• Journal of the Korean Ceramic Society
• /
• v.30 no.1
• /
• pp.7-16
• /
• 1993

Effect of sulfate on the reactionof C3S formation in presence of clinker melt and its appearance in clinker were investigated, using (NH4)2SO4 and CaSO4 as sulfate sources. When (NH4)2SO4 and CaSO4 were added, both showed the similar results, 1.0wt% of sulfate could promoted the reaction of C3S formation, however for its content of more than 2.0wt%, the formation of C3S was prevented. Residual limit of sulfate to C3S formation is about 1.4wt%. Appearances of sulfate were C4A3l and CaSO4 in interstitial phase. For the addition of (NH4)2SO4 or CaSO4 of 20wt%~4.0wt%, C3S grains showed the hypertrophic growth. We might consider that, because sulfate reduced the surface tension and viscosity of the clinker melt, C3S crystals were precipitated below 140$0^{\circ}C$, and the crystlas of C3S were coalesced and linked in the same crystallographical direction with increasing temperature becuase of their rapid growth rate.

• Journal of the Korean Ceramic Society
• /
• v.11 no.1
• /
• pp.29-35
• /
• 1974

Effect of calcium sulfate and barium sulfate on the formation of portland cement clinker was studied by means of chemical analysis. DTA and X-ray diffraction analysis. In the presence of liquid phase, effect of the additives on the formation of tricalcium silicate was examined according to the reaction, 2CaO.$SiO_3$＋CaO$\longrightarrow$3CaO.$SiO_3$, which is the principal reaction in portland cement clinkerization, and optimum conditions in firing clinker concerning amount of additive, firing time and temperature were determined, and its kinetics was referred to. The experimental results are summerized as follow: (1) Appropriate burning temperature range of cement clinker is more limited as the content of calcium sulfate in clinker is increased. Amount of calcium sulfate, firing time and temperature in proper condition of clinkerization is related to each others. Being added suitable quantity of calcium sulfate, firing temperature of clinker can be lowered about $100^{\circ}C$. (2) When 3-5 mole% of calcium sulfate is added, firing time of 15-30 minutes at about $1380^{\circ}C$ is reasonable, and if the content is over7 mole %, firing for 1 hr. or more at $1350^{\circ}C$ is anticipated to be optimum condition. (3) In the reaction of tricalcium silicate formation, the role of barium sulfate as a mineralizer is similar to that of calcium sulfate, but the optimum firing temperature of cement clinker containing barium sulfate tends to be 20-$30^{\circ}C$ higher than that of clinker containing calcium sulfate. (4) When barium sulfate is used as mineralizer, 2-3 mole % of it to tricalcium silicate is recommended and if it is added more than this amount, free CaO is increased rapidly in clinker and alite formation is inhibited.

• Journal of Periodontal and Implant Science
• /
• v.29 no.1
• /
• pp.153-171
• /
• 1999

The purpose of this study was to evaluate the effect of modified calcium sulfate paste on periodontal regeneration. l-wall intrabony defect(mesio-distal width: 4mm, depth: 4mm) was surgically created on the distal side of P2 and mesial side of p4 in four dogs. The control group(GFS) was treated with conventional flap operation alone, and the experimental group(CS) was treated with conventional flap operation with modified calcium sulfate paste application. Both control and experimental groups were sacrificed after 8weeks of healing period, The results of histological and histometric observations were as follows. 1. The length of the junctional epithelium was 0.41${\pm}$0.01mm in the control groups, 0.47${\pm}$0.01mm in the experimental group. 2. The connective tissue attachment was 0.28${\pm}$0.02mm(6.15${\pm}$0.28%) in the control group, 0.18${\pm}$0.01mm(3.41${\pm}$0.14%) in the experimental group. The control group showed more connective tissue attachment. 3. The new cementum formation was 3.80${\pm}$0.06mm(84.80${\pm}$0.33%) in the control group, 4.49${\pm}$0.06mm(87.57${\pm}$0.15%) in the experimental group. Both groups showed a lot of new cementum formation. 4. The new bone formation was 1.43${\pm}$0.03mm(32.37%) in the control group, 2.04${\pm}$O.09mm(40.94%) in the experimental group. 5. The inflamatory cells were observed partially around resorbed calcium sulfate in the connective tissue of the experimental group. 6. Partially resorbed calcium sulfate were found within the connective tissue, around alveolar bone, and in the newly formed alveolar bone, On the basis of these results, newly formed calcium sulfate paste enhanced new bone formation and new cementum formation. The resorption rate of calcium sulfate seems to be controlled by the add-in compounds. Thus research about biocompatibility and adequate resorptionrate is required to develop a improved material.

• Journal of the Korean Ceramic Society
• /
• v.24 no.4
• /
• pp.343-348
• /
• 1987

The effects of salts such as aluminum sulfate as inorganic salt(2-4%), and sodium salts of citrate, tartrate, succinate, potassium tartrate and gelatin as organic salts(0.1%) on the formation of ${\alpha}$-calcium sulfate hemihydrate from by-product gypsum of phosphoric acid process under hydrothermal condition at 123$^{\circ}C$ and 133$^{\circ}C$ were investigated. Aluminum sulfate solution exhibited the catalystic effected on the crystallization of ${\alpha}$-calcium sulfate hemihydrate of which was assumed in the prismatic form, and organic salts solution exhibited little effect on the catalystic action to the crystallization, than inorganic salts. In the acidic solution with sulfuric acid(pH=2), needle like crystal of calcium sulfate hemihydrate was obtained. Hydrothermal process with aluminum sulfate solution also showed certain amounts of impurity removal such as phosphorus penataoxide from calcium sulfate hemihydrate.

• Journal of the Korean Ceramic Society
• /
• v.25 no.3
• /
• pp.300-306
• /
• 1988

The catalytic effect of salts on formation of ${\alpha}$-calcium sulfate hemihydrate under water vapor at atmospheric pressure was studied and the formation of q-calcium sulfate hemilydrate from by-product gypsum of phosphoric acid process was investigated. The order of catalytic effect of salts are as follow: Ammonium chloride>Sodium succinate>Calcium chloride>Sodium tartrate>Magnesium chloride The prismatic crystals was formed when ammonium chloride, calcium chloride and magnesium chloride was added, whereas the needle crystals was formed when sodium tartrate was added. Ammonium chlorideis most successful in catalytic effects in formation of ${\alpha}$-calcium sulfate hermihydrate for the by-product gypsum of phosphoric acid process.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.20 no.3
• /
• pp.217-227
• /
• 1998

Calcium sulfate(plaster of Paris) has been used in dental and orthopedic surgery for about 100 years. It is well known that the plaster is bioresorbable, biocompatible, defect conformable and moldable. The purpose of this study is to evaluate two effects of calcium sulfate on bone regeneration, that is, the effects of graft materials and barrier for bone regeneration. Cortical bone defects were formed for recipient site on the femurs of 19 Sprague-Dawley rats. The autogenous particulated bone and calcium sulfate were grafted to the defects. Calcium sulfate paste, $Gore-Tex^R$ membrane(W.L. GORE & ASSOCIATES LTD., U.S.A.) and rubber sheet were used for the shielding materials. The results were as follows : 1. Calcium sulfate that had been grafted in the cortical bone defect was almost resorbed before bone remodeling, resultantly had little effect on bone regeneration. 2. Resoption process of calcium sulfate grafted on the bone grafting area tends to be accelerated, as being divided into numerous small particles progressively. Under the situation where the calcium sulfate was protected, with the coverage of fascia, $Gore-Tex^R$ membrane or rubber sheet, new bone formation was confirmed with presence of calcium sulfate particles over 6 weeks after grafting. 3. In the case of calcium sulfate covered with membrane, distinct bone formation was observed on the marrow space of femur adjacent to the plaster mass. 4. Rubber shielded plaster group revealed new bone trabeculae under the rubber sheet, but it showed ischemic degeneration of superficial cortical bone.

• The Journal of the Korean bone and joint tumor society
• /
• v.9 no.1
• /
• pp.31-37
• /
• 2003

Introduction: The purpose of this study is to assess the efficacy of calcium sulfate as a bone graft substitute in the treatment of benign bone tumor. Materials and Method: Between December 2000 and November 2001, 18 patients with a benign bone tumor were treated with crettage and the defects were filled with calcium sulfate (Osteoset$^{(R)}$:Wright Medical Co. USA) as a bone graft substitute. Average age was 28.4 years and mean follow up period was 12.3 months. Calcium sulfate mixed with autograft was used in 6 cases, calcium sulfate with allograft in 2 cases, and calcium sulfate alone was used in 10 cases. The degree of absorption of calcium sulfate and new bone formation at plain radiograph was analyzed at immediate postoperative and postoperative 3 months and 6 months follow up. Results: At 3 months postoperatively, 92% of calcium sulfate was absorbed, and at 6 months postoperatively, 89% of new bone formation was observed. There was no difference in the resorption and new bone formation between the group using bone graft and the group osteoset$^{(R)}$ alone, different preoperative diagnosis and even different locations. There was no complication. Conclusion: Calcium sulfate(Osteoset$^{(R)}$) is a safe and effective bone graft substitute in the treatment of benign bone tumors, especially for the children in whom autograft is not recommandable.

• Journal of Veterinary Clinics
• /
• v.20 no.3
• /
• pp.351-356
• /
• 2003

The aim of this experiment was to study the calcium sulfate on early bone consolidation in distraction osteogenesis in the canine mandible. Twelve dogs were used and divided into control group (group A, 4 heads), sodium hyaluronate injection group (group B, 4 heads), mixture of calcium sulfate and sodium hyaluronate injection group (group C, 4 heads). Each group were subdivided into 3 weeks testing group (totally 6 heads) and 5 weeks testing group (totally 6 heads). Mandibular distraction was started at the 5th day after the mandibular osteotomy and continued for 10 days by 1 mm a day. After the distraction on the 10th day of mandibular distraction, 0.5 m1 saline in group A, 0.5 m1 sodium hyaluronate in group B, and 0.5 ml mixture of calcium sulfate and sodium hyaluronate in group C were each injected in mandibular distraction lesion. And X-ray examination, bone mineral density, and histopathological findings were examined. The radiological findings were the most radiopaque in group C, and the most radiolucent in group A in both 3 and 5 week testing group. The level of bone mineral density was also the highest in group C, and the lowest in group C in both 3 and 5 week testing group. The histopathological findings of new bone formation were the most remarkable in group C in both 3 and 5 week testing group. New bone formation of group A was not present in both 3 and 5 week testing group. In conclusion, calcium sulfate is a kind of material that can stimulate early bone formation and can shorten the duration of bone consolidation. And it can be effective in clinical usage.

• Journal of Periodontal and Implant Science
• /
• v.28 no.2
• /
• pp.219-237
• /
• 1998

Numerous bone graft materials have been used in Periodontics, in an attempt to reach the main goal of periodontal therapy, i.e. the regeneration of periodontal tissue lost due to destructive periodontal diseases. The present study investigates the effect of composite graft of DFDB and Calcium sulfate with and without Calcium sulfate barrier in Periodontal 1-wall intrabony defects in dogs. Following the initiation of general anesthesia by I.V. administration of 40mg/Kg of Pentobabital, second premolar was extracted and full thickness flap elevated. The crown portion of premolars was removed. Exposed root canals were sealed with Caviton and covered completely with flap. After the healing period of 8 weeks, the surgical sites were re-opened and 1-wall intrabony defects were created, and treated with flap operation alone(control group), with composit graft of 80% DFDB and 20% Calcium sulfate(Experimental group 1), with composite graft of DFDB and calcium sulfate with calcium sulfate membrane( Experimental group 2). Healing response was histologically observed after 8 weeks and the results were as follows : 1. New bone formation was 70 % in the control group, 93 % in the Experimental group I, 89 % in the Experimental group II. There was a no differences between Experimental groups. 2. New cementum formation was not significantly different between control and two Experimental groups. 3. The length of connective tissue adhesion was 30 % in the control, 7% in the Experimental group I and 11 % in the Experimental group II. 4. After 8weeks, calcium sulfate was completely resorbed, while DFDB particle remained. These results suggest that the use of composite graft of allogenic DFDB and Calcium sulfate with and without Calcium sulfate barrier in periodontal 1 wall intrabony defects have little effect on connective tissue adhesion, but has beneficial effect on new alveolar bone and new cementum formation, and prevent downgrowth of epithelium and connective tissue effectively.

• Applied Biological Chemistry
• /
• v.2
• /
• pp.9-14
• /
• 1961

The formation of sulfide from sulfate has been discussed from the thermodynamic principles. No mechanism of the reaction has been presented. From the stoichiometric and Nernst equations for the conversion of sulfate into sulfide, it was concluded that the formation of sulfide from sulfate can take place more readily if pH of a medium is low. The difficulty of this conversion increases with increasing pH. As pH of a medium increases, the degree of dissociation of H₂S into S= increases and this, in turn, renders the chance of precipitation of sulfide as FeS easier. Higher the pH of a soil or medium, greater is the S= concentration. The concentration of ferrous ion required to remove dissolved sulfide in a medium by forming insoluble FeS decreases with increasing pH. From the theory it was pointed out that an application of lime and iron rich foreign substances to a soil may be effective in causing the removal of dissolved sulfide from solution.