the water depth of 1.0 m. Habitat regions by the flow response of each plants were suggested.

• Korean Journal of Child Studies
• /
• v.32 no.3
• /
• pp.185-202
• /
• 2011

The purpose of this study was to understand the archetypical symbols present when conducting sandplay therapy with water from a hermeneutic point of view. The research participants were 6 children aged 8~9 who experienced problems in parent-children relationships. The result were as follows : The nature of archetypical symbols of present when working with water can be structured along two themes, vertical movements and horizontal movements. In vertical movements with three sub-themes, the meaning of 'to put in and boil out' is interpreted as 'mother's feeding baby', the meaning of 'to sink and bring out of water' is interpreted as 'resource acquisition', 'to swamp and float on the water' represents 'death and rebirth'. In horizontal movements consisted of two sub- themes, the meaning of 'to be swept away' is interpreted as 'initiation and conversion', the meaning of 'to wave and fix' is interpreted as 'to overcome the difficulties and create stability'.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.9 no.6
• /
• pp.38-51
• /
• 2006

This study was carried out to improve rehabilitation effect by hydro-seeding methods on denuded slopes. Lespedeza cyrtobotrya, Indigofera pseudotinctoria, Arudinella hirta, Poa pratensis, and Lolium perenne were used in this study. The results of the germination and growth characteristics by seed coating, slope control and soil mulching treatments are summarized here. Seed coating of those plants had an effect on germination ratio, germination force, $LD_{50}$, and seedling growth of stem, leaf and root. The seed coating effect was highest for I. pseudotinctoria while the seedling growth was best for L. cyrtobotrya. Vermiculite+Talcum was the best coating material for germination and seedling growth of the plants. As the slopes were steeper, germination ratio was lower and seedling growth of stem and root decreased. Lots of seeds and soils were swept away when the slope was steep. Soil mulching was effective for germination, seedling growth of stem and root, and soil stabilization. It was more effective when the slope was steeper. Coir net was the most effective soil mulching material n this study.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2005.11a
• /
• pp.220-221
• /
• 2005

Sub-bottom profiler(SBP) has been used extensively for the mapping of basement in the foundation design of offshore structure, for pre- and post-dredging operations within harbors and channels, for selection of pipeline routes, sitting of drilling platforms, and in the exploration for an aggregates such as sands and gravels. During the construction of Siwha embankment for irrigation water and the expansion of arable land, the breaking of an embankment unfortunately occurred so that a lot of riprap was swept away and widely dispersed by the tide and strong current. The feasibility study for the construction of the tidal-powered electric plant in Siwha embankment was performed quite recently. Therefore we made use of SBP survey to investigate the distribution of the lost riprap. We could successfully map out the distribution of the lost riprap from the reflection amplitude characteristics of the sediments in SBP data set. We demonstrated the variation of reflection amplitude versus the sediments with and/or without riprap by means of the numerical modeling of acoustic wave equation using finite difference method. Also we examined an amplitude anomaly of the ripraped area through the physical modeling using ultrasonic.

• Fire Science and Engineering
• /
• v.16 no.4
• /
• pp.28-32
• /
• 2002

The performance based design in fire detection system, the effect of high airflow and dilution of smoke produced in any fire situation serve to increase the response time of point-type smoke detectors. This study investigated the smoke density of ceiling, under the air stream and in normal status when fire type is smoldering fires. The result of study, smoke generated in the fire was swept away from nearby spot type smoke detector which failed to actuate because dispersed in diluted form around the room. The concept of performance based design in fire detection system of protected area influenced by high airflow provided the need of active fire detection system such as air sampling smoke detection system.